This letter proposes a new control strategy for wind turbine generators to decide the necessity of switches between the normal operation and frequency support modes. The idea is to accurately predict an unsafe frequency response using a differential transformation method right after power imbalance is detected so as to adaptively activate a frequency support mode only when necessary. This control strategy can effectively avoid unnecessary switches with a conventional use of deadband but still ensure adequate frequency response.
Wind turbines are prone to structural degradation, particularly in offshore locations. Based on the structural health condition of the tower, power de-rating strategies can be used to reduce structural loads at the cost of power losses.This paper introduces a novel closed-loop switching control architecture to constrain the thrust in individual turbines. By taking inspiration from developments in the field of reference governors, an existing demanded power tracking controller is extended by a thrust tracking controller. The latter is activated only when a user-defined constraint on fore-aft th…
This paper addresses the problem of control of a twin wind turbine which is subject to an electrical fault affecting only one stator phase of one turbine. An active fault tolerant control is proposed. The performance and robustness of the proposed control, comparing to a passive fault tolerant one developed in the literature, are shown through numerical simulations.
Active power control regulates the total power generated by wind farms with the power consumed on the electricity grid. Due to wake effects, the available power is reduced and turbulence is increased at downstream wind turbines. Such effects lead to a design challenge for wind farm control, where the delicate balance between supply and demand should be maintained, while considering the load balancing in the wind turbine structures. We propose a control architecture based on simple feedback controllers that adjusts the demanded power set points of individual wind turbines to compensate for turb…
The thrust for increased rating capacity of wind turbines has resulted into larger generators, longer blades, and taller towers. Presently, up to 16 MW wind turbines are being offered by wind turbines manufacturers which is nearly a 60 percent increase in the design capacity over the last five years. Manufacturing of these turbines involves assembling of gigantic sized components. Due to the frequent design changes and the variety of tasks involved, conventional automation is not possible making it a labor-intensive activity. However the handling and assembling of large components are challeng…
Based on a series of two experimental campaigns testing advanced controllers on a scaled wind turbine operating in a wind tunnel, this contribution describes the overall experimental method, challenges faced, lessons learned, and opportunities for future work. The two campaigns, run in Fall 2018 and Fall 2019, tested unconstrained and constrained optimal blade pitch controllers, respectively, using preview disturbance measurements of the oncoming wind. Specifically, the first study considered an extension to the linear-quadratic regulator to include feedforward action, while the second deploye…
Wind turbines may experience local weather perturbation, which is not taken into account by the commonly-used wind turbine simulation packages. Without this information, it is extremely challenging to evaluate the controller performance with regard to the effect of the variation of local atmospheric conditions. On the other side, it is too late and costly to wait until field test time. To fill this gap, in this paper, we develop a control-oriented turbine dynamic simulation framework to evaluate the controller performance considering the perturbation of local atmospheric conditions. This goal …
The use of state estimation technique offers a means of inferring the rotor-effective wind speed based upon solely standard measurements of the turbine. For the ease of design and computational concerns, such estimators are typically built based upon simplified turbine models that characterise the turbine with rigid blades. Large model mismatch, particularly in the power coefficient, could lead to degradation in estimation performance. Therefore, in order to effectively reduce the adverse impact of parameter uncertainties in the estimator model, this paper develops a wind sped estimator based …
In this paper, the highly acknowledged advantages of the Model Predictive Control (MPC) approach are utilized to regulate the wind turbines' output power in the partial load region. In this region, the purpose of the designed controller is to capture maximum power from the wind. When the wind speed is above rated wind speed (full load region), control strategy is to keep output power and generator speed at their rated value. Because of the wind turbine's nonlinearities and constraints of the variables this is a challenging problem and two MPC-based methods are proposed, i.e. online and offline…
With the exploitation of wind power, more turbines will be deployed at remote areas possibly with harsh working conditions (e.g., offshore wind farm). The adverse working environment may lead to massive operating and maintenance costs of turbines. Deploying unmanned aerial vehicles (UAVs) for turbine inspection is considered as a viable alternative to manual inspections. An important objective of automated UAV inspection is to minimize the flight time of the UAVs to inspect all the turbines. A first contribution of this paper is thus formulating an optimization problem to compute the optimal r…
The operation and maintenance costs of wind parks make up a major fraction of a park's overall lifetime costs. They also include opportunity costs of lost revenue from avoidable power generation underperformance. We present a machine-learning based decision support method that minimizes these opportunity costs. By analyzing the stream of telemetry sensor data from the turbine operation, estimating highly accurate power reference relations and benchmarking, we can detect performance-related operational faults in a turbine- and site-specific manner. The most accurate power reference model is sel…
Recent years have seen an unprecedented growth in the use of sensor data to guide wind farm operations and maintenance. Emerging sensor-driven approaches typically focus on optimal maintenance procedures for single turbine systems, or model multiple turbines in wind farms as single component entities. In reality, turbines are composed of multiple components that dynamically interact throughout their lifetime. These interactions are central for realistic assessment and control of turbine failure risks. In this paper, an integrated framework that combines i) real-time degradation models used for…
Floating offshore wind turbines allow wind energy to be harvested in deep waters. However, additional dynamics and structural loads may result when the floating platform is being excited by wind and waves. In this work, the conventional wind turbine controller is complemented with a novel linear feedforward controller based on wave measurements. The objective of the feedforward controller is to attenuate rotor speed variations caused by wave forcing. To design this controller, a linear model is developed that describes the system response to incident waves. The performance of the feedback-feed…
Wind turbine condition monitoring based on intra- and inter-farm federated learning
Bern University of Applied Sciences, School of Engineering（伯恩应用科学大学工程学院）；Università della Svizzera italiana, Faculty of Informatics（瑞士联合大学信息学院）；Delft University of Technology, Department of Geoscience（代尔夫特理工大学地质学院）；Remote Sensing, Stevinweg 1, 2628 Delft, The Netherlands（遥感学院，Stevinweg 1，2628 Delft，荷兰）
With increased wind power penetration in modern power systems, wind plants are required to provide frequency support similar to conventional plants. However, for the existing frequency regulation scheme of wind turbines, the control gains in the auxiliary frequency controller are difficult to set because of the compromise of the frequency regulation performance and the stable operation of wind turbines, especially when the wind speed remains variable. This paper proposes a novel frequency regulation scheme (FRS) for de-loaded wind turbines. Instead of an auxiliary frequency controller, frequen…
Improving wind turbine efficiency is essential for reducing the costs of energy production. The highly nonlinear dynamics of the wind turbines and their uncertain operating conditions have posed many challenges for their control methods. In this work, a robust control strategy based on sliding mode and adaptive fuzzy disturbance observer is proposed for speed tracking in a variable speed wind turbine. First, the nonlinear mathematical model that describes the dynamics of the variable speed wind turbine is derived. This nonlinear model is then used to derive the control methodology and to find …
With steadily increasing wind turbine penetration, regulatory standards for grid interconnection are evolving to require that wind generation systems ride-through disturbances such as faults and support the grid during such events. Conventional modifications to the doubly fed induction generation (DFIG) architecture for providing ride-through result in limited control of the turbine shaft and grid current during fault events. A DFIG architecture in which the grid side converter is connected in series as opposed to parallel with the grid connection has shown improved low voltage ride through bu…
In this manuscript, an image analytics based deep learning framework for wind turbine blade surface damage detection is proposed. Turbine blade(s) which carry approximately one-third of a turbine weight are susceptible to damage and can cause sudden malfunction of a grid-connected wind energy conversion system. The surface damage detection of wind turbine blade requires a large dataset so as to detect a type of damage at an early stage. Turbine blade images are captured via aerial imagery. Upon inspection, it is found that the image dataset was limited and hence image augmentation is applied t…
This paper presents developed real-time simulation models for offshore wind turbine generators in compliance with industry standards. The critical control functions such as negative sequence injection, sequence current limit, voltage ride through, and power curtailments are designed to meet the industry requirements for future electromagnetic transient (EMT) testing and controls of offshore wind farms. Average-value and switching detailed models are developed in the Opal-RT real-time simulator. Real-time capabilities of these models are compared to show the effectiveness of the average-value m…
WAKE-NET: A 3D-Wake-Aware Economic Turbine Layout and Cabling Optimization Framework for Multi-Capacity Multi-Hub-Height Wind Farms Serving Grid-Scale and Industrial Power Systems
The extreme loads experienced by the wind turbine in the extreme wind events are critical for the evaluation of structural reliability. Hence, the load alleviation control methods need to be designed and deployed to reduce the adverse effects of extreme wind events. This work demonstrates that the extreme loads are highly correlated to wind conditions such as turbulence-induced wind shears. Based on this insight, this work proposes a turbulence-based load alleviation control strategy for adapting the controller to changes in wind condition. The estimation of the rotor averaged wind shear based…
This paper proposes a novel integrated multiport bidirectional back-to-back power converter for a type-4 wind turbine that accommodates a battery and supercapacitor for energy storage. The circuit topology reduces 4 switches compared to the traditional configuration. Moreover, owing to the dual-buck structure embedded in the phase leg, the circuitry has no short-circuit path, therefore it withstands short-circuited events for a much longer time than the normal phase-leg and prevents the reverse current in turn-off recovery. The use of a hybrid energy storage system with battery and supercapaci…
The wind energy industry has been experiencing tremendous growth and confronting the failures of wind turbine components. Wind turbine gearbox malfunctions are particularly prevalent and lead to the most prolonged downtime and highest cost. This paper presents a data-driven gearbox fault detection algorithm base on high frequency vibration data using graph neural network (GNN) models and sparse filtering (SF). The approach can take advantage of the comprehensive data sources and the complicated sensing networks. The GNN models, including basic graph neural networks, gated graph neural networks…
Wind turbine (WT) controllers are often geared towards maximum power extraction, while suitable operating constraints should be guaranteed such that WT components are protected from failures. Control strategies can be also devised to reduce the generated power, for instance to track a power reference provided by the grid operator. They are called down-regulation strategies and allow to balance power generation and grid loads, as well as to provide ancillary grid services, such as frequency regulation. Although this balance is limited by the wind availability and grid demand, the quality of win…
Dynamic induction control is a wind farm flow control strategy that utilises wind turbine thrust variations to accelerate breakdown of the aerodynamic wake and improve downstream turbine performance. However, when floating wind turbines are considered, additional dynamics and challenges appear that make optimal control difficult. In this work, we propose an adjoint optimisation framework for non-linear economic model-predictive control, which utilises a novel coupling of an existing aerodynamic wake model to floating platform hydrodynamics. Analysis of the frequency response for the coupled mo…
Optimising wind turbine performance involves maximising energy harvesting while seeking to minimise load fatigues on the tower structure, blades and rotor. To improve turbine control performance, wind preview measurement technologies such as Light Detection And Ranging (LIDAR) have been a point of interest for researchers in recent years. In this paper, we explore the application of a classical control methodology known as Exact Output Regulation (EOR) for improving the control performance of a LIDAR-enhanced wind turbine. The EOR controller is designed to achieve the rejection of known input …
Individual Pitch Control (IPC) is an effective and widely-used strategy to mitigate blade loads in wind turbines. However, conventional IPC fails to cope with blade and actuator faults, and this situation may lead to an emergency shutdown and increased maintenance costs. In this paper, a Fault-Tolerant Individual Pitch Control (FTIPC) scheme is developed to accommodate these faults in Floating Offshore Wind Turbines (FOWTs), based on a Subspace Predictive Repetitive Control (SPRC) approach. To fulfill this goal, an online subspace identification paradigm is implemented to derive a linear appro…
Although variable-speed three-blade wind turbines are nowadays quite popular, their control remains a challenging task. We propose a new easily implementable model-free control approach with the corresponding intelligent controllers. Several convincing computer simulations, including some fault accommodations, shows that model-free controllers are more efficient and robust than classic proportional-integral controllers.
The cost of wind energy can be reduced by controlling the power reference of a turbine to increase energy capture, while maintaining load and generator speed constraints. We apply standard torque and pitch controllers to the direct inputs of the turbine and use their set points to change the power output and reduce generator speed and blade load transients. A power reference controller increases the power output when conditions are safe and decreases it when problematic transient events are expected. Transient generator speeds and blade loads are estimated using a gust measure derived from a w…
Designing a floating offshore wind turbine (FOWT) controller requires solving engineering challenges not found for fixed-bottom turbines. This paper applies several methods from the growing body of FOWT control literature to the 10-MW Ultraflexible Smart FLoating Offshore Wind Turbine (USFLOWT) baseline generator-speed controller. USFLOWT aims to reduce capital expenses using the lightweight SpiderFLOAT platform, a novel smart floating substructure with built-in distributed actuators for direct platform tilt and heave control. In this work, the USFLOWT baseline controller is improved through d…
This study focuses on the numerical analysis and optimal control of vertical-axis wind turbines (VAWT) using Bayesian reinforcement learning (RL). We specifically address small-scale wind turbines, which are well-suited to local and compact production of electrical energy on a small scale, such as urban and rural infrastructure installations. Existing literature concentrates on large scale wind turbines which run in unobstructed, mostly constant wind profiles. However urban installations generally must cope with rapidly changing wind patterns. To bridge this gap, we formulate and implement an …
Dynamic wind farm control is a new strategy that aims to apply time-varying, often periodic, control signals on upstream wind turbines to increase the wake mixing behind the turbine. As a result, wake recovery is accelerated, leading to a higher power production of downstream turbines. As the amount of interest in dynamic control strategies for wind turbines in a wind farm is increasing, different approaches are being proposed. One such novel approach is called Dynamic Individual Pitch Control (DIPC). In DIPC, each blade pitch angle of a turbine is controlled independently to dynamically manip…
Wind farm control using dynamic concepts is a research topic that is receiving an increasing amount of interest. The main concept of this approach is that dynamic variations of the wind turbine control settings lead to higher wake turbulence, and subsequently faster wake recovery due to increased mixing. As a result, downstream turbines experience higher wind speeds, thus increasing their energy capture. The current state of the art in dynamic wind farm control is to vary the magnitude of the thrust force of an upstream turbine. Although very effective, this approach also leads to increased po…
