We report on the investigation of morphology, magnetic and conductive properties of the mutilayered nanostructures [(Co$_{40}$Fe$_{40}$B$_{20}$)$_{34}$(SiO$_2$)$_{66}$]/[C]$_{47}$ consisting of the contacting magnetic (Co$_{40}$Fe$_{40}$B$_{20}$)$_{34}$(SiO$_2$)$_{66}$ nanocomposite and amorphous semiconductor carbon C layers. It is shown by Grazing-Incidence Small-Angle X-ray Scattering method that the ordering and the size of nanoparticles in the magnetic layers do not change profoundly with increasing of carbon layer thickness. Meanwhile, the electrical conductance and the magnetic properties are significantly varied: resistance of the samples changes by four orders of magnitude and superparamagnetic blocking temperature changes from 15 K to 7 K with the increment of carbon layer thickness $h_c$ from 0.4 nm to 1.8 nm. We assume that the formation of the homogeneous semiconductor interlayer leads to modification of the metal-insulator growth process that drives the changes in the magnetic and conductive properties.
We found that an optimized mixture of graphene and multilayer graphene - produced by the high-yield inexpensive liquid-phase-exfoliation technique - can lead to an extremely strong enhancement of the cross-plane thermal conductivity K of the composite. The "laser flash" measurements revealed a record-high enhancement of K by 2300 % in the graphene-based polymer at the filler loading fraction f =10 vol. %. It was determined that a relatively high concentration of single-layer and bilayer graphene flakes (~10-15%) present simultaneously with thicker multilayers of large lateral size (~ 1 microme…
Bismaleimide(BMI) resin/silsesquioxane or titania nanocomposites were synthesized from bismaleimide resin and SiO3/2 or TiO2 via the sol-gel process of N-γ-triethoxylsilylpropyl-maleamic acid (TESPMA) or tetrabutyltitanate (Ti(OnBu)4, TBT), respectively, in the presence of the AP-BMI prepolymers. These nanocomposite materials were characterized by FT-IR, FE-SEM, TGA and DMA. It was found that the nano-scale SiO3/2 or TiO2 particles were formed in the AP-BMI resin matrix and the average original particle size of the dispersed phase in the nanocomposites was less than 100nm, but the particle agg…
3D lattice Monte Carlo modeling of morphology formation of Si/SiOx nanocomposites during phase separation of nonstoichiometric Si oxide films
Educational Scientific Institute of High Technologies, Taras Shevchenko National University of Kyiv（基辅塔拉斯舍甫琴科国立大学高等技术教育科学研究所）；V. Lashkaryov Institute of Semiconductor Physics, National Academy of Sciences of Ukraine（乌克兰国家科学院瓦西里拉什卡廖夫半导体物理研究所）；National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute”（乌克兰国立技术大学“伊戈尔·西科尔斯基基辅理工学院”）
Bulk samples of carbon multilayer nanotubes with the structure of nested cones (fishbone structure) suitable for transport measurements, were prepared by compressing under high pressure (~25 kbar) a nanotube precursor synthesized through thermal decomposition of polyethylene catalyzed by nickel. The structure of the initial nanotube material was studied using high-resolution transmission electron microscopy. In the low-temperature range (4.2 - 100 K) the electric resistance of the samples changes according to the law ln ρ~ (T_0/T)^{1/3}, where T_0 ~ 7 K. The measured magnetoresistance is quadr…
Despite its interest for CMOS applications, Atomic Layer Deposition (ALD) of GeO$_{2}$ thin films, by itself or in combination with SiO$_{2}$, has not been widely investigated yet. Here we report the ALD growth of SiO$_{2}$/GeO$_{2}$ multilayers on Silicon substrates using a so far unreported Ge precursor. The characterization of multilayers with various periodicities reveals successful layer-by-layer growth with electron density contrast and absence of chemical intermixing, down to a periodicity of 2 atomic layers.
The nucleation, distribution, composition and structure of Pd nanocrystals in SiO$_2$ multilayers containing Ge, Si, and Pd are studied using High Resolution Transmission Electron Microscopy (HRTEM) and X-ray Photoelectron Spectroscopy (XPS), before and after heat treatment. The Pd nanocrystals in the as deposited sample seem to be capped by a layer of PdO$_x$. A 1-2 eV shift in binding energy was found for the Pd-3d XPS peak, due to initial state Pd to O charge transfer in this layer. The heat treatment results in a decomposition of PdO and Pd into pure Pd nanocrystals and SiO$_2$.
The mechanical property enhancement of polymer reinforced with nano-thin clay platelets (of high aspect ratio) is associated with a high polymer-filler interfacial area per unit volume. The ideal case of fully separated (exfoliated) platelets is generally difficult to achieve in practice: a typical nanocomposite also contains multilayer stacks of intercalated platelets. Here we use numerical modelling to investigate how the platelet properties affect the overall mechanical properties. The configuration of platelets is modelled using a statistical interpretation of the Representative Volume Ele…
We synthesize large-area graphene via atmospheric-pressure (AP) chemical vapor deposition (CVD) on copper, and transfer to SiO2 wafers. In contrast to low-pressure (LP) CVD on copper, optical contrast and atomic force microscopy measurements show AP-CVD graphene contains significant multi-layer areas. Raman spectroscopy always shows a single Lorentzian 2D peak, however systematic differences are observed in the 2D peak energy, width, and intensity for single- and multi-layer regions. We conclude that graphene multi-layers grown by AP-CVD on Cu are rotationally disordered.
Transition-metal dichalcogenide (TMD) semiconductors have been widely studied due to their distinctive electronic and optical properties. The property of TMD flakes is a function of its thickness, or layer number (N). How to determine N of ultrathin TMDs materials is of primary importance for fundamental study and practical applications. Raman mode intensity from substrates has been used to identify N of intrinsic and defective multilayer graphenes up to N=100. However, such analysis is not applicable for ultrathin TMD flakes due to the lack of a unified complex refractive index ($\tilde{n}$) …
Large-area growth of continuous transition metal dichalcogenides (TMDCs) layers is a prerequisite to transfer their exceptional electronic and optical properties into practical devices. It still represents an open issue nowadays. Electric and magnetic doping of TMDC layers to develop basic devices such as p-n junctions or diluted magnetic semiconductors for spintronic applications are also an important field of investigation. Here, we have developed two different techniques to grow MoSe$_2$ mono- and multi-layers on SiO$_2$/Si substrates over large areas. First, we co-deposited Mo and Se atoms…
Based on combination of experimental measurements and first-principles calculations we report a novel carbon-based catalytic material and describe significant acceleration of the hydrogenation of magnesium at room temperature in presence of nickel nanoparticles wrapped in multilayer graphene. Increase of the rate of magnesium hydrogenation in contrast to the mix of graphite and nickel nanoparticles evidences intrinsic catalytic properties of explored nanocomposites. Results of simulations demonstrate that the doping from metal substrate and the presence of Stone-Wales defects turn multilayer g…
To achieve high thermal conductivity (k) of polymer graphene nanocomposites, it is critically important to achieve efficient thermal coupling between graphene and its surrounding polymers through effective functionalization schemes. In this work, we demonstrate that edge-functionalization of graphene nanoplatelets (GnPs) can enable a larger enhancement of effective thermal conductivity in polymer-graphene nanocomposites, relative to basal plane functionalization. Effective thermal conductivity for edge case is predicted, through molecular dynamics simulations, to be up to 48% higher relative t…
The paper presents a comprehensive analysis of elastic properties of polystyrene-based nanocomposites filled with different types of inclusions: small spherical particles (SiO2 and Al2O3), alumosilicates (montmorillonite, halloysite natural tubules and Mica) and carbon nanofillers (carbon black and multi-walled carbon nanotubes). Composites were fabricated by melt technology. The analysis of composite melts showed that the introduction of Montmorillonite, Multi-walled carbon nanotubes, and Al2O3 particles provided an increase in melt viscosity by an average of 2 to 5 orders of magnitude over t…
The paper presents a new approach, based on controlled oxidation of nanoscale metallic multilayers, to produce strong and hard oxide/metal nanocomposite coatings with high strength and good thermal stability. The approach is demonstrated by performing long term annealing on sputtered Zr/Nb nanoscale metallic multilayers and investigating the evolution of their microstructure and mechanical properties by combining analytical transmission electron microscopy, nano-mechanical tests and finite element models. As-deposited multilayers were annealed at 350 C in air for times ranging between 1 - 336 …
We show that magnetic skyrmions can be stabilized at room temperature in continuous Ir/Co/Pt multilayers on SiO2/Si substrate without prior application of electric current or magnetic field. While decreasing the Co thickness, tuning of the magnetic anisotropy gives rise to a transition from worm-like domain patterns to long and separate stripes. The skyrmions are clearly imaged in both states using Magnetic Force Microscopy. The density of skyrmions can be significantly enhanced after applying the in-plane field procedure. In addition, we have investigated the phase diagram of a sample deposit…
A Variable-Spot-Size and Multi-Frequency Square-Pulsed Source (SPS) Approach for Comprehensive Characterization of Anisotropic Thermal Transport Properties in Multilayered Thin Films
School of Energy and Power Engineering, Huazhong University of Science and Technology（华中科技大学能源与动力工程学院）
Landau level broadening mechanisms in electrically neutral and quasineutral graphene were investigated through micro-magneto-Raman experiments in three different samples, namely, a natural single-layer graphene flake and a back-gated single-layer device, both deposited over Si/SiO2 substrates, and a multilayer epitaxial graphene employed as a reference sample. Interband Landau level transition widths were estimated through a quantitative analysis of the magnetophonon resonances associated with optically active Landau level transitions crossing the energy of the E_2g Raman-active phonon. Contra…
The reversal of magnetic bubble helicity through topologically trivial transient states provides an additional degree of freedom that promises the development of multidimensional magnetic memories. A key requirement for this concept is the stabilization of bubble states at ambient conditions on application-compatible substrates. In the present work we demonstrate a stabilization routine for remanent bubble states in high perpendicular magnetic anisotropy [(Co(0.44\,nm)/Pt(0.7\,nm)]$_X$, X = 48, 100, 150 multilayers on Si/SiO$_2$ substrates by exploring the effect of external magnetic fields ($…
In the paper, the processes occurring during low-temperature growth of non-hydrogenated amorphous Si and polycrystalline Si films on multilayer Si$_3$N$_4$/SiO$_2$/c-Si substrates from molecular beams under conditions of ultrahigh vacuum are studied in detail. Diffusion of hydrogen atoms from a dielectric layer into the growing film is shown to accompany the growth of a silicon film on a Si$_3$N$_4$ layer deposited by CVD or on a SiO$_2$ layer obtained by thermal oxidation of a silicon wafer. The process of hydrogen migration from the dielectric substrates into the silicon film is studied usin…
The structural interface properties of layered Pt/Ti/SiO2/Si electrodes have been investigated using high-resolution specular and diffuse x-ray reflectivity under grazing angles. Currently this multilayer system represents a technological standard as bottom electrodes for ferroelectric thin film applications. For the electronic and ferroelectric properties of integrated devices, the film-electrode interface is of crucial importance. We focused on Pt-100nm/Ti-10nm/SiO2/Si electrodes prepared under annealing conditions as employed in industrial processing, prior to the deposition of ferroelectri…
Synchrotron-based x-ray reflectivity is increasingly employed as an \textit{in situ} probe of surface morphology during thin film growth, but complete interpretation of the results requires modeling the growth process. Many models have been developed and employed for this purpose, yet no detailed, comparative studies of their scope and accuracy exists in the literature. Using experimental data obtained from hyperthermal deposition of pentane and diindenoperylene (DIP) on SiO$_2$, we compare and contrast three such models, both with each other and with detailed characterization of the surface m…
Over the past several years, the inherent scaling limitations of electron devices have fueled the exploration of high carrier mobility semiconductors as a Si replacement to further enhance the device performance. In particular, compound semiconductors heterogeneously integrated on Si substrates have been actively studied, combining the high mobility of III-V semiconductors and the well-established, low cost processing of Si technology. This integration, however, presents significant challenges. Conventionally, heteroepitaxial growth of complex multilayers on Si has been explored. Besides compl…
