Dissipation modulated Kelvin probe force microscopy method
Yoichi Miyahara, Peter Grutter
备注:
Chapter of the forthcoming book "Kelvin probe force microscopy - From single charge detection to device characterization" edited by Sascha Sadewasser and Thilo Glatzel
We review a new implementation of Kelvin probe force microscopy (KPFM) in which the dissipation signal of frequency modulation atomic force microscopy (FM-AFM) is used for dc bias voltage feedback (D-KPFM). The dissipation arises from an oscillating electrostatic force that is coherent with the tip oscillation, which is caused by applying the ac voltage between the tip and sample. The magnitude of the externally induced dissipation is found to be proportional to the effective dc bias voltage, which is the difference between the applied dc voltage and the contact potential difference. Two different implementations of D-KPFM are presented. In the first implementation, the frequency of the applied ac voltage, $f_\mathrm{el}$, is chosen to be the same as the tip oscillation ($f_\mathrm{el} = f_\mathrm{m}$: $1ω$D-KPFM). In the second one, the ac voltage frequency, $f_\mathrm{el}$, is chosen to be twice the tip oscillation frequency ($f_\mathrm{el}= 2 f_\mathrm{m}$: $2ω$D-KPFM). In $1ω$D-KPFM, the dissipation is proportional to the electrostatic force, which enables the use of a small ac voltage amplitude even down to $\approx 10$\,mV. In $2ω$D-KPFM, the dissipation is proportional to the electrostatic force gradient, which results in the same potential contrast as that obtained by FM-KPFM. D-KPFM features a simple implementation with no lock-in amplifier and faster scanning as it requires no low frequency modulation. The use of a small ac voltage amplitude in $1ω$D-KPFM is of great importance in characterizing of technically relevant materials in which their electrical properties can be disturbed by the applied electric field. $2ω$D-KPFM is useful when more accurate potential measurement is required. The operations in $1ω$ and $2ω$D-KPFM can be switched easily to take advantage of both features at the same location on a sample.
Local probing of superconductivity at oxide interfaces with atomic force microscopy
National Institute of Standards and Technology(美国国家标准与技术研究院);Joint Quantum Institute, Department of Physics, University of Maryland(马里兰大学物理系联合量子研究所);Department of Advanced Material Science, The University of Tokyo(东京大学先进材料科学系);Department of Physics and Astronomy, University of Pittsburgh(匹兹堡大学物理与天文学系);Department of Materials Science and Engineering, University of Wisconsin–Madison(威斯康星大学麦迪逊分校材料科学与工程系);Department of Chemistry and Biochemistry, University of Maryland(马里兰大学化学与生物化学系);Institute of Experimental and Applied Physics, University of Regensburg(雷根斯堡大学实验与应用物理研究所)
Disentangling Measurement Protocol from Material Physics in Isotypic and Anisotypic SiC/Si Heterojunctions: A Metrology-Driven Study for Betavoltaic Energy Conversion
Nanoscale mapping of stacking-dependent work function and local photoresponse in CVD-grown MoS2 bilayers by KPFM
Nanomagnetism and Microscopy Laboratory, Department of Physics, Indian Institute of Technology Hyderabad(印度理工学院海得拉巴分校物理系纳米磁学与显微镜实验室);Department of Physics, Indian Institute of Technology Bombay(印度理工学院孟买分校物理系)