Detection of low-reflectivity objects can be enriched via the so-called quantum illumination procedure. In order that this quantum procedure outperforms classical detection protocols, entangled states of microwave radiation are initially required. In this paper, we discuss the role of Josephson Traveling Wave Parametric Amplifiers (JTWPAs), based on circuit-QED components, as suitable sources of a two-mode squeezed vacuum state, a special signal-idler entangled state. The obtained wide bandwidth makes the JTWPA an ideal candidate for generating quantum radiation in quantum metrology and information processing applications.
Superconducting parametric amplifiers have great promise for quantum-limited readout of superconducting qubits and detectors. Until recently, most superconducting parametric amplifiers had been based on resonant structures, limiting their bandwidth and dynamic range. Broadband traveling-wave parametric amplifiers based both on the nonlinear kinetic inductance of superconducting thin films and on Josephson junctions are in development. By modifying the dispersion property of the amplifier circuit, referred to as dispersion engineering, the gain can be greatly enhanced and the size can be reduce…
Detection of low-reflectivity objects can be improved by the so-called quantum illumination procedure. However, quantum detection probability exponentially decays with the source bandwidth. The Josephson Parametric Amplifiers (JPAs) technology utilized as a source, generating a pair of entangled signals called two-mode squeezed vacuum states, shows a very narrow bandwidth limiting the operation of the microwave quantum radar (MQR). In this paper, for the first time, a microwave quantum radar setup based on quantum illumination protocol and using a Josephson Traveling Wave Parametric Amplifier …
We have developed a recently proposed Josephson traveling-wave parametric amplifier with three-wave mixing [A. B. Zorin, Phys. Rev. Applied 6, 034006, 2016]. The amplifier consists of a microwave transmission line formed by a serial array of nonhysteretic one-junction SQUIDs. These SQUIDs are flux-biased in a way that the phase drops across the Josephson junctions are equal to 90 degrees and the persistent currents in the SQUID loops are equal to the Josephson critical current values. Such a one-dimensional metamaterial possesses a maximal quadratic nonlinearity and zero cubic (Kerr) nonlinear…
Simultaneous ideal quantum measurements of multiple single-photon-level signals would advance applications in quantum information processing, metrology, and astronomy, but require the first amplifier to be simultaneously broadband, quantum limited, and directional. However, conventional traveling-wave parametric amplifiers support broadband amplification at the cost of increased added noise and are not genuinely directional due to non-negligible nonlinear backward wave generation. In this work, we introduce a new class of amplifiers which encode the information in the Floquet modes of the syst…
We develop a concept of the traveling-wave Josephson parametric amplifier exploiting quadratic nonlinearity of a serial array of one-junction SQUIDs embedded in a superconducting transmission line. The external magnetic flux applied to the SQUIDs makes it possible to efficiently control the shape of their current-phase relation and, hence, the balance between quadratic and cubic (Kerr-like) nonlinearities. This property allows us to operate in the favorable three-wave-mixing mode with minimal phase mismatch, an exponential dependence of the power gain on number of sections $N$, a large bandwid…
We have fabricated a wide-bandwidth, high dynamic range, low-noise cryogenic amplifier based on a superconducting kinetic inductance traveling-wave device. The device was made from NbTiN and consisted of a long, coplanar waveguide on a silicon chip. By adding a DC current and an RF pump tone we are able to generate parametric amplification using three-wave mixing. The devices exhibit gain of more than 15 dB across an instantaneous bandwidth from 4 to 8 GHz. The total usable gain bandwidth, including both sides of the signal-idler gain region, is more than 6 GHz. The noise referred to the input…
Noise at the quantum limit over a large bandwidth is a fundamental requirement for future applications operating at millikelvin temperatures, such as the neutrino mass measurement, the next-generation x-ray observatory, the CMB measurement, the dark matter and axion detection, and the rapid high-fidelity readout of superconducting qubits. The read out sensitivity of arrays of microcalorimeter detectors, resonant axion-detectors, and qubits, is currently limited by the noise temperature and bandwidth of the cryogenic amplifiers. The DARTWARS (Detector Array Readout with Traveling Wave AmplifieR…
We developed and experimentally tested a Symmetric Traveling Wave Parametric Amplifier (STWPA) based on Three-Wave Mixing, using the new concept of a Symmetric rf- SQUID. This allows to fully control the second and third order nonlinearities of the STWPA by applying external currents. In this way, the optimal bias point can be reached, taking into account both phase mismatch and pump depletion minimization. The structure was tested at 4.2K, showing a 4GHz bandwidth and a maximum estimated gain of 17dB. STWPA showed also great flexibility, allowing up-down conversion mixer operations and rf-con…
We describe a kinetic inductance traveling-wave (KIT) amplifier suitable for superconducting quantum information measurements and characterize its wideband scattering and noise properties. We use mechanical microwave switches to calibrate the four amplifier scattering parameters up to the device input and output connectors at the dilution refrigerator base temperature and a tunable temperature load to characterize the amplifier noise. Finally, we demonstrate the high fidelity simultaneous dispersive readout of two superconducting transmon qubits. The KIT amplifier provides low-noise amplificat…
Quantum illumination is a quantum-optical sensing technique in which an entangled source is exploited to improve the detection of a low-reflectivity object that is immersed in a bright thermal background. Entangled sources between microwave and optical fields can be exploited to improve detection in microwave quantum illumination technique. We proposed a scheme to enhance the entanglement between the output fields of microwave and optical cavity by introducing optical parametric amplifier medium in cavity optomechanical system. We show that improving signal-to-noise ratio and decreasing error …
Quantum-limited microwave parametric amplifiers are genuine key pillars for rising quantum technologies and in general for applications that rely on the successful readout of weak microwave signals by adding only the minimum amount of noise allowed by quantum mechanics. In this perspective, after providing a brief overview on the different families of parametric microwave amplifiers, we focus on traveling wave parametric amplifiers (TWPAs), underlining the key achievements of the last years and the present open challenges. We discuss also possible new research directions beyond amplification s…
Traveling wave parametric amplifiers (TWPAs) have recently emerged as essential tools for broadband near quantum-limited amplification. However, their use to generate microwave quantum states still misses an experimental demonstration. In this letter, we report operation of a TWPA as a source of two-mode squeezed microwave radiation. We demonstrate broadband entanglement generation between two modes separated by up to 400 MHz by measuring logarithmic negativity between 0.27 and 0.51 and collective quadrature squeezing below the vacuum limit between 1.5 and 2.1 dB. This work opens interesting p…
We develop a quantum theory describing the input-output properties of Josephson traveling wave parametric amplifiers. This allows us to show how such a device can be used as a source of nonclassical radiation, and how dispersion engineering can be used to tailor gain profiles and squeezing spectra with attractive properties, ranging from genuinely broadband spectra to "squeezing combs" consisting of a number of discrete entangled quasimodes. The device's output field can be used to generate a multi-mode squeezed bath--a powerful resource for dissipative quantum state preparation. In particular…
Squeezing of the electromagnetic vacuum is an essential metrological technique used to reduce quantum noise in applications spanning gravitational wave detection, biological microscopy, and quantum information science. In superconducting circuits, the resonator-based Josephson-junction parametric amplifiers conventionally used to generate squeezed microwaves are constrained by a narrow bandwidth and low dynamic range. In this work, we develop a dual-pump, broadband Josephson traveling-wave parametric amplifier that combines a phase-sensitive extinction ratio of 56 dB with single-mode squeezing…
The recently proposed Josephson traveling-wave parametric amplifier (JTWPA) based on a ladder transmission line consisting of radio-frequency SQUIDs and exploiting three-wave mixing (3WM), has great potential in achieving both a gain of 20 dB and a flat bandwidth of at least 4 GHz. To realize this concept in practical amplifiers we model the advanced JTWPA circuit with periodic modulation of the circuit parameters (engineered dispersion loadings), which allow the basic mixing process, i.e., $ω_s=ω_p-ω_i$, where $ω_s$, $ω_p$, and $ω_i$ are the signal, the pump, and the idler frequencies, respec…
Most microwave readout architectures in quantum computing or sensing rely on a semiconductor amplifier at 4 K, typically a high-electron mobility transistor (HEMT). Despite its remarkable noise performance, a conventional HEMT dissipates several milliwatts of power, posing a practical challenge to scale up the number of qubits or sensors addressed in these architectures. As an alternative, we present an amplification chain consisting of a kinetic-inductance traveling-wave parametric amplifier (KI-TWPA) placed at 4 K, followed by a HEMT placed at 70 K, and demonstrate a chain-added noise $T_Σ= …
Three wave mixing vacuum squeezing generation in a SNAIL-based Traveling-Wave Parametric Amplifier with alternated flux polarity
CNR-SPIN（意大利国家研究委员会自旋物理中心）；Dipartimento di Fisica “Ettore Pancini”, Università di Napoli “Federico II,”（那不勒斯费德里科二世大学埃托雷·潘奇尼物理系）；Université Grenoble Alpes, CNRS, Grenoble INP, Institut Néel（格勒诺布尔阿尔卑斯大学）；Dipartimento di Ingegneria Civile e Meccanica (DICEM), Università di Cassino e Lazio Meridionale（卡西诺与拉齐奥南部大学土木机械工程系）；Dipartimento di Ingegneria Elettrica e delle Tecnologie dell’Informazione, Università degli Studi di Napoli Federico II（那不勒斯费德里科二世大学电气与信息技术工程系）
An amplifier combining noise performances as close as possible to the quantum limit with large bandwidth and high saturation power is highly desirable for many solid state quantum technologies such as high fidelity qubit readout or high sensitivity electron spin resonance for example. Here we introduce a new Traveling Wave Parametric Amplifier based on Superconducting QUantum Interference Devices. It displays a 3 GHz bandwidth, a -102 dBm 1-dB compression point and added noise near the quantum limit. Compared to previous state-of-the-art, it is an order of magnitude more compact, its character…
We present a theoretical model and experimental characterization of a microwave kinetic inductance traveling-wave amplifier (KIT), whose noise performance, measured by a shot-noise tunnel junction (SNTJ), approaches the quantum limit. Biased with a dc current, the KIT operates in a three-wave mixing fashion, thereby reducing by several orders of magnitude the power of the microwave pump tone and associated parasitic heating compared to conventional four-wave mixing KIT devices. It consists of a 50 Ohms artificial transmission line whose dispersion allows for a controlled amplification bandwidt…
Magnetic-Field and Temperature Limits of a Kinetic-Inductance Traveling-Wave Parametric Amplifier
University of Cologne（科隆大学）；Jet Propulsion Laboratory, California Institute of Technology（加州理工学院喷气推进实验室）；Department of Applied Physics and Materials Science, California Institute of Technology（加州理工学院应用物理与材料科学系）；JARA Institute for Quantum Information (PGI-11), Forschungszentrum Jülich（于利希研究中心JARA量子信息研究所）；Quantum Research Center, Technology Innovation Institute（技术创新研究院量子研究中心）
We present an efficient, accurate, and comprehensive analysis framework for generic, multi-port nonlinear parametric circuits, in the presence of dissipation from lossy circuit components, based on "quantum-adapted" X-parameters. We apply this method to Josephson traveling-wave parametric amplifiers (JTWPAs) - a key component in superconducting and spin qubit quantum computing architectures - which are challenging to model accurately due to their thousands of linear and nonlinear circuit components. X-parameters are generated from a harmonic balance solution of the classical nonlinear circuit …
Quantum-limited traveling-wave parametric amplifier based on DUV-defined planar structures
Swiss Federal Institute of Technology Lausanne (EPFL)（洛桑联邦理工学院）；Institute of Electrical and Micro Engineering (IEM)（电气与微电子工程研究所）；Center for Quantum Science and Engineering（量子科学与工程中心）；WithWave Co., Ltd.（WithWave有限公司）
DARTWARS (Detector Array Readout with Traveling Wave AmplifieRS) is a three years project that aims to develop high-performing innovative Traveling Wave Parametric Amplifiers (TWPAs) for low temperature detectors and qubit readout (C-band). The practical development follows two different promising approaches, one based on the Josephson junctions (TWJPA) and the other one based on the kinetic inductance of a high-resistivity superconductor (KITWPA). This paper presents the advancements made by the DARTWARS collaboration to produce a first working prototype of a KITWPA.
Coupled-Mode Equations with Arbitrary Mode Combinations for Kinetic-Inductance Superconducting Traveling-Wave Parametric Devices: Theory and Experimental Validation
National Radio Astronomy Observatory（美国国家无线电天文台）；University of Chile（智利大学）；Space Research Organization Netherlands (SRON)（荷兰空间研究组织）
We present a cryogenic microwave noise source with a characteristic impedance of 50 $Ω$, which can be installed in a coaxial line of a cryostat. The bath temperature of the noise source is continuously variable between 0.1 K and 5 K without causing significant back-action heating on the sample space. As a proof-of-concept experiment, we perform Y-factor measurements of an amplifier cascade that includes a traveling wave parametric amplifier and a commercial high electron mobility transistor amplifier. We observe system noise temperatures as low as $680^{+20}_{-200}$ mK at 5.7 GHz corresponding…
