arXivDaily arXiv每日学术速递 周一至周五更新
arXiv周末暂无论文更新,休息一下吧,周末愉快~~
arXiv 1104.4444cond-mat.softcond-mat.mtrl-sci
收藏

简单屈服应力流体中的应力超调:结合流变学和速度测量的广泛研究

Stress overshoot in a simple yield stress fluid: an extensive study combining rheology and velocimetry

Thibaut Divoux, Catherine Barentin, Sebastien Manneville

摘要:

我们报告了大量的实验数据上的应力超调现象发生在启动剪切流在一个简单的屈服应力流体,即卡波姆微凝胶。经典的流变测量和超声波测速相结合,使人们有可能得到的瞬态动力学的应力$σ(t)$和速度场的粗糙的圆柱形Couette细胞的间隙在剪切启动过程中施加的剪切速率下$\dotγ$的物理见解。(i)在小应变($γ<1$)下,$σ(t)$线性增加并且微凝胶经历均匀变形。(ii)在时间$t_m$,应力达到最大值$σ_m$,其对应于微凝胶的失效和在移动壁处薄润滑层的成核。(iii)微凝胶然后经历一个强大的弹性反冲,并进入一个政权的总壁滑移,而应力缓慢下降。(iv)总壁滑移让位于瞬态剪切带现象,其发生的时间尺度比应力超调长得多,并已在其他地方进行了描述[Divoux \textit{et al., Phys. Rev. Lett.},2010,\textbf{104},208301]。整个序列对探索范围($0.5 \le C \le 3%$ w/w)内的浓度变化非常稳健。我们进一步证明,最大应力$σ_m$和相应的应变$γ_m=\dotγt_m$都取决于所施加的剪切速率$\dot γ$和预剪切和剪切启动之间的等待时间$t_w$:只要$\dotγ$小于某个临界剪切速率$\dotγ_w\sim 1/t_w$,它们就保持大致恒定,并且它们随着$\dotγ> \dotγ_w$的$\dot γ$的弱幂律而增加[.]。

英文摘要:

We report a large amount of experimental data on the stress overshoot phenomenon which takes place during start-up shear flows in a simple yield stress fluid, namely a carbopol microgel. A combination of classical rheological measurements and ultrasonic velocimetry makes it possible to get physical insights on the transient dynamics of both the stress $σ(t)$ and the velocity field across the gap of a rough cylindrical Couette cell during the start-up of shear under an applied shear rate $\dotγ$. (i) At small strains ($γ<1$), $σ(t)$ increases linearly and the microgel undergoes homogeneous deformation. (ii) At a time $t_m$, the stress reaches a maximum value $σ_m$ which corresponds to the failure of the microgel and to the nucleation of a thin lubrication layer at the moving wall. (iii) The microgel then experiences a strong elastic recoil and enters a regime of total wall slip while the stress slowly decreases. (iv) Total wall slip gives way to a transient shear-banding phenomenon, which occurs on timescales much longer than that of the stress overshoot and has been described elsewhere [Divoux \textit{et al., Phys. Rev. Lett.}, 2010, \textbf{104}, 208301]. This whole sequence is very robust to concentration changes in the explored range ($0.5 \le C \le 3%$ w/w). We further demonstrate that the maximum stress $σ_m$ and the corresponding strain $γ_m=\dotγt_m$ both depend on the applied shear rate $\dot γ$ and on the waiting time $t_w$ between preshear and shear start-up: they remain roughly constant as long as $\dotγ$ is smaller than some critical shear rate $\dotγ_w\sim 1/t_w$ and they increase as weak power laws of $\dot γ$ for $\dotγ> \dotγ_w$ [...].

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑