A thermoelectric device is a heat engine that directly converts heat into electricity. Many materials with a high figure of merit ZT have been discovered in anticipation of a high thermoelectric efficiency. However, there has been a lack of investigations on efficiency-based material evaluation, and little is known about the achievable limit of thermoelectric efficiency. Here, we report the highest thermoelectric efficiency using 12,645 published materials. The 97,841,810 thermoelectric efficiencies are calculated using 808,610 device configurations under various heat-source temperatures (T_h) when the cold-side temperature is 300 K, solving one-dimensional thermoelectric integral equations with temperature-dependent thermoelectric properties. For infinite-cascade devices, a thermoelectric efficiency larger than 33% (~1/3) is achievable when T_h exceeds 1400 K. For single-stage devices, the best efficiency of 17.1% (~1/6) is possible when T_h is 860 K. Leg segmentation can overcome this limit, delivering a very high efficiency of 24% (~1/4) when T_h is 1100 K.
Thermoelectric degrees of freedom determining thermoelectric efficiency
由于热电效应,热能可以直接转换成电能。由于这种转换实现了清洁能源技术,例如废热回收和能量收集,因此已经做出了大量努力来寻找热电材料。在材料品质因数$zT$代表热电器件的能量转换效率的信念下,半个世纪以来已经探索了各种高峰值-$zT$材料。然而,热电性能随温度$zT$变化很大,因此单个值$zT$不能准确地表示器件效率。在这里,我们表明,热电转换的效率是完全由\emph{three}参数$Z_{\mathrm{gen}}$,$τ$和$β$,我们称之为\emph{thermoelectric degrees of freedom}。$Z_{\mathrm{gen}}$是材料性能的平均值,是传统品质因数的概括。反映材料性质梯度的$τ$和$β$分别与由汤姆逊效应和不对称焦耳热引起的逸出热成比例。我们的发现为实现高热电效率提出了新的方向;增加一个热电自由度可以提高效率。例如,与单一材料腿的最佳效率相比,通过调整分段腿中的热电自由度,热电效率可以提高高达176%。
Effect of Pb doping on the crystallization process and thermoelectric properties of Ge2Sb2Te5 phase change material
A.B. Nalbandyan Institute of Chemical Physics NAS RA(纳尔班扬化学物理研究所);Belgorod State University(别尔哥罗德国立大学);Institute of Radiophysics and Electronics NAS RA(无线电物理与电子研究所)
Eco-friendly Bismuth Based Double Perovskites X$_2$NaBiCl$_6$ (X=Cs, Rb, K) for Optoelectronic and Thermoelectric Applications: A First-Principles Study
Calculation of Efficiency and Power Output by Considering Different Realistic Prospects for Recovering Heat from Automobile using Thermoelectric Generator
Exact branch-transfer criterion for common-mode Thomson heat cancellation in thermoelectric couples
School of Materials Science and Engineering, Beihang University(北京航空航天大学材料科学与工程学院);National Key Laboratory of Artificial Intelligence for Material Science, Beihang University(北京航空航天大学人工智能材料科学全国重点实验室);Tianmushan Laboratory, Beihang University(北京航空航天大学天目山实验室);Center for Bioinspired Science and Technology, Hangzhou International Innovation Institute, Beihang University(北京航空航天大学杭州创新研究院仿生科学与技术中心)
Tuning electronic heat transport in graphene/metal heterostructures with ultralow thermal conductivity
现有的超低热导率材料由于材料中有限的电子传输而不适用于热电应用。在这里,我们提出了一类新的超低热导率材料与大量的电子热传输。我们的样品是通过热蒸发或射频磁控溅射沉积的转移石墨烯和金属钯膜(Pd,Au和Ni)的石墨烯/金属异质结构。对于蒸发的样品,我们实现了0.06 W m-1 K-1的超低热导率,声子作为主要的热载体。超低的热导率是由于石墨烯和金属中声子能量的巨大差异。有趣的是,对于溅射样品,我们发现,约50%的热量是由电子携带的,即使热导率约为0.1 W m-1 K-1。我们将电子贡献归因于电子在石墨烯中穿过原子级针孔的传输。这种具有超低导热系数和电子输运特性的新材料有望在热电领域得到应用。
Thermoelastic Harvesting Outperforming Thermoelectric Generators Below 100 °C
Helmholtz-Zentrum Dresden–Rossendorf(德累斯顿-罗森多夫亥姆霍兹中心);TUD Dresden University of Technology(德累斯顿工业大学);Hochschule für Technik und Wirtschaft Dresden(德累斯顿应用技术大学)