Non-radiative recombination processes are the biggest hindrance to approaching the radiative limit of the open-circuit voltage for wide-band gap perovskite solar cells. In addition, to high bulk quality, good interfaces and good energy level alignment for majority carriers at charge transport layer-absorber interfaces are crucial to minimize non-radiative recombination pathways. By tuning the lowest-unoccupied molecular-orbital of electron transport layers via the use of different fullerenes and fullerene blends, we demonstrate open-circuit voltages exceeding 1.35 V in CH3NH3Pb(I0.8Br0.2)3 device. Further optimization of mobility in binary fullerenes electron transport layer can boost the power conversion efficiency as high as 18.6%. We note in particular that the Voc-fill factor product is > 1.085 V, which is the highest value reported for halide perovskites with this band gap.
Organic solar cells (OSCs) based on ADA-type (acceptor-donor-acceptor) non-fullerene acceptors (NFAs) exhibit improved power conversion efficiency (PCE) compared to the conventional fullerene-based analogues. The optoelectronic properties of OSC active layer blends are correlated to their underlying structural dynamics and therefore influence the device performance. Using synergistically different neutron spectroscopy techniques, we studied the dynamics of binary and ternary blends made of the NFAs O-IDTBR and O-IDFBR and the regioregular donor polymer P3HT. Deuteration was considered for a co…
Electrospun Conjugated Polymer/Fullerene Hybrid Fibers: Photoactive Blends, Conductivity through Tunnelling-AFM, Light-Scattering, and Perspective for Their Use in Bulk-Heterojunction Organic Solar Cells
Blended organic thin films have been studied during the last decades due to their applicability in organic solar cells. Although their optical and electronic features have been examined intensively, there is still lack of detailed knowledge about their growth processes and resulting morphologies, which play a key role for the efficiency of optoelectronic devices such as organic solar cells. In this study, pure and blended thin films of copper phthalocyanine (CuPc) and the Buckminster fullerene (C60) were grown by vacuum deposition onto a native silicon oxide substrate at two different substrat…
Non-fullerene acceptor (NFA)-based ternary bulk heterojunction solar cells (TSC) are the most efficient organic solar cells (OSCs) today due to their broader absorption and quantum efficiencies (QE) often surpassing those of corresponding binary blends. We study how the energetics driving charge transfer at the electron donor:electron acceptor (D/A) interfaces impact the QE in blends of PBDB-T-2F donor with several pairs of lower bandgap NFAs. As in binary blends, the ionization energy offset between donor and acceptor (ΔIE) controls the QE and maximizes for ΔIE > 0.5 eV. However, ΔIE is not c…
Earlier reports demonstrated that ternary organic solar cells (OSC) made of donor polymers (D) blended with different mixtures of fullerene acceptors (A:A) performed very similarly. This finding is surprising, as the corresponding fullerene LUMO levels are slightly different, which might result in decisive differences in the charge transfer step. We investigate ternary OSC (D:A:A) made of the donor polymer P3HT with stoichiometric mixtures of different fullerene derivatives, PC60BM:PC70BM and PC70BM:IC60BA, respectively. Using quantitative electron paramagnetic resonance (EPR) we can distingui…
We present a neutron spectroscopy based method to study quantitatively the partial miscibility and phase behaviour of an organic photovoltaic active layer made of conjugated polymer:small molecule blends, presently illustrated with the regio-random poly(3-hexylthiophene-2,5-diyl) and fullerene [6,6]-Phenyl C$_{61}$ butyric acid methyl ester (RRa-P3HT:PCBM) system. We perform both inelastic neutron scattering and quasi-elastic neutron scattering measurements to study the structural dynamics of blends of different compositions enabling us to resolve the phase behaviour. The difference of neutron…
The active layer crystallinity has long been associated with favourable organic solar cells (OSCs) properties such as high mobility and Fill Factor. In particular, this applies to acceptor materials such as fullerene-derivatives and the most recent Non-Fullerene Acceptors (NFAs), which are now surpassing 19% of Power Conversion Efficiency. Despite these advantages are being commonly attributed to their 3-dimensional crystal packing motif in the single crystal, the bridge that links the acceptor crystal packing from single crystals to solar cells has not clearly been shown yet. In this work, we…
Organic solar cells (OSCs) have recently shown a rapid improvement in their performance, bringing power conversion efficiencies (PCEs) closer to the point where commercial applications of the technology become viable. However, the low open-circuit voltage (Voc) of OSCs relative to their optical gap still limits PCEs to below 20%. A key factor contributing to the large Voc deficit in OSCs is non-radiative recombination to spin-triplet excitons, which is widely, but not universally, observed in blends using both fullerene and non-fullerene electron acceptors. Here, we present an experimental fra…
There is increasing attention to chemical applications of transmission electron microscopy, which is often plagued by radiation damage. The damage in organic matter predominantly occurs via ionization (radiolysis). Although radiolysis is highly important, previous studies on radiolysis have largely been descriptive and qualitative, lacking in such fundamental information as the product structure, the influence of the energy of the electrons, and the reaction kinetics. We need a chemically well-defined system to obtain such data, and have chosen as a model a variable-temperature and variable-vo…
Four different forms of carbon: activated carbon (AC) from human hair, AC from hemp fibers, a carbon fullerene extract consisting of C$_{60}$ and C$_{70}$ fullerene (CFEx) and Super-P carbon black were tested and compared as cathodes for non-aqueous aluminium-ion batteries (AIBs). These materials differ in their general structure, porosity and morphology. Fullerenes display a crystalline structure, whereas hemp fibers, Super-P and hair are amorphous in nature. Of all materials, AC obtained from hair recorded the highest specific capacity after 50 cycles at 103 mAh g$^{-1}$ with a Coulombic eff…
Driven by the rapid development of non-fullerene electron acceptors (NFAs), the power conversion efficiencies of organic solar cells (OSCs) have reached levels suitable for commercial applications. However, the poor operational stability of high-performance NFA OSCs is a remaining fundamental challenge that must be addressed. Whilst previous studies have primarily focused on the NFA component, we consider here the degradation pathways of both the donor and acceptor materials in the benchmark PM6:Y6 blend. Here, we show that light soaking greatly increases the energetic disorder and trap state …
Organic solar cells (OSCs) containing an active layer consisting of a nanostructured blend of a conjugated polymer like poly(3-hexylthiophene) (P3HT) and an electron acceptor molecule have the potential of competing against silicon-based photovoltaic panels. However, this potential is unfulfilled primarily due to interrelated production and stability issues. The generally employed spin coating process for fabricating organic solar cells cannot be scaled up. Recently, He et al., have reported that the gelation of P3HT with [6,6]-phenyl-C61-butyric acid methyl ester (PC60BM) under sub-ambient co…
Bridging the lab-to-fab gap in non-fullerene organic solar cells via gravure printing
Institute for Print and Media Technology, Chemnitz University of Technology（印刷与媒体技术研究所，开姆尼茨工业大学）；Institute of Physics, Chemnitz University of Technology（物理研究所，开姆尼茨工业大学）；Department of Engineering, Durham University（工程系，杜伦大学）
On the critical competition between singlet exciton decay and free charge generation in non-fullerene-based organic solar cells with low energetic offsets
Efficiencies of organic solar cells have practically doubled since the development of non-fullerene acceptors (NFAs). However, generic chemical design rules for donor-NFA combinations are still needed. Such rules are proposed by analyzing inhomogeneous electrostatic fields at the donor-acceptor interface. It is shown that an acceptor-donor-acceptor molecular architecture, and molecular alignment parallel to the interface, results in energy level bending that destabilizes the charge transfer state, thus promoting its dissociation into free charges. By analyzing a series of PCE10:NFA solar cells…
Despite many advances towards improving the stability of organic photovoltaic devices, environmental degradation under ambient conditions remains a challenging obstacle for future application. Particularly conventional systems employing fullerene derivatives are prone to oxidise under illumination, limiting their applicability. Herein, we report on the environmental stability of the small molecule donor DRCN5T together with the fullerene acceptor PC70BM. We find that this system exhibits exceptional device stability, mainly due to almost constant short-circuit current. By employing ultrafast f…
Stability is one of the most important challenges facing organic solar cells (OSC) on their path to commercialization. In the high-performance material system PM6:Y6 studied here, investigate degradation mechanisms of inverted photovoltaic devices. We have identified two distinct degradation pathways: one requires presence of both illumination and oxygen and features a short-circuit current reduction, the other one is induced thermally and marked by severe losses of open-circuit voltage and fill factor. We focus our investigation on the thermally accelerated degradation. Our findings show that…
Ternary organic solar cells (TOSC) are currently under intensive investigation, recently reaching a record efficiency of 17.1%. The origin of the device open-circuit voltage (VOC), already a multifaceted issue in binary OSC, is even more complex in TOSCs. Herein, we investigate two ternary systems with one donor (D) and two acceptor materials (A1, A2) including fullerene and non-fullerene acceptors. By varying the ratio between the two acceptors, we find the VOC to be gradually tuned between those of the two binary systems, D:A1 and D:A2. To investigate the origin of this change, we employ ult…
The power conversion efficiencies (PCEs) of organic solar cells (OSCs) using non-fullerene acceptors (NFAs) have now reached 18%. However, this is still lower than inorganic solar cells, for which PCEs >20% are commonplace. A key reason is that OSCs still show low open-circuit voltages (Voc) relative to their optical band gaps, attributed to non-radiative recombination. For OSCs to compete with inorganics in efficiency, all non-radiative loss pathways must be identified and where possible, removed. Here, we show that in most NFA OSCs, the majority of charge recombination at open-circuit procee…
The great progress in organic photovoltaics (OPV) over the past few years has been largely achieved by the development of non-fullerene acceptors (NFAs), with power conversion efficiencies now approaching 20%. To further improve device performance, loss mechanisms must be identified and minimized. Triplet states are known to adversely affect device performance, since they can form energetically trapped excitons on low-lying states that are responsible for non-radiative losses or even device degradation. Halogenation of OPV materials has long been employed to tailor energy levels and to enhance…
Influence of Charge Carrier Mobility on the Performance of Organic Solar Cells
基于供体-受体共混物的有机太阳能电池的功率转换效率由极化子对解离和双分子极化子复合的相互作用决定。这两个过程都强烈依赖于载流子的迁移率，解离随着更快的电荷传输而增加，同时提高了复合损失。使用宏观有效介质模拟，我们计算了最佳的载流子迁移率的最高功率转换效率，第一次占注入势垒和减少Langevin型复合。载流子迁移率从现有技术聚合物：富勒烯太阳能电池的$10^{-8}$ m $^2$ /Vs提高到产生最大效率的约$10^{-6}$ m $^2$ /Vs，对应于给定参数组仅约20%的提高。
Among the parameters determining the efficiency of an organic solar cell, the open-circuit voltage ($V_\text{OC}$) is the one with most room for improvement. Existing models for the description of $V_\text{OC}$ assume that photogenerated charge carriers are thermalized. Here, we demonstrate that quasi-equilibrium concepts cannot fully describe $V_\text{OC}$ of disordered organic devices. For two representative donor:acceptor blends it is shown that $V_\text{OC}$ is actually 0.1-0.2 V higher than it would be if the system was in thermodynamic equilibrium. Extensive numerical modeling reveals th…
A combination of transient photovoltage (TPV), voltage dependent charge extraction (CE) and time delayed collection field (TDCF) measurements is applied to poly[[4,8-bis[(2-ethylhexyl)oxy]benzo[1,2-b:4,5-b']dithiophene-2,6-diyl] [3-fluoro-2-[(2-ethylhexyl)carbonyl] thieno[3,4-b]thiophenediyl]] (PTB7):[6,6]-phenyl-C71-butyric acid (PC$_{71}$BM) bulk heterojunction solar cells to analyze the limitations of photovoltaic performance. Devices are processed from pure chlorobenzene (CB) solution and a subset was optimized with 1,8-diiodooctane (DIO) as co-solvent. The dramatic changes in device perfo…
Herein, we report on the synthesis and investigation of two triazino-isoquinoline tetrafluoroborate electrolytes as hole-blocking layers in methylammonium triiodide perovskite photovoltaic devices with fullerene electron extraction layer. We find that increasing the thickness of the dipolar hole-blocking layer results in a gradual increase in the open-circuit voltage suggesting that aggregation of the molecules can enhance the dipole induced by the layer. This finding is confirmed by theoretical calculations demonstrating that while both molecules exhibit a similar dipole moment in their isola…
Perovskite light emitting devices have drawn considerable attention for their favorable optoelectronic properties. High carrier mobilities make perovskites excellent candidates as host materials in electroluminescent devices. To achieve high performance in a simple single layer device, we employed a CsPbBr3 perovskite host and a novel ionic iridium complex guest along with a polyelectrolyte to demonstrate efficient light emitting electrochemical cells (PeLECs). For an optimal guest/host blend, 10600 cd/m2 luminance at 11.6 cd/A and 9.04 Lm/W are achieved at 4.1 V. These devices showed voltage-…
Bulk-heterojunction (BHJ) non-fullerene organic solar cells prepared from sequentially deposited donor and acceptor layers (sq-BHJ) have recently been promising to be highly efficient, environmentally friendly, and compatible with large area and roll-to-toll fabrication. However, the related photophysics at donor-acceptor interface and the vertical heterogeneity of donor-acceptor distribution, critical for exciton dissociation and device performance, are largely unexplored. Herein, steady-state and time-resolved optical and electrical techniques are employed to characterize the interfacial tra…
The thermodynamic limit for the efficiency of solar cells is predominantly defined by the energy bandgap of the used semiconductor. In case of organic solar cells both energetics and kinetics of three different species play role: excitons, charge transfer states and charge separated states. In this work, we clarify the effect of the relative energetics and kinetics of these species on the recombination and generation dynamics. Making use of detailed balance, we develop an analytical framework describing how the intricate interplay between the different species influence the photocurrent genera…
