On behalf of the ATLAS and Medipix-2 Collaborations. Contribution to IPRD13, 7-10 October 2013, Siena, Italy. To be published in the proceedings by JINST. 10 pages, 8 figures
ATLAS-MPX探测器基于欧洲核子研究中心设计的Medipix 2硅器件,用于探测多种类型的辐射。2008年至2013年,16个这样的探测器在LHC的ATLAS探测器中成功运行,并独立于ATLAS数据记录链收集数据。每个ATLAS-MPX探测器提供单独的测量聚束集成LHC光度。亮度监测的内部一致性约为2%。此外,靠近光束的MPX设备足够灵敏,可以在van der Meer校准扫描期间提供相对光度测量,其低光度范围低于基于ATLAS热量计的聚束积分光度计的灵敏度。这些光度研究的初步结果是针对2012年在sqrt(s)=8 TeV质子-质子碰撞中获得的数据。
英文摘要:
The ATLAS-MPX detectors are based on the Medipix2 silicon devices designed by CERN for the detection of multiple types of radiation. Sixteen such detectors were successfully operated in the ATLAS detector at the LHC and collected data independently of the ATLAS data-recording chain from 2008 to 2013. Each ATLAS-MPX detector provides separate measurements of the bunch-integrated LHC luminosity. An internal consistency for luminosity monitoring of about 2% was demonstrated. In addition, the MPX devices close to the beam are sensitive enough to provide relative-luminosity measurements during van der Meer calibration scans, in a low-luminosity regime that lies below the sensitivity of the ATLAS calorimeter-based bunch-integrating luminometers. Preliminary results from these luminosity studies are presented for 2012 data taken at sqrt(s)=8 TeV proton-proton collisions.
一个由16个Medipix-2(MPX)硅像素设备组成的网络安装在欧洲核子研究中心的ATLAS探测器洞穴中。它被设计用于测量ATLAS实验及其周围环境中辐射场的组成和光谱特性。这项研究表明,MPX网络也可以作为一个自给自足的光度监测系统。MPX探测器独立于ATLAS数据记录链收集数据,因此它们提供了对ATLAS/LHC束团集成光度的独立测量。特别是,位于距离主要相互作用点足够近的MPX探测器用于执行高精度的van der Meer校准扫描。来自光度监测的结果是针对2012年在sqrt(s)= 8 TeV质子-质子碰撞时采集的数据。研究了LHC亮度降低率的特性,并对束-束(燃尽)和束-气(单束团)相互作用的影响进行了评价。在MPX光度测量中观察到的系统变化在一分钟间隔内低于0.3%。
A monitoring and control test bench for assessing the upgraded low voltage power supplies for the ATLAS Tile Calorimeter Phase-II Upgrade front-end electronics
Tile Computer-on-Module for the ATLAS Tile Calorimeter Phase-II upgrades
瓦片预处理器(TilePPr)是高亮度大型强子对撞机(HL-LHC)瓦片量热计(TileCal)探测器外电子学的核心元件。TilePPr包括基于FPGA的板,用于操作和读取TileCal探测器上的电子器件。Tile Computer on Module(TileCoM)夹层嵌入在TilePPr中,实现三个主要功能。这些包括远程配置探测器上的电子设备和TilePPr FPGA,将TilePPr与ATLAS触发和数据采集(TDAQ)系统连接,以及通过提供监测数据将TilePPr与ATLAS探测器控制系统(DCS)连接。TileCoM是一款10层板,配有用于处理数据的Zynq UltraScale+ ZU 2CG、与TilePPr集成的接口组件以及连接到高级电信计算架构载体的电源。CentOS嵌入式Linux部署在TileCoM上,以实现HL-LHC所需的功能。本文从远程编程、与ATLAS TDAQ系统和DCS系统的接口等方面介绍了TileCoM系统的硬件和固件开发。
Characterisation of the Thermoflow due to the Dry Nitrogen Flushing Scheme in the ATLAS Inner Tracker using Computational Fluid Dynamics
University of Pretoria(比勒陀利亚大学);University of Johannesburg(约翰内斯堡大学);University of KwaZulu-Natal(夸祖鲁-纳塔尔大学);SLAC National Accelerator Laboratory(斯坦福直线加速器中心);Nikhef, National Institute for Subatomic Physics(荷兰亚原子物理国家研究所)
Surface Commissioning and Performance of the sMDT Muon Chambers for the ATLAS HL-LHC Upgrade
University of Michigan(密歇根大学);Max Planck Institute for Physics(马克斯·普朗克物理研究所);Tufts University(塔夫茨大学);Chinese University of Hong Kong(香港中文大学);Michigan State University(密歇根州立大学);University of Science and Technology of China(中国科学技术大学)
Deep Diffused Avalanche Photodiodes for Charged Particles Timing
高亮度LHC(HL-LHC)的ATLAS和CMS的升级突出了物理对象计时作为解决束流交叉内主要相互作用的工具。由于预期的堆积是200左右,与r.m.s. 180 ps的时间扩展,需要大约30 ps的时间分辨率。对于桶和端盖区域,定时探测器将分别经历大约$Φ_{eq}=10^{14}$和$10^{15}$ cm $^{-2}$的1 MeV中子当量注量。在这方面的贡献,深扩散雪崩光电二极管(APD)的辐射监测设备生产的检查作为候选人的HL-LHC应用程序的定时探测器。为了提高探测器的定时性能,APD用于直接探测穿越的粒子,而不需要产生光的辐射体介质。具有$8\times8$ mm $^2$的有效面积的器件在射束测试中表征。使用光束望远镜和微通道板光电倍增管(MCP-PMT)测量作为检测器上的位置的函数的定时性能和信号特性。使用具有$2\times2$ mm $^2$的有效面积的器件来确定辐射损伤的影响,并使用ps脉冲激光来表征。这些探测器用高达$Φ_{eq}=10^{15}$ cm $^{-2}$的中子辐照。