The ubiquitous use of sensing and signal processing is increasing exponentially with the advance of the Internet of Everything (IoE). In this context, the design of every time more power efficient sensor nodes is a must. Within these nodes, one of the most power-hungry components are the analog-to-digital converters (ADC). These components are used everywhere to translate real-world analog signals into computer intelligible digital signals. One of the promising architecture for the sensing of physiological signals is the level crossing ADC due to the sparse characteristics of those signals. One of the challenges to improve the power efficiency of this type of ADC lies in the use of continuous comparators to keep track of the input signal within the voltage references. The aim of this work is to investigate the impact of using continuous comparator which can be turned off without incurring error to the conversion of the level crossing ADC. New boundaries will be set for the correct behavior of the level crossing ADC together with the conditions for power saving with the proposed architecture. A 1V 5-bits level crossing ADC was implemented using the TSMC 0.18um process and fabricated for laboratory measurements. The ADC consumes 12.2uW during tracking state and with the proposed technique, the reduction of the average power can go from 4.2% to 45.5% depending on the activity and the type of the input signal.
A 125$μ$W 8kS/s Sub-pA Area-Efficient Current Sensing 45nm CMOS ADC for Biosensing
本文介绍了一种125 $μ$ W、面积效率(0.042 mm 2)、81 dB DR、8 kS/s电流检测ADC,采用45 nm CMOS工艺,能够检测亚pA电流。我们的方法结合了跨导放大器(TIA)和ADC到一个统一的结构,折叠成一个低噪声的电容TIA到第一级积分器的二阶Δ-Σ调制器。主要DAC反馈噪声通过积分器和微分器对的斜率修改利用电流缩放来减轻。
Design and Experimental Verification of a Novel Error-Backpropagation-Based Background Calibration for Time Interleaved ADC in Digital Communication Receivers
On-CMOS High-Throughput Multi-Modal Amperometric DNA Analysis with Distributed Thermal Regulation
精确的温度调节对于安培DNA分析实现高保真度、可靠性和通量至关重要。在这项工作中,9 × 6单元阵列的混合信号的CMOS分布式温度调节器的on-CMOS多模式电流DNA分析。支持三种DNA分析方法,包括恒电位安培法(CPA)、循环伏安法(CV)和阻抗谱法(IS)。电池内加热和温度传感元件采用标准CMOS技术实现,无需后处理。使用比例-积分-微分(PID)控制,局部温度可以调节到20 ℃和90 ℃之间的任何期望值的+/-0.5 ℃范围内。PID算法中的两个计算密集型运算(乘法和减法)由混合信号域中的单元内双斜率乘法ADC执行,从而实现小面积和低功耗。超过95%的电路模块在四种工作模式之间协同共享,包括CPA,CV,IS和建议的温度调节模式。在0.13 μ m CMOS工艺中制造的3 mm × 3 mm CMOS原型已经被充分实验表征。每个通道占用0.06mm2的面积,从1.2V电源消耗42 uW。所提出的分布式温度调节设计和混合信号PID实现可以应用于广泛的传感器和其他应用。
A Kalman Filter-Assisted Data-Predictive SAR ADC With Reduced Switching Energy for Low-Power Applications
School of Integrated Circuits (School of Microelectronics) Northwestern Polytechnical University(西北工业大学集成电路学院(微电子学院));Suzhou Institute of Nano-Tech Nano-Bionics Chinese Academy of Sciences(中国科学院苏州纳米技术与纳米仿生研究所)
针对超低功耗 ADC 需求,提出卡尔曼滤波器辅助数据预测型 SAR ADC,通过预测 4 个 MSB 实现并行切换,减少开关能量和量化周期,优化切换方案,双模式操作,降低功耗,适用于无线传感器网络。