It is well known that buoyancy suppresses, and can even laminarise turbulence in upward heated pipe flow. Heat transfer seriously deteriorates in this case. Through a new DNS model, we confirm that the deteriorated heat transfer within convective turbulence is related to a lack of near-wall rolls, which leads to a weak mixing between the flow near the wall and centre of pipe. Having surveyed the fundamental properties of the system, we perform a nonlinear nonmodal stability analysis. it is found that, the minimal seed becomes thinner and closer to the wall, with increase of buoyancy number C. Most importantly, we show that the critical initial energy required to trigger shear-driven turbulence keeps increasing, implying that attempts to artificially trigger it may not be an efficient means to improve heat transfer at larger C. The new minimal seed, found at C=6, is localised in streamwise direction and is active in the centre of pipe. To find this branch of optimal, we took advantage of a window of linear stability. While the nonlinear optimal causes transition to convective turbulence directly at this and larger C, transition via the linear instability passes via a travelling wave or periodic orbit solutions. Detailed analysis of the periodic solution reveals three stages: growth of the unstable eigenfunction, the formation of streaks, and the decay of streaks due to suppression of the instability. Flow visualization at C up to 10 also show similar features, suggesting that convective turbulence is sustained by these three typical processes.
The dynamics of suspensions plays a crucial role on the evolution of geophysical systems such as lava lakes, magma chambers and magma oceans. During their cooling and solidification, these magmatic bodies involve convective viscous fluids and dispersed solid crystals that can form either a cumulate or a floating lid by sedimentation. We study such systems based on internal heating convection experiments in high Prandtl fluids bearing plastic beads. We aim to determine the conditions required to produce a floating lid or a sedimented deposit. We show that although the sign of particles buoyancy…
Experimental study on gravity currents flowing on heated walls
Ecole Centrale de Lyon, CNRS, Universite Claude Bernard Lyon 1, INSA Lyon, LMFA, UMR5509（里昂中央理工学院、法国国家科学研究中心、里昂第一大学、里昂国立应用科学学院、力学与工程实验室）；Politecnico di Torino（都灵理工大学）
We study the conductive and convective states of phase-change of pure water in a rectangular container where two opposite walls are kept respectively at temperatures below and above the freezing point and all the other boundaries are thermally insulating. The global ice content at the equilibrium and the corresponding shape of the ice-water interface are examined, extending the available experimental measurements and numerical simulations. We first address the effect of the initial condition, either fully liquid or fully frozen, on the system evolution. Secondly, we explore the influence of th…
The present study numerically explores the mixed convection phenomena in a differentially heated ventilated square cavity with active flow modulation via a rotating plate. Forced convection flow in the cavity is attained by maintaining an external fluid flow through an opening at the bottom of the left cavity wall while leaving it through another opening at the right cavity wall. A counter-clockwise rotating plate at the center of the cavity acts as active flow modulator. Moving mesh approach is used for the rotation of the plate and the numerical solution is achieved using Arbitrary Lagrangia…
A 2D numerical hydrodynamics approach is considered for modelling recent experimental results on the oscillation and collective behavior of convective flows. Our simulations consider the rising dynamics of heated fluid columns in a gravitational field. Simulations are done on two entirely different length-scales, showing also the generality of the investigated phenomena. For the flow of a single heated fluid column, the effect of the inflow yield and the nozzle diameter is studied. In agreement with the experiments, for a constant nozzle diameter the oscillation frequency increases approximate…
The paper presents the comparative study of the vortex-induced cooling of a heated channel for the four different cross-sections of the rigid cylinder, i.e., circular, square, semi-circular, and triangular, with or without the rigid/flexible splitter plate at the Reynolds number (based on the hydraulic diameter) of 200. The study presents a comprehensive analysis of the flow and thermal performance for all the cases. For flexible plate cases, a partitioned approach is invoked to solve the coupled fluid-structure-convection problem. The simulations show the reduction in the thermal boundary lay…
Comment on Influence of convective boundary condition on double diffusive mixed convection from a permeable vertical surface, by P.M. Patil, E. Momoniat, S. Roy, International Journal of Heat and Mass Transfer, 70 (2014) 313-321
New bounds are proven on the mean vertical convective heat transport, $\overline{\langle wT \rangle}$, for uniform internally heated (IH) convection in the limit of infinite Prandtl number. For fluid in a horizontally-periodic layer between isothermal boundaries, we show that $\overline{\langle wT \rangle} \leq \frac12 - c R^{-2}$, where $R$ is a nondimensional `flux' Rayleigh number quantifying the strength of internal heating and $c = 216$. Then, $\overline{\langle wT \rangle} = 0$ corresponds to vertical heat transport by conduction alone, while $\overline{\langle wT \rangle} > 0$ represent…
Turbulence in the flow of fluid through a pipe can be suppressed by buoyancy forces. As the suppression of turbulence leads to severe heat transfer deterioration, this is an important and undesirable phenomenon in both heating and cooling applications. Vertical flow is often considered, as the axial buoyancy force can help drive the flow. With heating measured by the buoyancy parameter $C$, our DNS show that shear-driven turbulence may either be completely laminarised or transitions to a relatively quiescent convection-driven state. Buoyancy forces cause a flattening of the base flow profile, …
Inductive heating with high-voltage cables reduces the risk of hydrate formation by raising the temperature of the production fluid in pipelines. Heating the pipeline results in losing a certain fraction of the heat to the surrounding soil through conduction or convection-dominated flow through the soil. However, the amount of heat lost in conduction versus convection and the transition from conduction to convection-dominated heat loss remains unknown. Soil permeability, temperature gradient between cable and mudline, and burial depth influence the mode of heat transfer and the amount of heat …
An experimental and numerical smoothed particle hydrodynamics (SPH) analysis was performed for the convective flow arising from a horizontal, thin cylindrical heat source enclosed in a glycerin-filled, slender enclosure at low Rayleigh numbers ($1.18\leq {\rm Ra}\leq 242$). Both the experiments and the SPH calculations were performed for positive ($0.1\leqΔT\leq 10$ K) and negative ($-10\leqΔT\leq -0.1$ K) temperature differences between the source and the surrounding fluid. In all cases a pair of steady, counter-rotating vortices is formed, accompanied by a plume of vertically ascending flow …
Recent planetary data and geophysical modelling suggest that hydrothermal activity is ongoing under the ice crust of Enceladus, one of Saturn's moons. According to these models, hydrothermal flow in the porous, rocky core of the satellite is driven by tidal deformation that induces dissipation and volumetric internal heating. Despite the effort in the modelling of Enceladus' interior, systematic understanding---and even basic scaling laws---of internally-heated porous convection and hydrothermal activity are still lacking. In this article, using an idealised model of an internally-heated porou…
A Finite-Volume based POD-Galerkin reduced order modeling strategy for steady-state Reynolds averaged Navier--Stokes (RANS) simulation is extended for low-Prandtl number flow. The reduced order model is based on a full order model for which the effects of buoyancy on the flow and heat transfer are characterized by varying the Richardson number. The Reynolds stresses are computed with a linear eddy viscosity model. A single gradient diffusion hypothesis, together with a local correlation for the evaluation of the turbulent Prandtl number, is used to model the turbulent heat fluxes. The contribu…
We discuss spatio-temporal pattern formation in two separate thermal convective systems. In the first system, hydrothermal waves (HTW) are modeled numerically in an annular channel. A temperature difference is imposed across the channel, which induces a surface tension gradient on the free surface of the fluid, leading to a surface flow towards the cold side. The flow pattern is axially symmetric along the temperature gradient with an internal circulation for a small temperature difference. This axially symmetric flow (ASF) becomes unstable beyond a given temperature difference threshold, and …
We obtain an analytical bound on the mean vertical convective heat flux $\langle w T \rangle$ between two parallel boundaries driven by uniform internal heating. We consider two configurations, one with both boundaries held at the same constant temperature, and the other one with a top boundary held at constant temperature and a perfectly insulating bottom boundary. For the first configuration, Arslan et al. (J. Fluid Mech. 919:A15, 2021) recently provided numerical evidence that Rayleigh-number-dependent corrections to the only known rigorous bound $\langle w T \rangle \leq 1/2$ may be provab…
In the present work, the effects of diffuse and collimated radiation on the symmetrical cooling case of natural convection in a two-dimensional cavity heated from the bottom have been investigated, numerically. The cavity is convectively heated from the bottom with heat transfer coefficient of 50 W/m2K and free stream temperature 305 K, while both vertical walls of cavity are isothermal at temperature of 296 K. The top wall is adiabatic and all walls are opaque for radiation heat transfer. For collimated case, a small semitransparent window of non-dimensional width of 0.05 at height of 0.7 has…
Heat and momentum transfer of low-Prandtl-number fluid ($Pr=0.029$) in a closed rectangular cavity ($100\times60\times10$ mm$^3$) heated at one side and cooled at the opposite side are analyzed. The electromagnetic forces into the liquid metal are generated by the travelling magnetic field inductor and directed towards buoyancy forces. Large eddy simulations are performed with the Grashof number $Gr$ from $1.9\cdot 10^5$ to $7.6\cdot 10^7$ and the electromagnetic forcing parameter $F$ from $2.6\cdot 10^4$ to $2.6\cdot10^6$. An experimental validation of the simulation results of vertical conve…
The convective heat transfer enhancement in a turbulent boundary layer (TBL) employing a pulsed, slot jet in crossflow is investigated experimentally. A parametric study on actuation frequencies and duty cycles is performed. The actuator is a flush-mounted slot jet that injects fluid into a well-behaved zero-pressure-gradient TBL over a flat plate. A heated-thin-foil sensor measures the time-averaged convective heat transfer coefficient downstream of the actuator location and the flow field is characterised by means of Particle Image Velocimetry. The results show that both the jet penetration …
We investigate the radial thermocapillary flow driven by a laser-heated microbead in partial wetting at the water-air interface. Particular attention is paid to the evolution of the convective flow patterns surrounding the hot sphere as the latter is increasingly heated. The flow morphology is nearly axisymmetric at low laser power P. Increasing P leads to symmetry breaking with the onset of counter-rotating vortex pairs. The boundary condition at the interface, close to no-slip in the low-P regime, turns about stress-free between the vortex pairs in the high-P regime. These observations stron…
The main objective of this paper is to study the effect of a cold, vertical, arc-shaped control plate on the flow characteristics and forced convective heat transfer mechanism across a rotary oscillating, isothermally heated circular cylinder. Two-dimensional, unsteady, incompressible, laminar, and viscous flow of a Newtonian, constant property fluid is considered across the cylinder. The simulations are performed with an in-house code for various gap ratios between the control plate and the cylinder ($0\leq d/R_0 \leq 3$), maximum angular velocity ($0.5\leq α_m \leq 4$) and frequency ratio of…
Motivated by understanding the dynamics of stellar and planetary interiors, we have performed a set of direct numerical simulations of Boussinesq convection in a rotating full sphere. The domain is internally heated with fixed temperature and stress-free boundary conditions, but fixed heat flux and no-slip boundary conditions are also briefly considered. We particularly focus on the large-scale coherent structures and the mean zonal flows that can develop in the system. At Prandtl number of unity, as the thermal forcing (measured by the Rayleigh number) is increased above the value for the ons…
We present mesoscale numerical simulations of Rayleigh-Bénard convection in a two-dimensional concentrated emulsion, confined between two parallel walls, heated from below and cooled from above, under the effect of buoyancy forces. The systems under study comprise finite-size droplets, whose concentration $Φ_0$ is varied, ranging from the dilute limit up to the point where the emulsion starts to be packed and exhibits non-Newtonian rheology. We focus on the characterisation of the convective heat transfer properties close to the transition from conductive to convective states. The convective f…
