In this manuscript, an image analytics based deep learning framework for wind turbine blade surface damage detection is proposed. Turbine blade(s) which carry approximately one-third of a turbine weight are susceptible to damage and can cause sudden malfunction of a grid-connected wind energy conversion system. The surface damage detection of wind turbine blade requires a large dataset so as to detect a type of damage at an early stage. Turbine blade images are captured via aerial imagery. Upon inspection, it is found that the image dataset was limited and hence image augmentation is applied to improve blade image dataset. The approach is modeled as a multi-class supervised learning problem and deep learning methods like Convolutional neural network (CNN), VGG16-RCNN and AlexNet are tested for determining the potential capability of turbine blade surface damage.
The cost of wind energy can be reduced by controlling the power reference of a turbine to increase energy capture, while maintaining load and generator speed constraints. We apply standard torque and pitch controllers to the direct inputs of the turbine and use their set points to change the power output and reduce generator speed and blade load transients. A power reference controller increases the power output when conditions are safe and decreases it when problematic transient events are expected. Transient generator speeds and blade loads are estimated using a gust measure derived from a w…
Modern wind turbine control algorithms typically utilize rotor effective wind speed measured from an anemometer on the turbine's nacelle. Unfortunately, the measured wind speed from such a single measurement point does not give a good representation of the effective wind speed over the blades, as it does not take the varying wind condition within the entire rotor area into account. As such, Blade Effective Wind Speed (BEWS) estimation can be seen as a more accurate alternative. This paper introduces a novel Subspace Predictive Repetitive Estimator (SPRE) approach to estimate the BEWS using bla…
The current government's goal is the realization of an even distribution of the electrification ratio in Indonesia. However, in 2018 the electrification ratio in Nusa Tenggara Timur (NTT) only reached 62.07%. One of the solutions offered is the implementation of a Bladeless Wind Turbine (BWT). BWT is a type of wind power plant that can work optimally in areas with low wind speeds, 3 to 8 m/s, which is still above the NTT average wind speed, 2.3 m/s. This study aims to optimize the mechanical design of BWT with shape and size parameters based on the manipulation of the coefficient of friction t…
Individual Pitch Control (IPC) is an effective and widely-used strategy to mitigate blade loads in wind turbines. However, conventional IPC fails to cope with blade and actuator faults, and this situation may lead to an emergency shutdown and increased maintenance costs. In this paper, a Fault-Tolerant Individual Pitch Control (FTIPC) scheme is developed to accommodate these faults in Floating Offshore Wind Turbines (FOWTs), based on a Subspace Predictive Repetitive Control (SPRC) approach. To fulfill this goal, an online subspace identification paradigm is implemented to derive a linear appro…
The operation and maintenance costs of wind parks make up a major fraction of a park's overall lifetime costs. They also include opportunity costs of lost revenue from avoidable power generation underperformance. We present a machine-learning based decision support method that minimizes these opportunity costs. By analyzing the stream of telemetry sensor data from the turbine operation, estimating highly accurate power reference relations and benchmarking, we can detect performance-related operational faults in a turbine- and site-specific manner. The most accurate power reference model is sel…
Individual Pitch Control (IPC) is an effective control strategy to mitigate the blade loads on large-scale wind turbines. Since IPC usually requires high pitch actuation, the safety constraints of the pitch actuator should be taken into account when designing the controller. This paper introduces a constrained Subspace Predictive Repetitive Control (SPRC) approach, which considers the limitation of blade pitch angle and pitch rate. To fulfill this goal, a model predictive control scheme is implemented in the fully data-driven SPRC approach to incorporate the physical limitations of the pitch a…
Although variable-speed three-blade wind turbines are nowadays quite popular, their control remains a challenging task. We propose a new easily implementable model-free control approach with the corresponding intelligent controllers. Several convincing computer simulations, including some fault accommodations, shows that model-free controllers are more efficient and robust than classic proportional-integral controllers.
The thrust for increased rating capacity of wind turbines has resulted into larger generators, longer blades, and taller towers. Presently, up to 16 MW wind turbines are being offered by wind turbines manufacturers which is nearly a 60 percent increase in the design capacity over the last five years. Manufacturing of these turbines involves assembling of gigantic sized components. Due to the frequent design changes and the variety of tasks involved, conventional automation is not possible making it a labor-intensive activity. However the handling and assembling of large components are challeng…
The estimation of the rotor effective wind speed is used in modern wind turbines to provide advanced power and load control capabilities. However, with the ever increasing rotor sizes, the wind field over the rotor surface shows a higher degree of spatial variation. A single effective wind speed estimation therefore limits the attainable levels of load mitigation, and the estimation of the Blade Effective Wind Speed (BEWS) might present opportunities for improved load control. This letter introduces two novel BEWS estimator approaches: A Proportional Integral Notch (PIN) estimator based on ind…
Dynamic wind farm control is a new strategy that aims to apply time-varying, often periodic, control signals on upstream wind turbines to increase the wake mixing behind the turbine. As a result, wake recovery is accelerated, leading to a higher power production of downstream turbines. As the amount of interest in dynamic control strategies for wind turbines in a wind farm is increasing, different approaches are being proposed. One such novel approach is called Dynamic Individual Pitch Control (DIPC). In DIPC, each blade pitch angle of a turbine is controlled independently to dynamically manip…
The use of state estimation technique offers a means of inferring the rotor-effective wind speed based upon solely standard measurements of the turbine. For the ease of design and computational concerns, such estimators are typically built based upon simplified turbine models that characterise the turbine with rigid blades. Large model mismatch, particularly in the power coefficient, could lead to degradation in estimation performance. Therefore, in order to effectively reduce the adverse impact of parameter uncertainties in the estimator model, this paper develops a wind sped estimator based …
Based on a series of two experimental campaigns testing advanced controllers on a scaled wind turbine operating in a wind tunnel, this contribution describes the overall experimental method, challenges faced, lessons learned, and opportunities for future work. The two campaigns, run in Fall 2018 and Fall 2019, tested unconstrained and constrained optimal blade pitch controllers, respectively, using preview disturbance measurements of the oncoming wind. Specifically, the first study considered an extension to the linear-quadratic regulator to include feedforward action, while the second deploye…
University of Bradford（布拉德福德大学）；University of Hull（赫尔大学）；University of Sheffield（谢菲尔德大学）
The offshore wind energy is increasingly becoming an attractive source of energy due to having lower environmental impact. Effective operation and maintenance that ensures the maximum availability of the energy generation process using offshore facilities and minimal production cost are two key factors to improve the competitiveness of this energy source over other traditional sources of energy. Condition monitoring systems are widely used for health management of offshore wind farms to have improved operation and maintenance. Reliability of the wind farms are increasingly being evaluated to a…
