Cavity cooling via quantum backaction force can extract thermal fluctuations from a mechanical resonator to reach the quantum ground state. Surface or bulk two-level-system (TLS) defects in a mechanical resonator can couple with the mechanical mode via deformation potential and affect the cooling process significantly. Here, we develop a theory to study the cavity cooling of a mechanical mode in the presence of a TLS defect using the adiabatic elimination technique. Our result shows that the cooling process depends strongly on the resonance and the damping rate of the TLS.
Achieving quantum correlations between two distant systems is a desirable feature for quantum networking. In this work, we study a system composed of two quantum emitter-cavity subsystems spatially separated. A mechanical resonator couples to either both quantum emitters or both cavities leading to quantum correlations between both subsystems such as non-local light-matter dressed states and cavity-cavity normal mode splitting. These indirect couplings can be explained by an effective Hamiltonian for large energy detuning between the mechanical resonator and the atoms/cavities. Moreover, it is…
We theoretically analyse the cooling dynamics of a high-Q mode of a mechanical resonator, when the structure is also an optical cavity and is coupled with a NV center. The NV center is driven by a laser and interacts with the cavity photon field and with the strain field of the mechanical oscillator, while radiation pressure couples mechanical resonator and cavity field. Starting from the full master equation we derive the rate equation for the mechanical resonator's motion, whose coefficients depend on the system parameters and on the noise sources. We then determine the cooling regime, the c…
Coupled electromechanical resonators that can be independently driven/detected and easily integrated with external circuits are essential for exploring mechanical modes based signal processing. Here, we present a room temperature phonon-cavity electromechanical system, consisting of two distinct resonators: a silicon nitride electromechanical drum capacitively coupled to an aluminum one. We demonstrate electromechanically induced transparency and amplification in a two-tone driving scheme and observe the phonon-cavity force affecting the mechanical damping rates of both movable objects. We als…
We propose two measurement-based schemes to cool a nonlinear mechanical resonator down to energies close to that of its ground state. The protocols rely on projective measurements of a spin degree of freedom, which interacts with the resonator through a Jaynes-Cummings interaction. We show the performance of these cooling schemes, that can be either concatenated -- i.e. built by repeating a sequence of dynamical evolutions followed by projective measurements -- or single-shot. We characterize the performance of both cooling schemes with numerical simulations, and pinpoint the effects of decohe…
We propose a protocol to dissipatively cool a room temperature mechanical resonator using a nitrogen-vacancy (NV) center ensemble. The spin ensemble is coupled to the resonator through its orbitally-averaged excited state, which has a spin-strain interaction that has not been previously characterized. We experimentally demonstrate that the spin-strain coupling in the excited state is $13.5\pm0.5$ times stronger than the ground state spin-strain coupling. We then theoretically show that this interaction combined with a high-density spin ensemble enables the cooling of a mechanical resonator fro…
We propose a domino-cooling method to realize simultaneous ground-state cooling of a coupled mechanical-resonator chain through an optomechanical cavity working in the unresolved-sideband regime. This domino-effect cooling is realized by combining the cold-damping feedback on the first mechanical resonator with nearest-neighbor couplings between other neighboring mechanical resonators. We obtain analytical results for the effective susceptibilities, noise spectra, final mean phonon numbers, and cooling rates of these mechanical resonators, and find the optimal-cooling condition for these reson…
Back-action evasion and squeezing of a mechanical resonator using a cavity detector
本文研究了利用参变耦合电磁腔对悬臂梁的量子测量。该方案最初是由于Braginsky等人[V.Braginsky，Y. I. Vorontsov和K. P.Thorne，Science 209，547（1980）]，允许悬臂运动的一个正交的反作用自由测量，并且因此有可能产生压缩状态。我们提出了一个完整的量子理论，这个系统，并推导出简单的条件时，量子限制的附加噪声可以被超越。我们还研究了测量的条件动力学，并讨论了如何这样的计划（与反馈耦合时）可以用来产生和检测压缩态的振荡器。我们的研究结果是相关的光学力学实验，并在量子力学实验中采用带状线谐振器耦合到机械谐振器。
The strong coupling limit of cavity quantum electrodynamics (QED) implies the capability of a matter-like quantum system to coherently transform an individual excitation into a single photon within a resonant structure. This not only enables essential processes required for quantum information processing but also allows for fundamental studies of matter-light interaction. In this work we demonstrate strong coupling between the charge degree of freedom in a gate-detuned GaAs double quantum dot (DQD) and a frequency-tunable high impedance resonator realized using an array of superconducting quan…
Hybrid devices based on the superconducting qubits have emerged as a promising platform for controlling the quantum states of macroscopic resonators. The nonlinearity added by a qubit can be a valuable resource for such control. Here we study a hybrid system consisting of a mechanical resonator longitudinally coupled to a transmon qubit. The qubit readout can be done by coupling to a readout mode like in c-QED setup. The coupling between the mechanical resonator and transmon qubit can be implemented by modulation of the SQUID inductance. In such a tri-partite system, we analyze the steady-stat…
We propose a scheme to cool down a mechanical resonator to its quantum ground-state, which is interacting with a working fluid via an optomechanical-like coupling. As opposed to standard laser cooling schemes where coherence renders the motion of a resonator to its ground-state, we consider an incoherent thermal source to achieve the same aim. We show that simultaneous cooling of two degenerate or near-degenerate mechanical resonators is possible, which is otherwise a challenging goal to achieve. The generalization of this method to the simultaneous cooling of multiple resonators is straightfo…
Ground state cooling of mechanical resonator is a way to generate macroscopic quantum states. Here we present a study of optomechanical cooling under the drive of square pulses without smooth profile. By illustrating the dynamical processes of cooling, we show how to choose the amplitudes and durations of square pulses, as well as the intervals between them, so that a mechanical resonator can be quickly cooled down to its ground state. Compared with the cooling under a continuous-wave drive field, the ground state cooling of a mechanical resonator can be performed more efficiently and flexibly…
When a gain system is coupled to a loss system, the energy usually flows from the gain system to the loss one. We here present a counterintuitive theory for the ground-state cooling of the mechanical resonator in optomechanical system via a gain cavity. The energy flows first from the mechanical resonator into the loss cavity, then into the gain cavity, and finally localizes there. The energy localization in the gain cavity dramatically enhances the cooling rate of the mechanical resonator. Moreover, we show that unconventional optical spring effect, e.g., giant frequency shift and optically i…
Quantum manipulation of mechanical resonators has been widely applied in fundamental physics and quantum information processing. Among them, cooling the mechanical system to its quantum ground state is regarded as a key step. In this work, we propose a scheme which one can realize ground-state cooling of resonator in a cavity magnomechanical system. The system consists of a microwave cavity and a small ferromagnetic sphere, in which phonon-magnon coupling and cavity photon-magnon coupling can be achieved via magnetostrictive interaction and magnetic dipole interaction, respectively. After adia…
Measurement-based control has emerged as an important technique to prepare mechanical resonators in pure quantum states for applications in quantum information processing and quantum sensing. Conventionally this has required two separate channels, one for probing the motion and another one acting back on the resonator. In this work, we analyze and experimentally demonstrate a technique of single-laser feedback cooling, where one laser is used for both probing and controlling the mechanical motion. We show using an analytical model and experiments that feedback cooling is feasible in this mode …
Quantum manipulation of coupled mechanical resonators has become an important research topic in optomechanics because these systems can be used to study the quantum coherence effects involving multiple mechanical modes. A prerequisite for observing macroscopic mechanical coherence is to cool the mechanical resonators to their ground state. Here we propose a theoretical scheme to cool two coupled mechanical resonators by introducing an optomechanical interface. The final mean phonon numbers in the two mechanical resonators are calculated exactly and the results show that the ground-state coolin…
We propose to realize the ground state cooling of magnomechanical resonator in a parity-time (PT)-symmetric cavity magnomechanical system composed of a loss ferromagnetic sphere and a gain microwave cavity. In the scheme, the magnomechanical resonator can be cooled close to its ground state via the magnomechanical interaction, and it is found that the cooling effect in PT-symmetric system is much higher than that in non-PT-symmetric system. Resorting to the magnetic force noise spectrum, we investigate the final mean phonon number with experimentally feasible parameters and find surprisingly t…
Ground-state cooling of mechanical resonators is an important task in quantum optomechanics, because it is a necessary prerequisite for creation, manipulation, and application of macroscopic mechanical coherence. Here, we propose a transient-state scheme to accelerate ground-state cooling of a mechanical resonator in a three-mode loop-coupled optomechanical system via shortcuts to adiabaticity (STA). We consider four kinds of coupling protocols and calculate the evolution of the mean phonon number of the mechanical resonator in both the adiabatic and STA cases. We verify that the ground-state …
We present a simultaneous-cooling protocol for a double-resonator system via projective measurements on an ancillary $V$-type qutrit. Through repeated measurements on the ground state of the ancillary system, the two resonators can be cooled down to their respective ground states from thermal states. With respect to the measurement-based cooling, an optimized measurement-interval $τ_{\rm opt}$ is analytically obtained for the first time, which is inversely proportional to the collective thermal Rabi frequency $Ω_{\rm th}$ as a function of the resonators' average population of the last round. U…
Cooling microwave resonators to near the quantum ground state, crucial for their operation in the quantum regime, is typically achieved by direct device refrigeration to a few tens of millikelvin. However, in quantum experiments that require high operation power such as microwave-to-optics quantum transduction, it is desirable to operate at higher temperatures with non-negligible environmental thermal excitations, where larger cooling power is available. In this Letter, we present a radiative cooling protocol to prepare a superconducting microwave mode near its quantum ground state in spite of…
我们报告的演示和定量表征的一维腔冷却的一个单一的被困88Sr+离子在解决边带制度。我们测量了腔跃迁的光谱，腔加热和冷却的速率，以及稳态冷却极限。受离子和腔之间的适度耦合限制的22.5（3）运动量子的腔冷却动力学和冷却极限与没有任何自由参数的简单模型[Phys. Rev. A 64，033405]一致，验证了腔冷却的速率方程模型。
We present the generation of continuous-wave optical squeezing from a titanium-indiffused lithium niobate waveguide resonator. We directly measure 2.9\pm 0.1 dB of single-mode squeezing, which equates to a produced level of 4.9\pm 0.1 dB after accounting for detection losses. This device showcases the current capabilities of this waveguide architecture and precipitates more complicated integrated continuous-wave quantum devices in the continuous-variable regime.
One of the most effective methods for cooling micro and nano devices to ultra low temperatures is the sideband method. Currently, this approach is being studied experimentally and theoretically. Theoretical results that relate to this method correspond to the case of the interaction of an electromagnetic field with a micro or nano resonator through radiation pressure. Obviously, if you choose a charged micro or nano resonator, the interaction will be different. In this paper, this case is considered and it is shown that cooling will be as effective as in the sideband method. The resulting fina…
