We propose to realize the ground state cooling of magnomechanical resonator in a parity-time (PT)-symmetric cavity magnomechanical system composed of a loss ferromagnetic sphere and a gain microwave cavity. In the scheme, the magnomechanical resonator can be cooled close to its ground state via the magnomechanical interaction, and it is found that the cooling effect in PT-symmetric system is much higher than that in non-PT-symmetric system. Resorting to the magnetic force noise spectrum, we investigate the final mean phonon number with experimentally feasible parameters and find surprisingly that the ground state cooling of magnomechanical resonator can be directly achieved at room temperature. Furthermore, we also illustrate that the ground state cooling can be flexibly controlled via the external magnetic field.
Quantum manipulation of mechanical resonators has been widely applied in fundamental physics and quantum information processing. Among them, cooling the mechanical system to its quantum ground state is regarded as a key step. In this work, we propose a scheme which one can realize ground-state cooling of resonator in a cavity magnomechanical system. The system consists of a microwave cavity and a small ferromagnetic sphere, in which phonon-magnon coupling and cavity photon-magnon coupling can be achieved via magnetostrictive interaction and magnetic dipole interaction, respectively. After adia…
Kerr-induced nonreciprocal transparency and group delay in a hybrid cavity magnomechanical system
Ibnou Zohr University（伊本·佐赫尔大学）；Princess Nourah bint Abdulrahman University（公主努拉·宾特·阿卜杜勒拉赫曼大学）；Umm Al-Qura University（乌姆古拉大学）；Mohammed V University in Rabat（拉巴特穆罕默德五世大学）；University of Bisha（比沙大学）
When a gain system is coupled to a loss system, the energy usually flows from the gain system to the loss one. We here present a counterintuitive theory for the ground-state cooling of the mechanical resonator in optomechanical system via a gain cavity. The energy flows first from the mechanical resonator into the loss cavity, then into the gain cavity, and finally localizes there. The energy localization in the gain cavity dramatically enhances the cooling rate of the mechanical resonator. Moreover, we show that unconventional optical spring effect, e.g., giant frequency shift and optically i…
We propose a protocol to dissipatively cool a room temperature mechanical resonator using a nitrogen-vacancy (NV) center ensemble. The spin ensemble is coupled to the resonator through its orbitally-averaged excited state, which has a spin-strain interaction that has not been previously characterized. We experimentally demonstrate that the spin-strain coupling in the excited state is $13.5\pm0.5$ times stronger than the ground state spin-strain coupling. We then theoretically show that this interaction combined with a high-density spin ensemble enables the cooling of a mechanical resonator fro…
Cavity quantum electrodynamics (C-QED) effects, such as Rabi splitting, Rabi oscillations and superradiance, have been demonstrated with nitrogen vacancy center spins in diamond in microwave resonators at cryogenic temperature. In this article we explore the possibility to realize strong collective coupling and the resulting C-QED effects with ensembles of spins at room temperature. Thermal excitation of the individual spins by the hot environment leads to population of collective Dicke states with low symmetry and a reduced collective spin-microwave field coupling. However, we show with simul…
Coupled electromechanical resonators that can be independently driven/detected and easily integrated with external circuits are essential for exploring mechanical modes based signal processing. Here, we present a room temperature phonon-cavity electromechanical system, consisting of two distinct resonators: a silicon nitride electromechanical drum capacitively coupled to an aluminum one. We demonstrate electromechanically induced transparency and amplification in a two-tone driving scheme and observe the phonon-cavity force affecting the mechanical damping rates of both movable objects. We als…
Recent experiments demonstrated the cooling of a microwave mode of a high-quality dielectric resonator coupled to optically cooled nitrogen-vacancy (NV) spins in diamond. Our recent theoretical study [arXiv:2110.10950] pointed out the cooled NV spins can be used to realize cavity quantum electrodynamics effects (C-QED) at room temperature. In this article, we propose to modify the setup used in a recent diamond maser experiment [Nature 55, 493-496 (2018)], which features a higher spin transition frequency, a lower spin-dephasing rate and a stronger NV spins-resonator coupling, to realize bette…
All quantum optomechanics experiments to date operate at cryogenic temperatures, imposing severe technical challenges and fundamental constraints. Here we present a novel design of on-chip mechanical resonators which exhibit fundamental modes with frequencies $f$ and mechanical quality factors $Q_\mathrm{m}$ sufficient to enter the optomechanical quantum regime at room temperature. We overcome previous limitations by designing ultrathin, high-stress silicon nitride (Si$_3$N$_4$) membranes, with tensile stress in the resonators' clamps close to the ultimate yield strength of the material. By pa…
Ground-state cooling of mesoscopic mechanical resonators is a fundamental requirement for test of quantum theory and for implementation of quantum information. We analyze the cavity optomechanical cooling limits in the intermediate coupling regime, where the light-enhanced optomechanical coupling strength is comparable with the cavity decay rate. It is found that in this regime the cooling breaks through the limits in both the strong and weak coupling regimes. The lowest cooling limit is derived analytically at the optimal conditions of cavity decay rate and coupling strength. In essence, cool…
Stationary entanglement in a four-mode optomechanical system, especially under roomtemperature, is discussed. In this scheme, when the coupling strengths between the two target modes and the mechanical resonator are equal, the results cannot be explained by the Bogoliubov mode- based scheme. This is related to the idea of quantum-mechanics-free subspace, which plays an important role when the thermal noise of the mechanical modes is considered. Significantly prominent steady-state entanglement can be available under room-temperature.
A room-temperature mechanical oscillator undergoes thermal Brownian motion with an amplitude much larger than the amplitude associated with a single phonon of excitation. This motion can be read out and manipulated using laser light using a cavity-optomechanical approach. By performing a strong quantum measurement, i.e., counting single photons in the sidebands imparted on a laser, we herald the addition and subtraction of single phonons on the 300K thermal motional state of a 4GHz mechanical oscillator. To understand the resulting mechanical state, we implement a tomography scheme and observe…
Observation of quantum phenomena in cryogenic, optically cooled mechanical resonators has been recently achieved by a few experiments based on cavity optomechanics. A well-established experimental platform is based on a thin film stoichiometric ($ Si_3 N_4 $) nanomembrane embedded in a Fabry-Perot cavity, where the coupling with the light field is provided by the radiation pressure of the light impinging on the membrane surface. Two crucial parameters have to be optimized to ensure that these systems work at the quantum level: the cooperativity $ C$ describing the optomechanical coupling and t…
We study the optomechanical properties of stoichiometric SiN resonators through a combination of spectroscopic and interferometric imaging techniques. At room temperature, we demonstrate ultrahigh quality factors of $5 \times 10^7$ and a $f \times Q$ product of $1 \times 10^{14}$ Hz that, to our knowledge, correspond to the largest values yet reported for mesoscopic flexural resonators. Through a comprehensive study of the limiting dissipation mechanisms as a function of resonator and substrate geometry, we identify radiation loss through the supporting substrate as the dominant loss process. …
We demonstrate dispersive readout of the spin of an ensemble of Nitrogen-Vacancy centers in a high-quality dielectric microwave resonator at room temperature. The spin state is inferred from the reflection phase of a microwave signal probing the resonator. Time-dependent tracking of the spin state is demonstrated, and is employed to measure the T1 relaxation time of the spin ensemble. Dispersive readout provides a microwave interface to solid state spins, translating a spin signal into a microwave phase shift. We estimate that its sensitivity can outperform optical readout schemes, owing to th…
Recent progress in nonlinear optical materials and microresonators has brought quantum computing with bulk optical nonlinearities into the realm of possibility. This platform is of great interest, not only because photonics is an obvious choice for quantum networks, but also because it may be the only feasible route to quantum information processing at room temperature. We introduce a paradigm for room-temperature photonic quantum logic that significantly simplifies the realization of various quantum circuits, and in particular, of error correction. It uses only the strongest available bulk no…
Despite numerous efforts the coupling between randomly arranged multi-NV centers and also resonators has not been improved significantly mainly due to our limited knowledge of their entanglement times (2t_ent). Here, we demonstrate a very strong coupling between three-NV centers by using a simulated triple electron-electron resonance experiment based on a new quantum (U_C) gate on IBM quantum simulator with 2t_ent ~12.5 microsecond arranged is a triangular configuration. Interestingly through breaking the symmetry of couplings an even lower 2t_ent ~6.3 μs can be achieved. This simulation not o…
Nanomechanical resonators are a key tool for future quantum technologies such as quantum force sensors and interfaces, and for studies of macroscopic quantum physics. The ability to prepare room temperature non-classical states is a major outstanding challenge. Here, we explore the use of measurement-based state conditioning to achieve this. We demonstrate conditional cooling of a nanomechanical resonator that has non-Markovian decoherence, and show theoretically that the non-Markovianity makes quantum squeezing significantly easier to achieve. We further show that collective measurement of mu…
The strong-coupling regime between an electronic transition and the photonic mode of a optical resonator manifests itself in the lifting of the degeneracy between the two modes and the creation of two polariton states with mixed optical and electronic character. This phenomenon has been studied in atoms, excitons in semiconductors and quantum electrodynamics circuits based on Josephson junctions. Recently, there is also strong interest to study similar effects using intersubband transitions in quantum wells in the terahertz, where the ultra strong coupling regime can be reached and new physica…
Many protocols in quantum science and technology require initializing a system in a pure quantum state. In the context of the motional state of massive resonators, this enables studying fundamental physics at the elusive quantum-classical transition, and measuring force and acceleration with enhanced sensitivity. Laser cooling has been a method of choice to prepare mechanical resonators in the quantum ground state, one of the simplest pure states. However, in order to overcome the heating and decoherence by the thermal bath, this usually has to be combined with cryogenic cooling. Here, we lase…
Strongly interacting atom-cavity systems within a network with many nodes constitute a possible realization for a quantum internet which allows for quantum communication and computation on the same platform. To implement such large-scale quantum networks, nanophotonic resonators are promising candidates because they can be scalably fabricated and interconnected with waveguides and optical fibers. By integrating arrays of ring resonators into a vapor cell we show that thermal rubidium atoms above room temperature can be coupled to photonic cavities as building blocks for chip-scale hybrid circu…
The optical hybridization of the electronic states in strongly coupled molecule-cavity systems have revealed unique properties such as lasing, room temperature polariton condensation, and the modification of excited electronic landscapes involved in molecular isomerization. Here we show that molecular vibrational modes of the electronic ground state can also be coherently coupled with a micro-cavity mode at room temperature, given the low vibrational thermal occupation factors associated with molecular vibrations, and the collective coupling of a large ensemble of molecules immersed within the…
Preparing mechanical systems in their lowest possible entropy state, the quantum ground state, starting from a room temperature environment is a key challenge in quantum optomechanics. This would not only enable creating quantum states of truly macroscopic systems, but at the same time also lay the groundwork for a new generation of quantum-limited mechanical sensors in ambient environments. Laser cooling of optomechanical devices using the radiation pressure force combined with cryogenic precooling has been successful at demonstrating ground state preparation of various devices, while a simil…
Würzburg-Dresden Cluster of Excellence ctd.qmat（维尔茨堡-德累斯顿卓越集群 ctd.qmat）；NASA Jet Propulsion Laboratory, California Institute of Technology（美国宇航局喷气推进实验室，加州理工学院）
We present a laser system based on a 48 cm long optical glass resonator. The large size requires a sophisticated thermal control and optimized mounting design. A self balancing mounting was essential to reliably reach sensitivities to acceleration of below $Δν/ ν$ < 2E-10 /g in all directions. Furthermore, fiber noise cancellations from a common reference point near the laser diode to the cavity mirror and to additional user points (Sr clock and frequency comb) are implemented. Through comparison to other cavity-stabilized lasers and to a strontium lattice clock an instability of below 1E-16 a…
We study synchronization of a room temperature optomechanical system formed by two resonators coupled via radiation pressure to the same driven optical cavity mode. By using stochastic Langevin equations and effective slowly-varying amplitude equations, we explore the long-time dynamics of the system. We see that thermal noise can induce significant non-Gaussian dynamical properties, including the coexistence of multi-stable synchronized limit cycles and phase diffusion. Synchronization in this optomechanical system is very robust with respect to thermal noise: in fact, even though each oscill…
We investigate a hybrid quantum system consisting of a cavity optomechanical device optically coupled to an ultracold quantum gas. We show that the dispersive properties of the ultracold gas can be used to dramatically modify the optomechanical response of the mechanical resonator. We examine hybrid schemes wherein the mechanical resonator is coupled either to the motional or the spin degrees of freedom of the ultracold gas. In either case, we find an enhancement of more than two orders of magnitude in optomechanical cooling due to this hybrid interaction. Significantly, based on demonstrated …
Deterministic GHz-rate single photon sources at room-temperature would be essential components for various quantum applications. However, both the slow intrinsic decay rate and the omnidirectional emission of typical quantum emitters are two obstacles towards achieving such a goal which are hard to overcome simultaneously. Here we solve this challenge by a hybrid approach, using a complex monolithic photonic resonator constructed of a gold nanocone responsible for the rate enhancement, and a circular Bragg antenna for emission directionality. A repeatable process accurately binds quantum dots …
We demonstrate the integration of a mesoscopic ferromagnetic needle with a cavity optomechanical torsional resonator, and its use for quantitative determination of the needle's magnetic properties, as well as amplification and cooling of the resonator motion. With this system we measure torques as small as 32 zNm, corresponding to sensing an external magnetic field of 0.12 A/m (150 nT). Furthermore, we are able to extract the magnetization (1710 kA/m) of the magnetic sample, not known a priori, demonstrating this system's potential for studies of nanomagnetism. Finally, we show that we can mag…
