Soft matters whose constituents are deformable are ubiquitous in nature especially in biological systems-including cells and their organelles-as well as in foams and emulsions. The capacity for deformation in these soft materials gives rise to a range of intriguing phenomena, such as glassy behavior without any size dispersity, cluster crystal formation, and re-entrant melting. Deformability also plays a crucial role in facilitating essential biological processes, such as the flow of blood through veins and arteries. In this work, we investigate assemblies of two-dimensional (2D) polymeric, non-overlapping rings, which mimic deformable particulates in 2D using extensive molecular dynamics simulations. The rings are confined in a rectangular channel with hard walls perpendicular to the flow direction, mimicking natural flow conditions. We analyze the flow properties of these deformable particle assemblies at two different stiffness values. To further asses the impact of deformability, we examine the same monodisperse system at higher densities for the stiffer rings, where deformation is necessary and a fluid layer emerges at the channel edges. Finally, we explore a mixture of rings with two distinct stiffnesses and observe effective segregation of soft and hard particles at small channel widths.
We study the rheology of a suspension of soft deformable droplets subjected to a pressure-driven flow. Through computer simulations, we measure the apparent viscosity as a function of droplet concentration and pressure gradient, and provide evidence of a discontinuous shear thinning behaviour, which occurs at a concentration-dependent value of the forcing. We further show that this response is associated with a nonequilibrium transition between a `hard' (or less deformable) phase, which is nearly jammed and flows very slowly, and a `soft' (or more deformable) phase, which flows much more easil…
Soft, amorphous solids such as tissues, foams, and emulsions are composed of deformable particles. However, the effect of single-particle deformability on the collective behavior of soft solids is still poorly understood. We perform numerical simulations of two-dimensional jammed packings of explicitly deformable particles to study the mechanical response of model soft solids. We find that jammed packings of deformable particles with excess shape degrees of freedom possess low-frequency quartic vibrational modes that stabilize the packings even though they possess fewer interparticle contacts …
The fracture of highly deformable soft materials is of great practical importance in a wide range of technological applications, emerging in fields such as soft robotics, stretchable electronics and tissue engineering. From a basic physics perspective, the failure of these materials poses fundamental challenges due to the strongly nonlinear and dissipative deformation involved. In this review, we discuss the physics of cracks in soft materials and highlight two length scales that characterize the strongly nonlinear elastic and dissipation zones near crack tips in such materials. We discuss phy…
We demonstrate the existence of unconventional rheological and memory properties in systems of soft-deformable particles whose energy depends on their shape, via numerical simulations. At large strains, these systems experience an unconventional shear weakening transition characterized by an increase in the mechanical energy and a drastic drop in shear stress, which stems from the emergence of short-ranged tetratic order. In these weakened states, the contact network evolves reversibly under strain reversal, keeping memory of its initial state, while the microscopic dynamics is irreversible.
We adapt Vertex models to understand the physical origin of the formation of long-range ordered structures in repulsive soft particles. The model incorporates contributions from the volume and surface area of each particle. Sampling using Monte Carlo simulations allows the system to naturally select preferred structures. We observe transitions between a body-centered cubic ordered state and a disordered state. Constraints to the simulation domain can suppress or allow the system to follow a path similar to Martensitic transformations from one ordered state to another ordered state. Finally, we…
Dense suspensions of soft colloidal particles display a broad range of physical and rheological properties which are still far from being fully understood. To elucidate the role of deformability on colloidal flow, we employ computer simulations to measure the apparent viscosity of a system of droplets of variable surface tension subjected to a pressure-driven flow. We confirm that our suspension generically undergoes discontinuous shear thinning, and determine the dependence of the onset of the discontinuity on surface tension. We find that the effective viscosity of the suspension is mainly d…
Few simulations exist for microswimmers near deformable interfaces. Here, we present numerical simulations of the hydrodynamic flows associated with a single microswimmer embedded in a binary fluid mixture. The two fluids demix, separated by a penetrable and deformable interface that we assume to be initially prepared in its planar ground-state. We find that the microswimmer can either penetrate the interface, move parallel to it or bounce back off it. We analyze how the trajectory depends on the swimmer type (pusher/puller) and the angle of incidence with respect to the interface. Our simulat…
Fundamental biological and biomimetic processes, from tissue morphogenesis to soft robotics, rely on the propagation of chemical and mechanical surface waves to signal and coordinate active force generation. The complex interplay between surface geometry and contraction wave dynamics remains poorly understood, but will be essential for the future design of chemically-driven soft robots and active materials. Here, we couple prototypical chemical wave and reaction-diffusion models to non-Euclidean shell mechanics to identify and characterize generic features of chemo-mechanical wave propagation …
We study experimentally the motion of non-deformable microbeads in a linear shear flow close to a wall bearing a thin and soft polymer layer. Combining microfluidics and 3D optical tracking, we demonstrate that the steady-state bead/surface distance increases with the flow strength. Moreover, such lift is shown to result from flow-induced deformations of the layer, in quantitative agreement with theoretical predictions from elastohydrodynamics. This study thus provides the first experimental evidence of "soft lubrication" at play at small scale, in a system relevant {\it e.g.} to the physics o…
Cell deformability is an essential determinant for tissue-scale mechanical nature, such as fluidity and rigidity, and is thus crucial for understanding tissue homeostasis and stable developmental processes. However, numerical simulations for the collective dynamics of cells with arbitral cell deformations akin to mesenchymal, ameboid, and epithelial cells in a non-confluent situation need high computational costs and are still challenging. Here we propose a new method that allows us to study significantly larger numbers of cells than existing methods. Using the method, we investigated the dens…
Jamming is a fundamental transition that governs the mechanical behavior of particulate media, including sand, foam and dense suspensions but also biological tissues: Upon compression, particulate media can change from freely flowing to a disordered solid. Jamming has previously been conceived as a bulk phenomenon involving particle motions in fixed geometries. In a diverse class of soft materials, however, solidification can take place in a deformable geometry, such as on the surface of a fluid droplet or in the formation of a bijel. In these systems the nature and dynamics of jamming remains…
Softer than soft, squishy granular matter is composed of grains capable of significantly changing their shape (typically larger than 10% of deformation) without tearing or breaking. Because of the difficulty to test these materials experimentally and numerically, such a family of discrete systems remains largely ignored in the granular matter physics field despite being commonly found in nature and industry. Either from a numerical, experimental, or analytical point of view, the study of highly deformable granular matter involves several challenges covering, for instance: ($i$) the need to inc…
The mechanical deformability of single cells is an important indicator for various diseases such as cancer, blood diseases and inflammation. Lab-on-a-chip devices allow to separate such cells from healthy cells using hydrodynamic forces. We perform hydrodynamic simulations based on the lattice-Boltzmann method and study the behavior of an elastic capsule in a microfluidic channel flow in the inertial regime. While inertial lift forces drive the capsule away from the channel center, its deformability favors migration in the opposite direction. Balancing both migration mechanisms, a deformable c…
Laminar flow in devices fabricated from soft materials causes deformation of the passage geometry, which affects the flow rate--pressure drop relation. For a given pressure drop, in channels with narrow rectangular cross-section, the flow rate varies as the cube of the channel height, so deformation can produce significant quantitative effects, including nonlinear dependence on the pressure drop [{Gervais, T., El-Ali, J., Günther, A. \& Jensen, K.\ F.}\ 2006 Flow-induced deformation of shallow microfluidic channels.\ \textit{Lab Chip} \textbf{6}, 500--507]. Gervais et. al. proposed a successfu…
