High spatial resolution X-ray photo-emission electron microscopy technique has been used to study the influence of the dipolar coupling taking place between the NiFe and the Co ferromagnetic electrodes of micron sized, elliptical shaped magnetic tunnel junctions. The chemical selectivity of this technique allows to observe independently the magnetic domain structure in each ferromagnetic electrode. The combination of this powerful imaging technique with micromagnetic simulations allows to evidence that a 360 degree domain wall can be stabilized in the NiFe soft layer. In this letter, we discuss the origin and the formation conditions of those 360 degree domain walls evidenced experimentally and numerically.
Ultra violet light emitting diodes (UV LEDs) face critical limitations in both the injection efficiency and light extraction efficiency due to the resistive and absorbing p-type contact layers. In this work, we investigate the design and application of polarization engineered tunnel junctions for ultra-wide bandgap AlGaN (Al mole fraction higher than 50%) materials towards highly efficient UV LEDs. We demonstrate that polarization-induced 3D charge is beneficial in reducing tunneling barriers especially for high composition AlGaN tunnel junctions. The design of graded tunnel junction structure…
A standard route for fabrication of nanoscopic tunnel junctions is via electromigration of lithographically prepared gold nanowires. In the lithography process, a thin adhesion layer, typically titanium, is used to promote the adhesion of the gold nanowires to the substrate. Here, we demonstrate that such an adhesion layer plays a vital role in the electrical transport behavior of electromigrated tunnel junctions. We show that junctions fabricated from gold deposited on top of a titanium adhesion layer are electrically stable at ambient conditions, in contrast to gold junctions without a titan…
Perpendicular magnetic tunnel junction with MgAl2O4 barrier is investigated. It is found that reactive RF sputtering with O2 is essential to obtain strong perpendicular magnetic anisotropy and large tunneling magnetoresistance in MgAl2O4-based junctions. An interfacial perpendicular magnetic anisotropy energy density of 2.25 mJ/m2 is obtained for the samples annealed at 400C. An enhanced magnetoresistance of 60% has also been achieved. The Vhalf, bias voltage at which tunneling magnetoresistance drops to half of the zero-bias value, is found to be about 1V, which is substantially higher than t…
Molecular bridges covalently bonded to two ferromagnetic electrodes can transform ferromagnetic materials and produce intriguing spin transport characteristics. This paper discusses the impact of molecule induced strong coupling on spin transport. To study the molecular coupling effect organometallic molecular complex (OMC) was bridged between two ferromagnetic electrodes of a magnetic tunnel junction (Ta/Co/NiFe/AlOx/NiFe/Ta) along the exposed side edges. OMCs induced strong iter-ferromagnetic electrode coupling to yield drastic changes in transport properties of the magnetic tunnel junction …
Impact of lattice strain on the tunnel magneto-resistance in Fe/Insulator/Fe and Fe/Insulator/La$_{0.67}$Sr$_{0.33}$MnO$_{3}$ magnetic tunnel junctions
本工作的目的是在一个新的方法，超越了单带输运模型描述隧道电子电流在单势垒磁性隧道结。我们提出了一个弹道多通道电子输运模型，该模型可以解释面内晶格应变对隧道磁电阻以及非对称电压行为的影响。以Fe/Insulator/Fe和Fe/Insulator/La $_{0.67}$ Sr $_{0.33}$ MnO $_{3}$隧道结的单晶磁性Fe（110）电极为例，通过\it{ab-initio}计算得到了Fe和La $_{0.67}$ Sr $_{0.33}$ MnO $_{3}$的电子能带结构.
Commercially successful magnetic tunnel junction can harness the unmatched capabilities of molecular device elements by solving decade-old fabrication issues. Utilization of magnetic tunnel junction as a testbed for molecules also enables unprecedented magnetic studies of molecular spintronics devices. This paper utilizes magnetic force microscopy (MFM) to vividly show that organometallic molecules when bridged between two ferromagnetic electrodes along the magnetic tunnel junction edges, transformed the magnetic electrodes itself. Molecules impacted several hundred-micron areas of ferromagnet…
Future generations of magnetic random access memory demand magnetic tunnel junctions that can provide simultaneously high magnetoresistance, strong retention, low switching energy and small cell size below 10nm. Here we study perpendicular magnetic tunnel junctions with composite free layers where multiple ferromagnet/nonmagnet interfaces can contribute to the thermal stability. Different nonmagnetic materials (MgO, Ta, Mo) have been employed as the coupling layers in these multi-interface free layers. The evolution of junction properties under different annealing conditions is investigated. A…
Polarization engineered interband tunnel junctions (TJs) are integrated in nanowire ultraviolet (UV) light emitting diodes (LEDs). A ~6V reduction in turn-on voltage is achieved by the integration of tunnel junction at the base of polarization doped nanowire UV LEDs. Moreover, efficient hole injection into the nanowire LEDs leads to suppressed efficiency droop in TJ integrated nanowire LEDs. The combination of both reduced bias voltage and increased hole injection increases the wall plug efficiency in these devices. More than 100 microwatts of UV emission at ~310 nm is measured with external q…
Asymmetric Bias Dependence in Double Spin Filter Tunnel Junctions
在双自旋过滤器（SF）隧道结中，自旋信息的产生和分析完全来自双电极的SF效应。在这篇文章中，我们数值评估的偏置依赖的磁阻在这样的隧道结（超导金属/ SF /超导绝缘体/ SF /超导金属），特别是在使用不同的SF材料的情况下。在WKB近似下，可以得到具有非单调和非对称偏置依赖性的大磁阻效应。我们说明了系统的影响，隧道势垒的高度，隧道势垒的厚度，和交换能量分裂的磁阻，特别是专注于非对称行为的磁阻偏置依赖。
Magnetic Tunnel Junction devices find use in several applications based on the exploitation of the Spin-Transfer Torque phenomenon. The Ferromagnetic Resonance curve is a key characteristic of any Magnetic Tunnel Junctions. It is usually characterized both experimentally and numerically by performing a lot of measurements of the magnetic response to a sinusoidal field or current. Here we propose the use of a chirp signal as excitation signal to reconstruct the Ferromagnetic resonance curve with a single measurement/simulation. A micromagnetic comparison of the proposed method with the traditio…
The magnetic tunnel junction is a cornerstone of spintronic devices and circuits, providing the main way to convert between magnetic and electrical information. In state-of-the-art magnetic tunnel junctions, magnesium oxide is used as the tunnel barrier between magnetic electrodes, providing a uniquely large tunnel magnetoresistance at room temperature. However, the wide bandgap and band alignment of magnesium oxide-iron systems increases the resistance-area product and causes challenges of device-to-device variability and tunnel barrier degradation under high current. Here, we study using fir…
Magnetic tunnel junctions with wide band gap semiconductor ZnTe barrier were fabricated. A very low barrier height and sizable magnetoresistance were observed in the Fe/ZnTe/Fe junctions at room temperature. The nonlinear I-V characteristic curve confirmed the observed magnetoresistance is due to spin-dependent tunneling effect. Temperature dependent study indicated that the total conductance of the junction is dominated by direct tunneling, with only a small portion from the hopping conduction through the defect states inside the barrier.
We study the evolution of perpendicularly magnetized tunnel junctions under 300 to 400 $^{\circ}$C annealing. The hysteresis loops do not evolve much during annealing and they are not informative of the underlying structural evolutions. These evolutions are better revealed by the frequencies of the ferromagnetic resonance eigenmodes of the tunnel junction. Their modeling provides the exchange couplings and the layers' anisotropies within the stack which can serve as a diagnosis of the tunnel junction state after each annealing step. The anisotropies of the two CoFeB-based parts and the two Co/…
Theoretical investigation of direct and phonon-assisted tunneling currents in InAlGaAs-InGaAs bulk and quantum well interband tunnel junctions for multi-junction solar cells
