Accurate channel knowledge is critical in massive multiple-input multiple-output (MIMO), which motivates the use of channel prediction. Machine learning techniques for channel prediction hold much promise, but current schemes are limited in their ability to adapt to changes in the environment because they require large training overheads. To accurately predict wireless channels for new environments with reduced training overhead, we propose a fast adaptive channel prediction technique based on a meta-learning algorithm for massive MIMO communications. We exploit the model-agnostic meta-learning (MAML) algorithm to achieve quick adaptation with a small amount of labeled data. Also, to improve the prediction accuracy, we adopt the denoising process for the training data by using deep image prior (DIP). Numerical results show that the proposed MAML-based channel predictor can improve the prediction accuracy with only a few fine-tuning samples. The DIP-based denoising process gives an additional gain in channel prediction, especially in low signal-to-noise ratio regimes.
Channel estimation is of crucial importance in massive multiple-input multiple-output (m-MIMO) visible light communication (VLC) systems. In order to tackle this problem, a fast and flexible denoising convolutional neural network (FFDNet)-based channel estimation scheme for m-MIMO VLC systems was proposed. The channel matrix of the m-MIMO VLC channel is identified as a two-dimensional natural image since the channel has the characteristic of sparsity. A deep learning-enabled image denoising network FFDNet is exploited to learn from a large number of training data and to estimate the m-MIMO VLC…
We consider joint channel estimation and faulty antenna detection for massive multiple-input multiple-output (MIMO) systems operating in time-division duplexing (TDD) mode. For systems with faulty antennas, we show that the impact of faulty antennas on uplink (UL) data transmission does not vanish even with unlimited number of antennas. However, the signal detection performance can be improved with a priori knowledge on the indices of faulty antennas. This motivates us to propose the approach for simultaneous channel estimation and faulty antenna detection. By exploiting the fact that the degr…
We propose sparsity-adaptive beamspace channel estimation algorithms that improve accuracy for 1-bit data converters in all-digital millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) basestations. Our algorithms include a tuning stage based on Stein's unbiased risk estimate (SURE) that automatically selects optimal denoising parameters depending on the instantaneous channel conditions. Simulation results with line-of-sight (LoS) and non-LoS mmWave massive MIMO channel models show that our algorithms improve channel estimation accuracy with 1-bit measurements in a computatio…
Beijing Institute of Technology（北京理工大学）；CNRS（法国国家科学研究中心）；CentraleSupélec（中央理工-高等电力学院）；Université Paris-Saclay（巴黎-萨克雷大学）；King Abdullah University of Science and Technology（阿卜杜拉国王科技大学）
Integrating large intelligent reflecting surfaces (IRS) into millimeter-wave (mmWave) massive multi-input-multi-ouput (MIMO) has been a promising approach for improved coverage and throughput. Most existing work assumes the ideal channel estimation, which can be challenging due to the high-dimensional cascaded MIMO channels and passive reflecting elements. Therefore, this paper proposes a deep denoising neural network assisted compressive channel estimation for mmWave IRS systems to reduce the training overhead. Specifically, we first introduce a hybrid passive/active IRS architecture, where v…
In this letter, we consider the problem of channel estimation for large intelligent metasurface (LIM) assisted massive multiple-input multiple-output (MIMO) systems. The main challenge of this problem is that the LIM integrated with a large number of low-cost metamaterial antennas can only passively reflect the incident signal by a certain phase shift, and does not have any signal processing capability. To deal with this, we introduce a general framework for the estimation of the transmitter-LIM and LIM-receiver cascaded channel, and propose a two-stage algorithm that includes a sparse matrix …
In a K-best detector for multiple-input-multiple-output(MIMO) systems, the value of K needs to be sufficiently large to achieve near-maximum-likelihood (ML) performance. By treating K as a variable that can be adjusted according to a fitting function of some learnable coefficients, an intelligent MIMO detection network based on deep neural networks (DNN) is proposed to reduce complexity of the detection algorithm with little performance degradation. In particular, the proposed intelligent detection algorithm uses meta learning to learn the coefficients of the fitting function for K to circumve…
The combination of orthogonal frequency modulation (OFDM) and multiple-input multiple-output (MIMO) systems plays an important role in modern communication systems. In order to meet the growing throughput demands, future MIMO-OFDM receivers are expected to utilize a massive number of antennas, operate in dynamic environments, and explore high frequency bands, while satisfying strict constraints in terms of cost, power, and size. An emerging technology to realize massive MIMO receivers of reduced cost and power consumption is based on dynamic metasurface antennas (DMAs), which inherently implem…
In multiple-input multiple-output (MIMO), multiple radio frequency (RF) chains are usually required to simultaneously transmit multiple data streams. As a special MIMO technology, spatial modulation (SM) activates one transmit antenna with one RF chain and exploits the index of the active antenna for information transfer at each time slot. Recently, reconfigurable metasurfaces have emerged as a promising technology that is able to reconfigure the wireless propagation environment by altering the amplitude and/or phase of the incident signal. In this article, we aim for the implementation of sin…
Next generation wireless base stations and access points will transmit and receive using extremely massive numbers of antennas. A promising technology for realizing such massive arrays in a dynamically controllable and scalable manner with reduced cost and power consumption utilizes surfaces of radiating metamaterial elements, known as metasurfaces. To date, metasurfaces are mainly considered in the context of wireless communications as passive reflecting devices, aiding conventional transceivers in shaping the propagation environment. This article presents an alternative application of metasu…
Massive multiple-input multiple-output (MIMO) communications are the focus of considerable interest in recent years. While the theoretical gains of massive MIMO have been established, implementing MIMO systems with large-scale antenna arrays in practice is challenging. Among the practical challenges associated with massive MIMO systems are increased cost, power consumption, and physical size. In this work we study the implementation of massive MIMO antenna arrays using dynamic metasurface antennas (DMAs), an emerging technology which inherently handles the aforementioned challenges. Specifical…
Millimeter-wave (mmWave) communication in combination with massive multiuser multiple-input multiple-output (MU-MIMO) enables high-bandwidth data transmission to multiple users in the same time-frequency resource. The strong path loss of wave propagation at such high frequencies necessitates accurate channel state information to ensure reliable data transmission. We propose a novel channel estimation algorithm called BEAmspace CHannel EStimation (BEACHES), which leverages the fact that wave propagation at mmWave frequencies is predominantly directional. BEACHES adaptively denoises the channel …
Future wireless communications are largely inclined to deploy massive numbers of antennas at the base stations (BSs) by leveraging cost- and energy-efficient as well as environmentally friendly antenna arrays. The emerging technology of dynamic metasurface antennas (DMAs) is promising to realize such massive antenna arrays with reduced physical size, hardware cost, and power consumption. The goal of this paper is the optimization of the energy efficiency (EE) performance of DMA-assisted massive multiple-input multiple-output (MIMO) wireless communications. Focusing on the uplink, we propose an…
Channel estimation is very challenging when the receiver is equipped with a limited number of radio-frequency (RF) chains in beamspace millimeter-wave (mmWave) massive multiple-input and multiple-output systems. To solve this problem, we exploit a learned denoising-based approximate message passing (LDAMP) network. This neural network can learn channel structure and estimate channel from a large number of training data. Furthermore, we provide an analytical framework on the asymptotic performance of the channel estimator. Based on our analysis and simulation results, the LDAMP neural network s…
Millimeter-wave (mmWave) communications have been one of the promising technologies for future wireless networks that integrate a wide range of data-demanding applications. To compensate for the large channel attenuation in mmWave band and avoid high hardware cost, a lens-based beamspace massive multiple-input multiple-output (MIMO) system is considered. However, the beam squint effect in wideband mmWave systems makes channel estimation very challenging, especially when the receiver is equipped with a limited number of radio-frequency (RF) chains. Furthermore, the real channel data cannot be o…
Massive MIMO is widely touted as an enabling technology for 5th generation (5G) mobile communications and beyond. On paper, the large excess of base station (BS) antennas promises unprecedented spectral efficiency gains. Unfortunately, during the initial phase of industrial testing, a practical challenge arose which threatens to undermine the actual deployment of massive MIMO: user mobility-induced channel Doppler. In fact, testing teams reported that in moderate-mobility scenarios, e.g., 30 km/h of user equipment (UE) speed, the performance drops up to 50% compared to the low-mobility scenari…
Wireless communications empowered by Reconfigurable Intelligent (meta)Surfaces (RISs) are recently gaining remarkable research attention due to the increased system design flexibility offered by RISs for diverse functionalities. In this paper, we consider a Multiple Input Multiple Output (MIMO) physical layer security system with multiple data streams including one legitimate and one eavesdropping passive RISs, with the former being transparent to the eavesdropper and the latter's presence being unknown at the legitimate link. We first focus on the eavesdropping subsystem and present a joint d…
Two-Stage Refinement Sparse Channel Estimation for Reconfigurable Intelligent Metasurface Antenna (RIMSA) Massive MIMO
School of Information and Communications Engineering, Xi’an Jiaotong University（西安交通大学信息与通信工程学院）；School of Computer Science & Technology, Xi’an University of Posts & Telecommunications（西安邮电大学计算机科学与技术学院）
Multiple-input multiple-output (MIMO) systems are required to communicate reliably at high spectral bands using a large number of antennas, while operating under strict power and cost constraints. In order to meet these constraints, future MIMO receivers are expected to operate with low resolution quantizers, namely, utilize a limited number of bits for representing their observed measurements, inherently distorting the digital representation of the acquired signals. The fact that MIMO receivers use their measurements for some task, such as symbol detection and channel estimation, other than r…
Reconfigurable intelligent surfaces (RISs) have attracted great attention as a potential beyond 5G technology. These surfaces consist of many passive elements of metamaterials whose impedance can be controllable to change the phase, amplitude, or other characteristics of wireless signals impinging on them. Channel estimation is a critical task when it comes to the control of a large RIS when having a channel with a large number of multipath components. In this paper, we propose a novel channel estimation scheme that exploits spatial correlation characteristics at both the massive multiple-inpu…
An intelligent reflecting surface (IRS), consisting of reconfigurable metamaterials, can be used to partially control the radio environment and thereby bring new features to wireless communications. Previous works on IRS have particularly studied the range extension use case and under what circumstances the new technology can beat relays. In this paper, we study another use case that might have a larger impact on the channel capacity: rank improvement. One of the classical bottlenecks of point-to-point MIMO communications is that the capacity gains provided by spatial multiplexing are only lar…
Holographic Multiple Input Multiple Output (HMIMO), which integrates massive antenna elements into a compact space to achieve a spatially continuous aperture, plays an important role in future wireless networks. With numerous antenna elements, it is hard to implement the HMIMO via phased arrays due to unacceptable power consumption. To address this issue, reconfigurable refractive surface (RRS) is an energy efficient enabler of HMIMO since the surface is free of expensive phase shifters. Unlike traditional metasurfaces working as passive relays, the RRS is used as transmit antennas, where the …
Visibility-Region Coupling in XL-MIMO AGV Fleets: Triple-Role Modeling and Masked Beamforming
King Abdullah University of Science and Technology (KAUST)（阿卜杜拉国王科技大学）；Institute of Advanced Intelligence and Computing, Agency for Science, Technology and Research (A*STAR IAIC)（新加坡科技研究局先进智能与计算研究所）
Efficient Alternating Optimization for Hybrid Digital-Wave Beamforming in SIM-Assisted Cell-Free Massive MIMO
Hanyang University（汉阳大学）；Northeastern University London（伦敦东北大学）；King’s College London（伦敦国王学院）；CNRS and CentraleSupélec, Institute of Electronics and Digital Technologies (IETR)（法国国家科学研究中心与中央理工-苏裴蕾斯，电子与数字技术研究所）
Future wireless networks are expected to evolve towards an intelligent and software reconfigurable paradigm enabling ubiquitous communications between humans and mobile devices. They will be also capable of sensing, controlling, and optimizing the wireless environment to fulfill the visions of low-power, high-throughput, massively-connected, and low-latency communications. A key conceptual enabler that is recently gaining increasing popularity is the Holographic Multiple Input Multiple Output Surface (HMIMOS) that refers to a low-cost transformative wireless planar structure comprising of sub-…
State Key Lab of Intelligent Technologies and Systems（智能技术与系统国家重点实验室）；Beijing National Research Center for Information Science and Technology（北京信息科学与技术国家研究中心）；Department of Automation, Tsinghua University（清华大学自动化系）；State Key Laboratory of Rail Traffic Control and Safety, Beijing Jiaotong University（北京交通大学轨道交通控制与安全国家重点实验室）
Artificial intelligence (AI) based downlink channel state information (CSI) prediction for frequency division duplexing (FDD) massive multiple-input multiple-output (MIMO) systems has attracted growing attention recently. However, existing works focus on the downlink CSI prediction for the users under a given environment and is hard to adapt to users in new environment especially when labeled data is limited. To address this issue, we formulate the downlink channel prediction as a deep transfer learning (DTL) problem, where each learning task aims to predict the downlink CSI from the uplink CS…
