Diffractive optical elements such as periodic gratings are fundamental devices in X-ray imaging - a technique that medical, material science and security scans rely upon. Fabrication of such structures with high aspect ratios at the nanoscale creates opportunities to further advance such applications, especially in terms of relaxing X-ray source coherence requirements. This is because typical grating-based X-ray phase imaging techniques (e.g., Talbot self-imaging) require a coherence length of at least one grating period and ideally longer. In this paper, the fabrication challenges in achieving high aspect-ratio nanogratings filled with gold are addressed by a combination of laser interference and nanoimprint lithography, physical vapor deposition, metal assisted chemical etching (MACE), and electroplating. This relatively simple and cost-efficient approach is unlocked by an innovative post-MACE drying step with hexamethyldisilazane, which effectively minimizes the stiction of the nanostructures. The theoretical limits of the approach are discussed and, experimentally, X-ray nanogratings with aspect ratios >40 demonstrated. Finally, their excellent diffractive abilities are shown when exposed to a hard (12.2 keV) monochromatic x-ray beam at a synchrotron facility, and thus potential applicability in phase-based X-ray imaging.
All-dry processing of 3C-SiC nanomechanical string resonators for extreme aspect ratios and high intrinsic quality factor
Technical University of Munich(慕尼黑工业大学);Munich Center for Quantum Science and Technology (MCQST)(慕尼黑量子科学与技术中心);TUM Center for Quantum Engineering (ZQE)(慕尼黑工业大学量子工程中心)
Hot embossing of Au- and Pb- based alloys for X ray grating fabrication
基于光栅的X射线相衬干涉测量在材料科学和医学中具有很高的应用影响,用于弱吸收(低Z)材料和软组织的成像。对于吸收光栅,铸造高X射线吸收金属,如金和铅合金,已被证明是一种可行的方式来产生大面积周期性高纵横比的微结构。在本文中,我们回顾了光栅的制作策略,特别关注的是一种新的方法,铸造低温熔融合金(金锡和铅基合金)到硅光栅模板使用热压。类似于纳米压印光刻,该工艺需要根据金属合金和光栅特征尺寸对工艺参数进行特别的调整。固态和液态之间的转变取决于合金相图,施加的压力会破坏高纵横比的Si片层,固态金属的微观结构会影响光栅结构。我们证明,通过热压印的金属铸造可以用于制作大面积(高达70 x70 mm 2)的光栅,其纵横比高达50:1,间距在1-20 μm范围内。
Large-area implementation and critical evaluation of the material and fabrication aspects of a thin-film thermoelectric generator based on aluminum-doped zinc oxide
Plasmonic Particle Integration into Near-Infrared Photodetectors and Photoactivated Gas Sensors: Towards Sustainable Next-Generation Ubiquitous Sensing