We demonstrate high yield fabrication of field effect transistors (FET) using chemically reduced graphene oxide (RGO) sheets suspended in water assembled via dielectrophoresis. The two terminal resistances of the devices were improved by an order of magnitude upon mild annealing at 200 0C in Ar/H2 environment for 1 hour. With the application of a backgate voltage, all of the devices showed FET behavior with maximum hole and electron mobilities of 4.0 and 1.5 cm2/Vs respectively. This study shows promise for scaled up fabrication of graphene based nanoelectronic devices.
We demonstrate top-gated field effect transistor made of reduced graphene oxide (RGO) monolayer (graphene) by dielectrophoresis. Raman spectrum of RGO flakes of typical size of 5μm x 5μm show a single 2D band at 2687 cm-1, characteristic of a single layer graphene. The two probe current - voltage measurements of RGO flakes, deposited in between the patterned electrodes with a gap of 2.5 μm using a.c. dielectrophoresis show ohmic behavior with a resistance of ~ 37kΩ. The temperature dependence of the resistance (R) of RGO measured between temperatures 305 K to 393 K yields temperature coefficie…
We present a simple and scalable technique for the fabrication of solution processed & local gated carbon nanotube field effect transistors (CNT-FETs). The approach is based on directed assembly of individual single wall carbon nanotube from dichloroethane via AC dielectrophoresis (DEP) onto pre-patterned source and drain electrodes with a local aluminum gate in the middle. Local-gated CNT-FET devices display superior performance compared to global back gate with on-off ratios 10^4 and maximum subthreshold swings of 170 mV/dec. The local bottom-gated DEP assembled CNT-FETs will facilitate larg…
We report ultra-high density assembly of aligned single walled carbon nanotubes (SWNTs) two dimensional arrays via ac dielectrophoresis using high quality surfactant free and stable SWNT solutions. After optimization of frequency and trapping time, we can reproducibly control the linear density of the SWNT between prefabricated electrodes from 0.5 SWNT/\mum to more than 30 SWNT /\mum by tuning the concentration of the nanotubes in the solution. Our maximum density of 30 SWNT/\mum is the highest for aligned arrays via any solution processing technique reported so far. Further increase of SWNT c…
We report on the experimental demonstration and electrical characterization of N = 7 armchair graphene nanoribbon (7-AGNR) field effect transistors. The back-gated transistors are fabricated from atomically precise and highly aligned 7-AGNRs, synthesized with a bottom-up approach. The large area transfer process holds the promise of scalable device fabrication with atomically precise nanoribbons. The channels of the FETs are approximately 30 times longer than the average nanoribbon length of 30 nm to 40 nm. The density of the GNRs is high, so that transport can be assumed well-above the percol…
We report high performance p-type field-effect transistors based on single layered (thickness, ~0.7 nm) WSe2 as the active channel with chemically doped source/drain contacts and high-κ gate dielectrics. The top-gated monolayer transistors exhibit a high effective hole mobility of ~250 cm2/Vs, perfect subthreshold swing of ~60 mV/dec, and ION/IOFF of >10^6 at room temperature. Special attention is given to lowering the contact resistance for hole injection by using high work function Pd contacts along with degenerate surface doping of the contacts by patterned NO2 chemisorption on WSe2. The re…
We report the realization of field-effect transistors (FETs) made with chemically synthesized multilayer 2D crystal semiconductor MoS2. Electrical properties such as the FET mobility, subthreshold swing, on/off ratio, and contact resistance of chemically synthesized (s-) MoS2 are indistinguishable from that of mechanically exfoliated (x-) MoS2, however flat-band voltages are different, possibly due to polar chemical residues originating in the transfer process. Electron diffraction studies and Raman spectroscopy show the structural similarity of s-MoS2 to x-MoS2. This initial report on the beh…
We report the realization of field-effect transistors (FETs) made with chemically- synthesized layered two dimensional (2D) crystal semiconductor WS2. The 2D Schottky-barrier FETs demonstrate ambipolar behavior and a high (~105x) on/off current ratio at room temperature with current saturation. The behavior is attributed to the presence of an energy bandgap in the 2D crystal material. The FETs show clear photo response to visible light. The promising electronic and optical characteristics of the devices combined with the layered 2D crystal flexibility make WS2 attractive for future electronic …
Surface characterizations of an organophosphorus (OP) gas detector based on chemically functionalized silicon nanoribbon field-effect transistor (SiNR-FET) were performed by Kelvin Probe Force Microscopy (KPFM) and ToF-SIMS, and correlated with changes in the current-voltage characteristics of the devices. KPFM measurements on FETs allow (i) to investigate the contact potential difference (CPD) distribution of the polarized device as function of the gate voltage and the exposure to OP traces and, (ii) to analyze the CPD hysteresis associated to the presence of mobile ions on the surface. The C…
We report strategies of achieving both high assembly yield of carbon nanotubes at selected position of the circuit via dielectrophoresis (DEP) and field effect transistor (FET) yield using semiconducting enriched single walled carbon nanotube (s-SWNT) aqueous solution. When the DEP parameters were optimized for the assembly of individual s-SWNT, 97% of the devices show FET behavior with a maximum mobility of 210 cm2/Vs, on-off current ratio ~ 106 and on conductance up to 3 μS, however with an assembly yield of only 33%. As the DEP parameters were optimized so that 1-5 s-SWNTs are connected per…
We elucidate on the low mobility and charge traps of the chemically reduced graphene oxide (RGO) sheets by measuring and analyzing temperature dependent current-voltage characteristics. The RGO sheets were assembled between source and drain electrodes via dielectrophoresis. At low bias voltage the conduction is Ohmic while at high bias voltage and low temperatures the conduction becomes space charge limited with an exponential distribution of traps. We estimate an average trap density of 1.75x10^16 cm^-3. Quantitative information about charge traps will help develop optimization strategies of …
We form single-electron transistors from individual chemically-synthesized gold nanoparticles, 5-15 nm in diameter, with monolayers of organic molecules serving as tunnel barriers. These devices allow us to measure the discrete electronic energy levels of individual gold nanoparticles that are, by virtue of chemical synthesis, well-defined in their composition, size and shape. We show that the nanoparticles are non-magnetic and have spectra in good accord with random-matrix-theory predictions taking into account strong spin-orbit coupling.
In this letter, it is shown that the existing scaling theories for chemically doped transistors cannot be applied to the novel class of electrically doped 2D transistors and the concept of equivalent oxide thickness (EOT) is not applicable anymore. Hence, a novel scaling theory is developed based on analytic solutions of the 2D Poisson equation. Full band atomistic quantum transport simulations verify the theory and show that the critical design parameters are the physical oxide thickness and distance between the gates. Accordingly, the most optimized electrically doped devices are those with …
The accessibility of both n-type and p-type MoS2 FET is necessary for complementary device applications involving MoS2. However, MoS2 PFET is rarely achieved due to pinning effect resulting high Rc at metal-MoS2 interface and the inherently strong n-type property of the MoS2 material. In this study, we realized a high-performance multi-layer MoS2 PFET via controllable chemical doping, which has an excellent on/off ratio of 107 and a maximum hole mobility of 72 cm2/Vs at room temperature, and these values are further exceeding to 109 and 132 cm2/Vs at 133K. In addition, we revealed that large R…
Tunneling field-effect transistors (TFETs) based on 2D materials are promising steep sub-threshold swing (SS) devices due to their tight gate control. There are two major methods to create the tunnel junction in these 2D TFETs: electrical and chemical doping. In this work, design guidelines for both electrically and chemically doped 2D TFETs are provided using full band atomistic quantum transport simulations in conjunction with analytic modeling. Moreover, several 2D TFETs' performance boosters such as strain, source doping, and equivalent oxide thickness (EOT) are studied. Later on, these pe…
High performance p- and n-type single-walled carbon nanotube (SWNT) field-effect transistors (FETs) are obtained by using high and low work function metals, Pd and Al as source/drain (S/D) electrodes respectively. Ohmic contacts made to chemically intrinsic SWNTs, with no or small Schottky barriers (SB), afford high ON-state currents up to 20 uA per tube. The lack of significant Fermi-level pinning at the nanotube-metal interfaces allows for fine-tuning of the barrier heights for p-and n-channel conductions by changing the contact metals. The air-stable p- and n-FETs thus obtained can be used …
Graphene field effect transistors commonly comprise graphene flakes lying on SiO2 surfaces. The gate-voltage dependent conductance shows hysteresis depending on the gate sweeping rate/range. It is shown here that the transistors exhibit two different kinds of hysteresis in their electrical characteristics. Charge transfer causes a positive shift in the gate voltage of the minimum conductance, while capacitive gating can cause the negative shift of conductance with respect to gate voltage. The positive hysteretic phenomena decay with an increase of the number of layers in graphene flakes. Self-…
Single walled carbon nanotubes (SWNTs) have attracted immense research interest because of their remarkable physical and electronic properties. In particular, electronic devices fabricated using individual SWNT have shown outstanding device performance surpassing those of Si. However, for the widespread application of SWNTs based electronic devices, parallel fabrication techniques along with Complementary Metal Oxide (CMOS) compatibility are required. One technique that has the potential to integrate SWNTs at the selected position of the circuit in a parallel fashion is AC dielectrophoresis (D…
Graphene, the atomically-thin honeycomb carbon lattice, is a highly conducting 2D material whose exposed electronic structure offers an ideal platform for sensing. Its biocompatible, flexible, and chemically inert nature associated to the lack of dangling bonds, offers novel perspectives for direct interfacing with bioelements. When combined with its exceptional electronic and optical properties, graphene becomes a very promising material for bioelectronics. Among the successful bio-integrations of graphene, the detection of ionic currents through artificial membrane channels and extracellular…
In this letter, a new approach to chemically dope black phosphorus (BP) is presented, which significantly enhances the device performance of BP field-effect transistors for an initial period of 18 h, before degrading to previously reported levels. By applying 2,3,5,6-tetrafluoro-7,7,8,8-tetracyanoquinodimethane (F4-TCNQ), low ON-state resistance of 3.2 ohm.mm and high field-effect mobility of 229 cm2/Vs are achieved with a record high drain current of 532 mA/mm at a moderate channel length of 1.5 μm.
The presence of finite bandgap and high mobility in semiconductor few-layer black phosphorus offers an attractive prospect for using this material in future two-dimensional electronic devices. Here we demonstrate for the first time fully encapsulated ultrathin (down to bilayer) black phosphorus field effect transistors in Van der Waals heterostructures to preclude their stability and degradation problems which have limited their potential for applications. Introducing monolayer graphene in our device architecture for one-atom-thick conformal source-drain electrodes enables a chemically inert b…
We report the fabrication of both n-type and p-type WSe2 field effect transistors with hexagonal boron nitride passivated channels and ionic-liquid (IL)-gated graphene contacts. Our transport measurements reveal intrinsic channel properties including a metal-insulator transition at a characteristic conductivity close to the quantum conductance e2/h, a high ON/OFF ratio of >107 at 170 K, and large electron and hole mobility of ~200 cm2V-1s-1 at 160 K. Decreasing the temperature to 77 K increases mobility of electrons to ~330 cm2V-1s-1 and that of holes to ~270 cm2V-1s-1. We attribute our abilit…
We report the development of nanowire field-effect transistors featuring an ultra-thin parylene film as a polymer gate insulator. The room temperature, gas-phase deposition of parylene is an attractive alternative to oxide insulators prepared at high temperatures using atomic layer deposition. We discuss our custom-built parylene deposition system, which is designed for reliable and controlled deposition of <100 nm thick parylene films on III-V nanowires standing vertically on a growth substrate or horizontally on a device substrate. The former case gives conformally-coated nanowires, which we…
Next-generation electronics calls for new materials beyond silicon for increased functionality, performance, and scaling in integrated circuits. Carbon nanotubes and semiconductor nanowires are at the forefront of these materials, but have challenges due to the complex fabrication techniques required for large-scale applications. Two-dimensional (2D) gapless graphene and semiconducting transition metal dichalcogenides (TMDCs) have emerged as promising electronic materials due to their atomic thickness, chemical stability and scalability. Difficulties in the assembly of 2D electronic structures…
We have developed a novel, all-electronic biosensor for opioids that consists of an engineered mu opioid receptor protein, with high binding affinity for opioids, chemically bonded to a graphene field-effect transistor to read out ligand binding. A variant of the receptor protein that provided chemical recognition was computationally redesigned to enhance its solubility and stability in an aqueous environment. A shadow mask process was developed to fabricate arrays of hundreds of graphene transistors with average mobility of ~1500 cm2 V-1 s-1 and yield exceeding 98%. The biosensor exhibits hig…
