High-fidelity qubit measurement is a critical element of all quantum computing architectures. In superconducting systems, qubits are typically measured by probing a readout resonator with a weak microwave tone that must be amplified before reaching the room temperature electronics. Superconducting parametric amplifiers have been widely adopted as the first amplifier in the chain, primarily because of their low noise performance, approaching the quantum limit. However, they require isolators and circulators to route signals up the measurement chain and to protect qubits from amplified noise. While these commercial components are wideband and simple to use, their intrinsic loss, size, and magnetic shielding requirements impact overall measurement efficiency and scalability. Here we report a parametric amplifier that achieves both broadband forward amplification and backward isolation in a single, compact, non-magnetic circuit that could be integrated on chip with superconducting qubits. The approach relies on a nonlinear transmission line that supports traveling-wave parametric amplification of forward propagating signals, and isolation via frequency conversion of backward propagating signals. This traveling-wave parametric amplifier and converter has the potential to reduce the readout hardware overhead when scaling up the size of superconducting quantum computers.
Most microwave readout architectures in quantum computing or sensing rely on a semiconductor amplifier at 4 K, typically a high-electron mobility transistor (HEMT). Despite its remarkable noise performance, a conventional HEMT dissipates several milliwatts of power, posing a practical challenge to scale up the number of qubits or sensors addressed in these architectures. As an alternative, we present an amplification chain consisting of a kinetic-inductance traveling-wave parametric amplifier (KI-TWPA) placed at 4 K, followed by a HEMT placed at 70 K, and demonstrate a chain-added noise $T_Σ= …
We describe a kinetic inductance traveling-wave (KIT) amplifier suitable for superconducting quantum information measurements and characterize its wideband scattering and noise properties. We use mechanical microwave switches to calibrate the four amplifier scattering parameters up to the device input and output connectors at the dilution refrigerator base temperature and a tunable temperature load to characterize the amplifier noise. Finally, we demonstrate the high fidelity simultaneous dispersive readout of two superconducting transmon qubits. The KIT amplifier provides low-noise amplificat…
Simultaneous ideal quantum measurements of multiple single-photon-level signals would advance applications in quantum information processing, metrology, and astronomy, but require the first amplifier to be simultaneously broadband, quantum limited, and directional. However, conventional traveling-wave parametric amplifiers support broadband amplification at the cost of increased added noise and are not genuinely directional due to non-negligible nonlinear backward wave generation. In this work, we introduce a new class of amplifiers which encode the information in the Floquet modes of the syst…
Superconducting parametric amplifiers have great promise for quantum-limited readout of superconducting qubits and detectors. Until recently, most superconducting parametric amplifiers had been based on resonant structures, limiting their bandwidth and dynamic range. Broadband traveling-wave parametric amplifiers based both on the nonlinear kinetic inductance of superconducting thin films and on Josephson junctions are in development. By modifying the dispersion property of the amplifier circuit, referred to as dispersion engineering, the gain can be greatly enhanced and the size can be reduce…
Quantum-limited microwave parametric amplifiers are genuine key pillars for rising quantum technologies and in general for applications that rely on the successful readout of weak microwave signals by adding only the minimum amount of noise allowed by quantum mechanics. In this perspective, after providing a brief overview on the different families of parametric microwave amplifiers, we focus on traveling wave parametric amplifiers (TWPAs), underlining the key achievements of the last years and the present open challenges. We discuss also possible new research directions beyond amplification s…
We develop a technique to overcome phase-mismatch in Josephson-junction traveling wave parametric amplifiers in order to achieve high gain over a broad bandwidth. Using "resonant phase matching," we design a compact superconducting device consisting of a transmission line with subwavelength resonant inclusions that simultaneously achieves a gain of 20 dB, an instantaneous bandwidth of 3 GHz, and a saturation power of -98 dBm. Such an amplifier is well-suited to cryogenic broadband microwave measurements such as the multiplexed readout of quantum coherent circuits based on superconducting, semi…
Detection of low-reflectivity objects can be enriched via the so-called quantum illumination procedure. In order that this quantum procedure outperforms classical detection protocols, entangled states of microwave radiation are initially required. In this paper, we discuss the role of Josephson Traveling Wave Parametric Amplifiers (JTWPAs), based on circuit-QED components, as suitable sources of a two-mode squeezed vacuum state, a special signal-idler entangled state. The obtained wide bandwidth makes the JTWPA an ideal candidate for generating quantum radiation in quantum metrology and inform…
We developed and experimentally tested a Symmetric Traveling Wave Parametric Amplifier (STWPA) based on Three-Wave Mixing, using the new concept of a Symmetric rf- SQUID. This allows to fully control the second and third order nonlinearities of the STWPA by applying external currents. In this way, the optimal bias point can be reached, taking into account both phase mismatch and pump depletion minimization. The structure was tested at 4.2K, showing a 4GHz bandwidth and a maximum estimated gain of 17dB. STWPA showed also great flexibility, allowing up-down conversion mixer operations and rf-con…
Detection of low-reflectivity objects can be improved by the so-called quantum illumination procedure. However, quantum detection probability exponentially decays with the source bandwidth. The Josephson Parametric Amplifiers (JPAs) technology utilized as a source, generating a pair of entangled signals called two-mode squeezed vacuum states, shows a very narrow bandwidth limiting the operation of the microwave quantum radar (MQR). In this paper, for the first time, a microwave quantum radar setup based on quantum illumination protocol and using a Josephson Traveling Wave Parametric Amplifier …
We have developed a recently proposed Josephson traveling-wave parametric amplifier with three-wave mixing [A. B. Zorin, Phys. Rev. Applied 6, 034006, 2016]. The amplifier consists of a microwave transmission line formed by a serial array of nonhysteretic one-junction SQUIDs. These SQUIDs are flux-biased in a way that the phase drops across the Josephson junctions are equal to 90 degrees and the persistent currents in the SQUID loops are equal to the Josephson critical current values. Such a one-dimensional metamaterial possesses a maximal quadratic nonlinearity and zero cubic (Kerr) nonlinear…
We present a theoretical model and experimental characterization of a microwave kinetic inductance traveling-wave amplifier (KIT), whose noise performance, measured by a shot-noise tunnel junction (SNTJ), approaches the quantum limit. Biased with a dc current, the KIT operates in a three-wave mixing fashion, thereby reducing by several orders of magnitude the power of the microwave pump tone and associated parasitic heating compared to conventional four-wave mixing KIT devices. It consists of a 50 Ohms artificial transmission line whose dispersion allows for a controlled amplification bandwidt…
Traveling wave parametric amplifiers (TWPAs) have recently emerged as essential tools for broadband near quantum-limited amplification. However, their use to generate microwave quantum states still misses an experimental demonstration. In this letter, we report operation of a TWPA as a source of two-mode squeezed microwave radiation. We demonstrate broadband entanglement generation between two modes separated by up to 400 MHz by measuring logarithmic negativity between 0.27 and 0.51 and collective quadrature squeezing below the vacuum limit between 1.5 and 2.1 dB. This work opens interesting p…
We develop a quantum theory describing the input-output properties of Josephson traveling wave parametric amplifiers. This allows us to show how such a device can be used as a source of nonclassical radiation, and how dispersion engineering can be used to tailor gain profiles and squeezing spectra with attractive properties, ranging from genuinely broadband spectra to "squeezing combs" consisting of a number of discrete entangled quasimodes. The device's output field can be used to generate a multi-mode squeezed bath--a powerful resource for dissipative quantum state preparation. In particular…
Squeezing of the electromagnetic vacuum is an essential metrological technique used to reduce quantum noise in applications spanning gravitational wave detection, biological microscopy, and quantum information science. In superconducting circuits, the resonator-based Josephson-junction parametric amplifiers conventionally used to generate squeezed microwaves are constrained by a narrow bandwidth and low dynamic range. In this work, we develop a dual-pump, broadband Josephson traveling-wave parametric amplifier that combines a phase-sensitive extinction ratio of 56 dB with single-mode squeezing…
The recently proposed Josephson traveling-wave parametric amplifier (JTWPA) based on a ladder transmission line consisting of radio-frequency SQUIDs and exploiting three-wave mixing (3WM), has great potential in achieving both a gain of 20 dB and a flat bandwidth of at least 4 GHz. To realize this concept in practical amplifiers we model the advanced JTWPA circuit with periodic modulation of the circuit parameters (engineered dispersion loadings), which allow the basic mixing process, i.e., $ω_s=ω_p-ω_i$, where $ω_s$, $ω_p$, and $ω_i$ are the signal, the pump, and the idler frequencies, respec…
We develop a concept of the traveling-wave Josephson parametric amplifier exploiting quadratic nonlinearity of a serial array of one-junction SQUIDs embedded in a superconducting transmission line. The external magnetic flux applied to the SQUIDs makes it possible to efficiently control the shape of their current-phase relation and, hence, the balance between quadratic and cubic (Kerr-like) nonlinearities. This property allows us to operate in the favorable three-wave-mixing mode with minimal phase mismatch, an exponential dependence of the power gain on number of sections $N$, a large bandwid…
We have fabricated a wide-bandwidth, high dynamic range, low-noise cryogenic amplifier based on a superconducting kinetic inductance traveling-wave device. The device was made from NbTiN and consisted of a long, coplanar waveguide on a silicon chip. By adding a DC current and an RF pump tone we are able to generate parametric amplification using three-wave mixing. The devices exhibit gain of more than 15 dB across an instantaneous bandwidth from 4 to 8 GHz. The total usable gain bandwidth, including both sides of the signal-idler gain region, is more than 6 GHz. The noise referred to the input…
Noise at the quantum limit over a large bandwidth is a fundamental requirement for future applications operating at millikelvin temperatures, such as the neutrino mass measurement, the next-generation x-ray observatory, the CMB measurement, the dark matter and axion detection, and the rapid high-fidelity readout of superconducting qubits. The read out sensitivity of arrays of microcalorimeter detectors, resonant axion-detectors, and qubits, is currently limited by the noise temperature and bandwidth of the cryogenic amplifiers. The DARTWARS (Detector Array Readout with Traveling Wave AmplifieR…
An amplifier combining noise performances as close as possible to the quantum limit with large bandwidth and high saturation power is highly desirable for many solid state quantum technologies such as high fidelity qubit readout or high sensitivity electron spin resonance for example. Here we introduce a new Traveling Wave Parametric Amplifier based on Superconducting QUantum Interference Devices. It displays a 3 GHz bandwidth, a -102 dBm 1-dB compression point and added noise near the quantum limit. Compared to previous state-of-the-art, it is an order of magnitude more compact, its character…
We present an efficient, accurate, and comprehensive analysis framework for generic, multi-port nonlinear parametric circuits, in the presence of dissipation from lossy circuit components, based on "quantum-adapted" X-parameters. We apply this method to Josephson traveling-wave parametric amplifiers (JTWPAs) - a key component in superconducting and spin qubit quantum computing architectures - which are challenging to model accurately due to their thousands of linear and nonlinear circuit components. X-parameters are generated from a harmonic balance solution of the classical nonlinear circuit …
Microwave parametric amplifiers based on Josephson junctions have become a key component of many quantum information experiments. One key limitation which has not been well predicted by theory is the gain saturation behavior which determines its ability to process large amplitude signals. The typical explanation for this behavior in phase-preserving amplifiers based on three-wave mixing is pump depletion, in which the consumption of pump photons to produce amplification results in a reduction in gain. However, in this work we present experimental data and theoretical calculations showing that …
Quantum-limited traveling-wave parametric amplifier based on DUV-defined planar structures
Swiss Federal Institute of Technology Lausanne (EPFL)（洛桑联邦理工学院）；Institute of Electrical and Micro Engineering (IEM)（电气与微电子工程研究所）；Center for Quantum Science and Engineering（量子科学与工程中心）；WithWave Co., Ltd.（WithWave有限公司）
Magnetic-Field and Temperature Limits of a Kinetic-Inductance Traveling-Wave Parametric Amplifier
University of Cologne（科隆大学）；Jet Propulsion Laboratory, California Institute of Technology（加州理工学院喷气推进实验室）；Department of Applied Physics and Materials Science, California Institute of Technology（加州理工学院应用物理与材料科学系）；JARA Institute for Quantum Information (PGI-11), Forschungszentrum Jülich（于利希研究中心JARA量子信息研究所）；Quantum Research Center, Technology Innovation Institute（技术创新研究院量子研究中心）
Optimizing Pump Conditions of Parametric Amplifiers for Fast Multiplexed Readout of Superconducting Qubits
Quantum Machines Inc.（量子机器公司）；IQCC（以色列量子计算中心）；SKKU Advanced Institute of Nanotechnology, Sungkyunkwan University（成均馆大学SKKU纳米技术高等研究院）；Department of Quantum Information Engineering, Sungkyunkwan University（成均馆大学量子信息工程系）
California Institute of Technology（加州理工学院）；National Institute of Standards and Technology（美国国家标准与技术研究院）；University of Colorado, Boulder（科罗拉多大学博尔德分校）；University of Milano-Bicocca（米兰比可卡大学）
In the previous paper [M. Tsang, Phys. Rev. A 81, 063837 (2010), e-print arXiv:1003.0116], I proposed a quantum model of a cavity electro-optic modulator, which can coherently couple an optical cavity mode to a microwave resonator mode and enable novel quantum operations on the two modes, including laser cooling of the microwave mode, electro-optic entanglement, and backaction-evading optical measurement of a microwave quadrature. In this sequel, I focus on the quantum input-output relations between traveling optical and microwave fields coupled to a cavity electro-optic modulator. With red-si…
