In this contribution we describe the hardware, firmware and software components of the readout system of the MAGIC-II Cherenkov telescope on the Canary island La Palma. The PMT analog signals are transmitted by means of optical fibers from the MAGIC-II camera to the 80 m away counting house where they are routed to the new high bandwidth and fully programmable receiver boards (MONSTER), which convert back the signals from optical to electrical ones. Then the signals are split, one half provide the input signals for the level ONE trigger system while the other half is sent to the digitizing units. The fast Cherenkov pulses are sampled by low-power Domino Ring Sampler chips (DRS2) and temporarily stored in an array of 1024 capacitors. Signals are sampled at the ultra-fast speed of 2 GSample/s, which allows a very precise measurement of the signal arrival times in all pixels. They are then digitized with 12-bit resolution by an external ADC readout at 40 MHz speed. The Domino samplers are integrated in the newly designed mezzanines which equip a set of fourteen multi-purpose PULSAR boards. Finally, the data are sent through an S-LINK optical interface to a single computer. The entire DAQ hardware is controlled through a VME interface and steered by the slow control software program (MIR). The Data AcQuisition software program (DAQ) proceeds finally to the event building and data storage.
Imaging Atmospheric Cherenkov Telescopes (IACTs) currently in operation feature large mirrors and order of 1 ns time response to signals of a few photo-electrons produced by optical photons. This means that they are ideally suited for optical interferometry observations. Thanks to their sensitivity to visible wavelengths and long baselines optical intensity interferometry with IACTs allows reaching angular resolutions of tens to microarcsec. We have installed a simple optical setup on top of the cameras of the two 17 m diameter MAGIC IACTs and observed coherent fluctuations in the photon inten…
The Major Atmospheric Gamma Imaging Cherenkov (MAGIC) telescope system consists of two imaging atmospheric Cherenkov telescopes (IACTs) and is located on the Canary island of La Palma. IACTs are excellent tools to inspect the very-high-energy (few tens of GeV and above) gamma-ray sky by capturing images of the air showers, originated by the absorption of gamma rays and cosmic rays by the atmosphere, through the detection of Cherenkov photons emitted in the shower. One of the main factors determining the sensitivity of IACTs to gamma-ray sources, in general, is how well reconstructed the proper…
The Cherenkov Telescope Array (CTA) is the next-generation ground-based very-high-energy gamma-ray observatory. The Large-Sized Telescope (LST) of CTA is designed to detect gamma rays between 20 GeV and a few TeV with a 23-meter diameter mirror. We have developed the focal plane camera of the first LST, which has 1855 photomultiplier tubes (PMTs) and the readout system which samples a PMT waveform at GHz with switched capacitor arrays, Domino Ring Sampler ver4 (DRS4). To measure the precise pulse charge and arrival time of Cherenkov signals, we developed a method to calibrate the output voltag…
MAGIC is a system of two imaging atmospheric Cherenkov telescopes (IACTs) located on the Canary island of La Palma. Each telescope's imaging camera consists of 1039 photomultiplier tubes (PMTs). We developed three detector modules based on silicon photomultipliers (SiPMs) of seven pixels each that are mechanically and electronically compatible with those used in the MAGIC camera. These prototype modules are installed next to the PMTs in the imaging camera and are operated in parallel. To achieve a similar active area per pixel we used seven to nine SiPMs for producing a composite pixel. The Si…
The Cherenkov Telescope Array (CTA) is a forthcoming international ground-based observatory for very high-energy gamma rays. Its goal is to reach sensitivity five to ten times better than existing Cherenkov telescopes such as VERITAS, H.E.S.S. or MAGIC and extend the range of observation to energies down to few tens of GeV and beyond 100 TeV. To achieve this goal, an array of about 100 telescopes is required, meaning a total reflective surface of several thousands of square meters. Thence, the optimal technology used for CTA mirrors manufacture should be both low-cost (~1000 euros/m2) and allo…
The Major Atmospheric Gamma Imaging Cherenkov (MAGIC) telescope system is located on the Canary Island of La Palma and inspects the very high-energy (VHE, few tens of GeV and above) gamma-ray sky. MAGIC consists of two imaging atmospheric Cherenkov telescopes (IACTs), which capture images of the air showers originating from the absorption of gamma rays and cosmic rays by the atmosphere, through the detection of Cherenkov photons emitted in the shower. The sensitivity of IACTs to gamma-ray sources is mainly determined by the ability to reconstruct the properties (type, energy, and arrival direc…
The Cherenkov Telescope Array (CTA) will be the next generation gamma-ray observatory, which will consist of three kinds of telescopes of different sizes. Among those, the Large Size Telescope (LST) will be the most sensitive in the low energy range starting from 20 GeV. The prototype LST (LST-1) proposed for CTA was inaugurated in October 2018 in the northern hemisphere site, La Palma (Spain), and is currently in its commissioning phase. MAGIC is a system of two gamma-ray Cherenkov telescopes of the current generation, located approximately 100 m away from LST-1, that have been operating in s…
The first Large Size Telescope (LST-1) of the Cherenkov Telescope Array has been operational since October 2018 at La Palma, Spain. We report on the results obtained during the camera commissioning. The noise level of the readout is determined as a 0.2 p.e. level. The gain of PMTs are well equalized within 2\% variation, using the calibration flash system. The effect of the night sky background on the signal readout noise as well as the PMT gain estimation are also well evaluated. Trigger thresholds are optimized for the lowest possible gamma-ray energy threshold and the trigger distribution s…
FlashCam is a Cherenkov camera development project centered around a fully digital trigger and readout scheme with smart, digital signal processing, and a "horizontal" architecture for the electromechanical implementation. The fully digital approach, based on commercial FADCs and FPGAs as key components, provides the option to easily implement different types of triggers as well as digitization and readout scenarios using identical hardware, by simply changing the firmware on the FPGAs. At the same time, a large dynamic range and high resolution of low-amplitude signals in a single readout cha…
The detection of astrophysical neutrinos by IceCube and the potential to constrain source models of ultra-high energy cosmic rays provide the motivation to develop instruments for the observation of neutrinos above $10^7$ GeV. Among the different techniques to detect ultra-high energy neutrinos is the Earth-skimming technique. It makes use of the fact that the tau produced in a tau neutrino interaction inside the Earth can emerge from the ground and initiate an upward-going particle shower in the atmosphere. The particle shower and thus the neutrino can be reconstructed by measuring the Cheren…
The MAGIC telescopes are one of the three major IACTs (Imaging Atmospheric Cherenkov Telescopes) for observation of gamma rays in the TeV regime currently operative. MAGIC functions since 2003, and has published data from more than 60 sources, mostly blazars. MAGIC already provides astronomical \texttt{.fits} files with basic final scientific products such as spectral energy distributions, light curves and skymaps from published results. In future, the format of the files can be complemented with further relevant information to the community: a) by including the full multi-wavelength dataset e…
Usually the Imaging Atmospheric Cherenkov Telescopes, used for the ground-based gamma-ray astronomy in the very high energy range 50 GeV - 50 TeV, perform air shower observations till the zenith angle of ~60 deg. Beyond that limit the column density of air increases rapidly and the Cherenkov light absorption starts playing a major role. Absence of a proper calibration method of light transmission restrained researchers performing regular measurements under zenith angles >>60 deg. We extend the observation of air showers in Cherenkov light till almost the horizon. We use an aperture photometry …
The Cherenkov Telescope Array (CTA) is the next generation very high energy gamma-ray observatory covering the 20 GeV - 300 TeV energy range with unprecedented sensitivity, angular and energy resolution. With a site in each hemisphere, CTA will provide full-sky coverage. Four Large Size Telescopes (LSTs) in each site will be dedicated to the lowest energy range (20 GeV - 200 GeV). The first LST prototype has been installed at the CTA Northern site (Canary Island of La Palma, Spain) in October 2018 and it had been since then in commissioning phase. LST1 is located at about 100 m from MAGIC, a s…
The mirrors installed on Imaging Atmospheric Cherenkov Telescopes like the MAGIC telescopes in La Palma, Canary Islands, are constantly exposed to the harsh environment. They have to withstand wind-induced corrosion from dust and sand, changing temperatures, and rain. Because of the size of the telescope, protecting the structure with a dome is not practical. The current mirrors used in MAGIC are aluminum front-coated glass mirrors, covered by a thin quartz layer. But even with this protective layer, significant decrease in reflectivity can be seen on timescales of several years. The quartz la…
The High Energy Stereoscopic System (H.E.S.S.) is one of the three arrays of imaging atmospheric Cherenkov telescopes (IACTs) currently in operation. It is composed of four 12-meter telescopes and a 28-meter one, and is sensitive to gamma rays in the energy range ~30 GeV - 100 TeV. The cameras of the 12-m telescopes recently underwent a substantial upgrade, with the goal of improving their performance and robustness. The upgrade involved replacing all camera components except for the photomultiplier tubes (PMTs). This meant developing new hardware for the trigger, readout, power, cooling and m…
