arXivDaily arXiv每日学术速递 周一至周五更新
arXiv周末暂无论文更新,休息一下吧,周末愉快~~
arXiv 2409.20093hep-exphysics.ins-det
收藏

TOTEM nT2 探测器:架构、运行与性能

The TOTEM nT2 detector: architecture, operation and performance

Edoardo Bossini

AI总结:

本文介绍了为2023年LHC专项运行设计的TOTEM nT2探测器,其基于塑料闪烁体与SiPM阵列,采用抗辐射SoC FPGA容错架构以适应高辐射环境下的快速安装与运行,并报告了其成功运行的初步性能结果。

摘要:

LHC 上的 TOTEM 实验已对衍射过程和 pp 截面产生了一大批测量结果。一种名为 nT2 的新探测器被设计用于在 2023 年 LHC 专项运行期间测量非弹性散射率。由于处于高辐射环境,探测器最多必须在 10-20 分钟内完成安装,随后在短短几天内完成调试并投入运行。该探测器基于由 SiPM 阵列读取的塑料闪烁体设计,充分考虑了这些限制条件。前端、DAQ 和控制电子设备采用了容错架构开发,将尽可能多的功能转移到抗辐射 SoC FPGA 上,该 FPGA 集成了一个 ARM 控制器。本文将描述 nT2 探测器及其读出和控制电子设备。该探测器在专项运行期间成功运行:我们将报告探测器性能的初步结果。

英文摘要:

The TOTEM experiment at the LHC has produced a large set of measurements on diffractive processes and pp cross sections. A new detector, called nT2, has been designed to measure the inelastic scattering rate during the LHC special run of 2023. Due to the high radiation environment, the detector had to be installed in 10-20 minutes at most, then commissioned and operated after only few days. The detector, based on plastic scintillators read out by matrices of SiPMs, was designed with such constraints in mind. The front-end, DAQ and control electronics was developed with a fault tolerant architecture, moving as many functionalities as possible on a radiation tolerant SoC FPGA, hosting an integrated ARM controller. Here we will describe the nT2 detector and its read-out and control electronics. The detector was successfully operated during the special run: we will report the preliminary results on the detector performance.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑