Ambient backscatter communication is an emerging and promising low-energy technology for the Internet of Things. In such a system, a tag sends a binary message to a reader by backscattering a radio frequency signal generated by an ambient source. The tag can operate without battery and without generating additional radio waves. However, the tag-to-reader link suffers from the source-to-reader interference. In this paper, we propose a polarization-based reconfigurable antenna in order to improve the robustness of the tag-to-reader link against the source-to-reader direct interference. More precisely, we compare different types of tags' antennas, different tags' encoding schemes, and different detectors at the reader. By using analysis, numerical simulations, and experiments, we show that a polarization-based reconfigurable tag with four polarization directions significantly outperforms a non-reconfigurable tag, and provides almost the same performance as an ideal reconfigurable tag with a large number of reconfigurable polarization patterns.
We present a sensing system that determines soil moisture via RF using backscatter tags paired with a commodity ultra-wideband RF transceiver. Despite decades of research confirming the benefits, soil moisture sensors are still not widely adopted on working farms for three key reasons: the high cost of sensors, the difficulty of deploying and maintaining these sensors, and the lack of reliable internet access in rural areas. We seek to address these obstacles by designing a low-cost soil moisture sensing system that uses a hybrid approach of pairing completely wireless backscatter tags with a …
For large-scale Internet of Things (IoT), backscatter communication is a promising technology to reduce power consumption and simplify deployment. However, backscatter communication lacks stability, along with limited communication range within a few meters. Due to the limited computation ability of backscatter tags, it is burdensome to effectively adapt the bitrate for the time-varying channel. Thus, backscatter tags are failed to fully utilize the optimal transmission rate. In this paper, we design a system named COOK with self-reliant bitrate adaptation in backscatter communication. Channel…
Ambient backscatter communication system is an emerging and promising low-energy technology for Internet of Things. In such system, a device named tag, sends a binary message to a reader by backscattering a radio frequency signal generated by an ambient source. Such tag can operate without battery and without generating additional wave. However, the tag-to-reader link suffers from the source-to-reader direct interference. In this paper, for the first time, we propose to exploit a "polarization reconfigurable" antenna to improve robustness of the tag-to-reader link against the source-to-reader …
Huazhong University of Science and Technology（华中科技大学）；Southeast University（东南大学）
Recent years have witnessed the rapid proliferation of backscatter technologies that realize the ubiquitous and long-term connectivity to empower smart cities and smart homes. Localizing such backscatter tags is crucial for IoT-based smart applications. However, current backscatter localization systems require prior knowledge of the site, either a map or landmarks with known positions, which is laborious for deployment. To empower universal localization service, this paper presents Rover, an indoor localization system that localizes multiple backscatter tags without any start-up cost using a r…
Future Internet-of-Things (IoT) has high demand for energy-saving communications, especially in remote areas and smart cities. To meet this demand, we propose novel Unmanned Aerial Vehicle-assisted backscatter communications, where a UAV first collects data from multiple terrestrial backscattering tags via time division multiple access, and then flies into the coverage region of a terrestrial base station to upload its collected data to its associated base station. To determine the optimal UAV data collection location, we first analyze the system average outage probability, and then optimize t…
In this paper, we present an ambient backscatters-friendly 5G network that creates locations with large power (hot spots) for tags and good reception locations (quiet spots or coherent spots) for readers. The massive multiple input multiple output (M-MIMO) antenna and beamforming capability of the 5G network is used as follows. In a first step, a training device (separate from tags and readers) is used to send pilots and train the 5G network to perform focusing and/or nulling onto marked locations. In a second step, tags and readers are positioned onto the marked locations. The robustness of M…
A reconfigurable intelligent surface (RIS) enhanced non-orthogonal multiple access assisted backscatter communication (RIS-NOMABC) system is considered. A joint optimization problem over power reflection coefficients and phase shifts is formulated. To solve this non-convex problem, a low complexity algorithm is proposed by invoking the alternative optimization, successive convex approximation and manifold optimization algorithms. Numerical results corroborate that the proposed RIS-NOMABC system outperforms the conventional non-orthogonal multiple access assisted backscatter communication (NOMA…
Sixth generation (6G) mobile networks may include new passive technologies, such as ambient backscatter communication or the use of reconfigurable intelligent surfaces, to avoid the emission of waves and the corresponding energy consumption. On the one hand, a reconfigurable intelligent surface improves the network performance by adding electronically controlled reflected paths in the radio propagation channel. On the other hand, in an ambient backscatter system, a device, named tag, communicates towards a reader by backscattering the waves of an ambient source (such as a TV tower). However, t…
Ambient Backscatter Communication (AmBC) is an emerging communication technology that can enable green Internet-of-Things deployments. The widespread acceptance of this paradigm is limited by low Signal-to-Interference-Plus-Noise Ratio (SINR) of the signal impinging on the receiver antenna due to the strong direct path interference and unknown ambient signal. The adverse impact of these two factors can be mitigated by using non-coherent multi-antenna receivers, which is known to require higher SINR to reach Bit-Error-Rate (BER) performance of coherent receivers. However, in literature, coheren…
Due to extremely low power consumption, backscatter has become the transmission mechanism of choice for battery-free devices that operate on harvested energy. However, a limitation of recent backscatter systems is that the communication range scales with the strength of the ambient carrier signal(ACS). This means that to achieve a long range, a backscatter tag needs to reflect a strong ACS, which in practice means that it needs to be close to an ACS emitter. We present TunnelScatter, a mechanism that overcomes this limitation. TunnelScatter uses a tunnel diode-based radio frequency oscillator …
Sensing-Aware Backscatter Communications: A Survey on Envelope Stability, Waveform Design, and Selection Diversity
Rochester Institute of Technology（罗切斯特理工学院）；Cisco Systems Inc.（思科系统公司）；Obafemi Awolowo University（奥巴费米·阿沃洛沃大学）；The University of Texas at Dallas（德克萨斯大学达拉斯分校）
WiFi backscatter tags can enable direct connectivity of IoT devices with commodity WiFi hardware at low power. However, most state of the art backscatter tag implementations in this area have limited transmitter to tag range, are not suitable to be deployed in a WiFi mesh network, and do not take full advantage of today's WiFi network capabilities such as MIMO. In this paper, we present BeamScatter, which can realize a backscatter tag based on MIMO techniques that can work at a very long separation of 28m from an access-point and enables their deployment in WiFi mesh networks. BeamScatter pres…
We investigate a wireless power transfer (WPT)-based backscatter-mobile edge computing (MEC) network with a {reconfigurable intelligent surface (RIS)}.In this network, wireless devices (WDs) offload task bits and harvest energy, and they can switch between backscatter communication (BC) and active transmission (AT) modes. We exploit the RIS to maximize energy efficiency (EE). To this end, we optimize the time/power allocations, local computing frequencies, execution times, backscattering coefficients, and RIS phase shifts.} This goal results in a multi-objective optimization problem (MOOP) wit…
Multiple-antenna backscatter is emerging as a promising approach to offer high communication performance for the data-intensive applications of ambient backscatter communications (AmBC). Although much has been understood about multiple-antenna backscatter in conventional backscatter communications (CoBC), existing analytical models cannot be directly applied to AmBC due to the structural differences in RF source and tag circuit designs. This paper takes the first step to fill the gap, by exploring the use of spatial modulation (SM) in AmBC whenever tags are equipped with multiple antennas. Spe…
Bistatic backscatter communication (BackCom) allows passive tags to transmit over extended ranges, but at the cost of having carrier emitters either transmitting at high powers or being deployed very close to tags. In this paper, we examine how the presence of an intelligent reflecting surface (IRS) could benefit the bistatic BackCom system. We study the transmit power minimization problem at the carrier emitter, where its transmit beamforming vector is jointly optimized with the IRS phase shifts, whilst guaranteeing a required BackCom performance. A unique feature in this system setup is the …
Ambient backscatter communication (AmBC) has been introduced to address communication and power efficiency issues for short-range and low-power Internet-of-Things (IoT) applications. On the other hand, reconfigurable intelligent surface (RIS) has been recently proposed as a promising approach that can control the propagation environment especially in indoor communication environments. In this paper, we propose a new AmBC model over ambient orthogonal-frequency-division-multiplexing (OFDM) subcarriers in the frequency domain in conjunction with RIS for short-range communication scenarios. A tag…
Symbiotic radio (SR) is emerging as a spectrum- and energy-efficient communication paradigm for future passive Internet-of-things (IoT), where some single-antenna backscatter devices, referred to as Tags, are parasitic in an active primary transmission. The primary transceiver is designed to assist both direct-link (DL) and backscatter-link (BL) communication. In multi-tags SR systems, the transceiver designs become much more complicated due to the presence of DL and inter-Tag interference, which further poses new challenges to the availability and reliability of DL and BL transmission. To ove…
In this paper, a novel reconfigurable intelligent surface (RIS)-assisted multiple-input multiple-output (MIMO) symbiotic radio (SR) system is proposed, in which an RIS, operating as a secondary transmitter (STx), sends messages to a multi-antenna secondary receiver (SRx) by using cognitive backscattering communication, and simultaneously, it enhances the primary transmission from a multi-antenna primary transmitter (PTx) to a multi-antenna primary receiver (PRx) by intelligently reconfiguring the wireless environment. We are interested in the joint design of active transmit beamformer at the P…
With the development of the next generation of mobile networks, new research challenges have emerged, and new technologies have been proposed to face them. On the one hand, the reconfigurable intelligent surface (RIS) technology is being investigated for partially controlling the wireless channels. The RIS is a promising technology for improving the signal quality by controlling the scattering of the electromagnetic waves in a nearly passive manner. On the other hand, ambient backscatter communications (AmBC) is another promising technology that is tailored for addressing the energy efficiency…
Accurate localization of a large number of objects over a wide area is one of the keys to the pervasive interaction with the Internet of Things. This paper presents Hawkeye, a new mmWave backscatter that, for the first time, offers over (i) hundred-scale simultaneous 3D localization at (ii) subcentimeter accuracy for over an (iii) hectometer distance. Hawkeye generally applies to indoors and outdoors as well as under mobility. Hawkeye tag's Van Atta Array design with retro-reflectivity in both elevation and azimuth planes offers 3D localization and effectively suppresses the multipath. Hawkeye…
A Single-Chain Backscatter Tag for Multi-Sensor Multiplexing
National University of Singapore（新加坡国立大学）；Pennsylvania State University（宾夕法尼亚州立大学）；University of Massachusetts Amherst（马萨诸塞大学阿默斯特分校）；Shanghai Jiao Tong University（上海交通大学）；Microsoft Research（微软研究院）；UT Austin（德克萨斯大学奥斯汀分校）
A long-standing vision of backscatter communications is to provide long-range connectivity and high-speed transmissions for batteryless Internet-of-Things (IoT). Recent years have seen major innovations in designing backscatters toward this goal. Yet, they either operate at a very short range, or experience extremely low throughput. This paper takes one step further toward breaking this stalemate, by presenting PolarScatter that exploits channel polarization in long-range backscatter links. We transform backscatter channels into nearly noiseless virtual channels through channel polarization, a…
With the commencement of the 5G of wireless networks, researchers around the globe have started paying their attention to the imminent challenges that may emerge in the beyond 5G (B5G) era. Various revolutionary technologies and innovative services are offered in 5G networks, which, along with many principal advantages, are anticipated to bring a boom in the number of connected wireless devices and the types of use-cases that may cause the scarcity of network resources. These challenges partly emerged with the advent of massive machine-type communications (mMTC) services, require extensive res…
The heterogenous wireless services and exponentially growing traffic call for novel spectrum- and energy-efficient wireless communication technologies. In this paper, a new technique, called symbiotic radio (SR), is proposed to exploit the benefits and address the drawbacks of cognitive radio (CR) and ambient backscattering communications(AmBC), leading to mutualism spectrum sharing and highly reliable backscattering communications. In particular, the secondary transmitter (STx) in SR transmits messages to the secondary receiver (SRx) over the RF signals originating from the primary transmitte…
Beamforming and RIS-Aided Ambient Backscatter Communications with Residual-Feature SVM Detection
Wolfson School of Mechanical, Electrical and Manufacturing Engineering, Loughborough University（拉夫堡大学沃夫森机械、电气与制造工程学院）；Loughborough University（拉夫堡大学）；East Midlands Institute of Technology, Loughborough College Group（东米德兰理工学院，拉夫堡学院集团）；Institute for Digital Technologies, Loughborough University（拉夫堡大学数字技术研究所）
