基于光子到达时间的飞行时间测量全波形建模
Full-Waveform Modeling for Time-of-Flight Measurements based on Arrival Time of Photons
摘要:
现代LiDAR传感器在安全关键型应用中的使用越来越多。因此,在苛刻的环境条件下对系统的行为进行高度精确的建模是必要的。在本文中,我们提出了一个模块化的结构,以准确地模拟放大的原始探测器信号的直接飞行时间激光雷达系统的同轴发射器-接收器的光学。我们的模型描述了一种基于标准光学元件和能够将单光子转换为电信号的检测器的测量系统。为了验证模型的预测,在规定的距离上对不同反射率的目标进行了单点测量。统计分析显示,模拟和测量信号幅度水平的R平方值大于0.990。噪声建模显示出良好的一致性与不同的目标辐照度水平进行测量。研究结果对激光雷达系统复杂信号处理链的建模具有指导意义,因为它可以在开发过程的早期预测系统的关键参数。因此,可以减轻设计缺陷造成的不必要成本。模块化结构允许轻松适应任意LiDAR系统。
英文摘要:
Modern LiDAR sensors find increasing use in safety-critical applications. Therefore, highly accurate modeling of the system's behavior under demanding environmental conditions is necessary. In this paper, we present a modular structure to accurately simulate the amplified raw detector signal of a direct time-of-flight LiDAR system for coaxial transmitter-receiver optics. Our model describes, a measurement system based on standard optical components and a detector able of converting single photons to an electrical signal. To verify the model's predictions, single-point measurements for targets of different reflectivity at defined distances were performed. Statistical analysis shows an R-squared value greater than 0.990 for simulated and measured signal amplitude levels. Noise modeling shows good accordance with the performed measurements for different target irradiance levels. The presented results have a guiding significance in the modeling of the complex signal processing chain of LiDAR systems, as it enables the prediction of key parameters of the system early in the development process. Hence, unnecessary costs by design flaws can be mitigated. The modular structure allows easy adaption for arbitrary LiDAR systems.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。