This paper analyzes the maximal achievable rate for a given blocklength and error probability over a multiple-antenna ambient backscatter channel with perfect channel state information at the receiver. The result consists of a finite blocklength channel coding achievability bound and a converse bound based on the Neyman-Pearson test and the normal approximation based on the Berry- Esseen Theorem. Numerical evaluation of these bounds shows fast convergence to the channel capacity as the blocklength increases and also proves that the channel dispersion is an accurate measure of the backoff from capacity due to finite blocklength.
Sixth generation (6G) mobile networks may include new passive technologies, such as ambient backscatter communication or the use of reconfigurable intelligent surfaces, to avoid the emission of waves and the corresponding energy consumption. On the one hand, a reconfigurable intelligent surface improves the network performance by adding electronically controlled reflected paths in the radio propagation channel. On the other hand, in an ambient backscatter system, a device, named tag, communicates towards a reader by backscattering the waves of an ambient source (such as a TV tower). However, t…
We consider an ambient backscatter communication (AmBC) system aided by an intelligent reflecting surface (IRS). The optimization of the IRS to assist AmBC is extremely difficult when there is no prior channel knowledge, for which no design solutions are currently available. We utilize a deep reinforcement learning-based framework to jointly optimize the IRS and reader beamforming, with no knowledge of the channels or ambient signal. We show that the proposed framework can facilitate effective AmBC communication with a detection performance comparable to several benchmarks under full channel k…
Channel Estimation for Ambient Backscatter Communication Systems with Massive-Antenna Reader
环境后向散射技术作为一种新兴的绿色通信技术，引起了学术界和工业界的极大兴趣。环境后向散射通信（AmBC）系统的一个公开问题是用于双天线读取器的信道估计。本文研究了在阅读器端采用均匀线阵（Uniform Linear Array，简称EGA）的AmBC系统中的信道估计问题。我们首先设计了一个两步的方法来联合估计信道增益和波达方向（DOA），然后通过角度旋转来细化估计。此外，Cramer-Rao下界（CRLB）推导出的信道增益和DoA估计的模。仿真结果验证了分析的正确性，并表明了该方法的有效性。
Wireless power transfer (WPT) using energy beamforming is a promising solution for low power Internet of Things (IoT) devices. In this work, we consider WPT from an energy transmitter (ET) employing retrodirective WPT using a large phased antenna array to an energy receiver (ER) capable of ambient backscatter. The advantage of retrodirective WPT is that no explicit channel estimation is needed at the ET and the use of ambient backscattering eliminates the need for active transmission at the ER. We propose a training sequence design, i.e., pattern of varying the reflection coefficient at the ER…
Channel estimation is a challenging problem for realizing efficient ambient backscatter communication (AmBC) systems. In this letter, channel estimation in AmBC is modeled as a denoising problem and a convolutional neural network-based deep residual learning denoiser (CRLD) is developed to directly recover the channel coefficients from the received noisy pilot signals. To simultaneously exploit the spatial and temporal features of the pilot signals, a novel three-dimension (3D) denoising block is specifically designed to facilitate denoising in CRLD. In addition, we provide theoretical analysi…
Simplifying the detection procedure and improving the bit error rate (BER) performance of a non-coherent receiver in ambient backscatter is vital for enhancing its ability to function without the channel state information (CSI). In this work, we analyze the BER performance of Manchester encoding which is implemented at the transmitter for data transmission, and demonstrate that the optimal decision rule is independent of the system parameters. Further, through extensive numerical results, it is shown that the ambient backscatter system can achieve a signal-to-noise ratio (SNR) gain with Manche…
The probability density function (pdf) of the received signal of an ambient backscatter communication system is derived, assuming that on-off keying (OOK) is performed at the tag, and that the ambient radio frequency (RF) signal is white Gaussian. The pdf of the received signal is then utilized to design two different types of non-coherent detectors. The first detector directly uses the received signal to perform a hypothesis test. The second detector first estimates the channel based on the observed signal and then performs the hypothesis test. Test statistics and optimal decision threshold o…
The performance of cooperative ambient backscatter communications (CABC) can be enhanced by employing reconfigurable intelligent surface (RIS) to assist backscatter transmitters. Since the RIS power consumption is a non-negligible issue, we consider a RIS assisted CABC system where the RIS with energy harvesting circuit can not only reflect signal but also harvest wireless energy. We study a transmission design problem to minimize the RIS power consumption with the quality of service constraints for both active and backscatter transmissions. The optimization problem is a mixed-integer non-conv…
Ambient backscatter communication (AmBC) leverages the existing ambient radio frequency (RF) environment to implement communication with battery-free devices. One critical challenge of AmBC systems is signal recovery because the transmitted information bits are embedded in the ambient RF signals and these are unknown and uncontrollable. To address this problem, most existing approaches use averaging-based energy detectors and consequently the data rate is low and there is an error floor. Here we propose a new detection strategy based on the ratio between signals received from a multiple-antenn…
Non-orthogonal multiple access (NOMA) and ambient backscatter communication have been envisioned as two promising technologies for the Internet-of-things due to their high spectral efficiency and energy efficiency. Motivated by this fact, we consider an ambient backscatter NOMA system in the presence of a malicious eavesdropper. Under some realistic assumptions of residual hardware impairments (RHIs), channel estimation errors (CEEs) and imperfect successive interference cancellation (ipSIC), we investigate the physical layer security (PLS) of the ambient backscatter NOMA systems focusing on r…
Symbol Detection in Ambient Backscatter Communications Under Residual Time Synchronization Errors
Shaanxi Key Laboratory of Information Communication Network and Security, Xi’an University of Posts & Telecommunications（西安邮电大学）；The University of Sheffield（谢菲尔德大学）；University of Warwick（华威大学）；Institute of Infocomm Research, Agency for Science, Technology and Research（新加坡科技研究局信息通信研究所）
Tag signal detection is one of the key tasks in ambient backscatter communication (AmBC) systems. However, obtaining perfect channel state information (CSI) is challenging and costly, which makes AmBC systems suffer from a high bit error rate (BER). To eliminate the requirement of channel estimation and to improve the system performance, in this paper, we adopt a deep transfer learning (DTL) approach to implicitly extract the features of channel and directly recover tag symbols. To this end, we develop a DTL detection framework which consists of offline learning, transfer learning, and online …
In mutualistic cooperative ambient backscatter communications (AmBC), Internet-of-Things (IoT) device sends its information to a desired receiver by modulating and backscattering the primary signal, while providing beneficial multipath diversity to the primary receiver in return, thus forming a mutualism relationship between the AmBC and primary links. We note that the hardware impairments (HIs), which are unavoidable in practical systems and may significantly affect the transmission rates of the primary and AmBC links and their mutualism relationships, have been largely ignored in the study o…
This paper focuses on the non-coherent detection in ambient backscatter communication, which is highly appealing for systems where the trade-off between signaling overhead and the actual data transmission is very critical. Modeling the time-selective fading channel as a first-order autoregressive (AR) process, we propose a new receiver architecture based on the direct averaging of the received signal samples for detection, which departs significantly from the energy averaging-based receivers considered in the literature. For the proposed setup, we characterize the exact asymptotic bit error ra…
Internet-of-Things (IoT) is featured with low-power communications among a massive number of ubiquitously-deployed and energy-constrained electronics, e.g., sensors and actuators. To cope with the demand, wireless-powered cooperative relaying emerges as a promising communication paradigm to extend data transmission coverage and solve energy scarcity for the IoT devices. In this paper, we propose a novel hybrid relaying strategy by combining wireless-powered communication and ambient backscattering functions to improve applicability and performance of data transfer. In particular, the hybrid re…
Symbol Detection in Multi-channel Multi-tag Ambient Backscatter Communication Under IQ Imbalance
Shaanxi Key Laboratory of Information Communication Network and Security, Xi’an University of Posts & Telecommunications（西安邮电大学）；Interdisciplinary Research Center for Communication Systems and Sensing (IRC-CSS), Department of Electrical Engineering, King Fahd University of Petroleum & Minerals (KFUPM)（阿卜杜拉国王科技大学）
Existing tag signal detection algorithms inevitably suffer from a high bit error rate (BER) due to the difficulties in estimating the channel state information (CSI). To eliminate the requirement of channel estimation and to improve the system performance, in this paper, we adopt a deep transfer learning (DTL) approach to implicitly extract the features of communication channel and directly recover tag symbols. Inspired by the powerful capability of convolutional neural networks (CNN) in exploring the features of data in a matrix form, we design a novel covariance matrix aware neural network (…
Ambient backscatter communications have been identified for ultra-low energy wireless communications. Indeed, a tag can send a message to a reader without emitting any wave and without battery, simply by backscattering the waves generated by a source. In the simplest implementation of such a system, the tag sends a binary message by oscillating between two states and the reader detects the bits by comparing the two distinct received powers. In this paper, for the first time, we propose to study an ambient backscatter communication system, in the presence of a diffusing surface, a simple flat p…
In this paper, we study the throughput utility functions in buffer-equipped monostatic backscatter communication networks with multi-antenna Readers. In the considered model, the backscatter nodes (BNs) store the data in their buffers before transmission to the Reader. We investigate three utility functions, namely, the sum, the proportional and the common throughput. We design online admission policies, corresponding to each utility function, to determine how much data can be admitted in the buffers. Moreover, we propose an online data link control policy for jointly controlling the transmit …
