We provide evidence that commonly held intuitions when designing quantum circuits can be misleading. In particular we show that: a) reducing the T-count can increase the total depth; b) it may be beneficial to trade CNOTs for measurements in NISQ circuits; c) measurement-based uncomputation of relative phase Toffoli ancillae can make up to 30\% of a circuit's depth; d) area and volume cost metrics can misreport the resource analysis. Our findings assume that qubits are and will remain a very scarce resource. The results are applicable for both NISQ and QECC protected circuits. Our method uses multiple ways of decomposing Toffoli gates into Clifford+T gates. We illustrate our method on addition and multiplication circuits using ripple-carry. As a byproduct result we show systematically that for a practically significant range of circuit widths, ripple-carry addition circuits are more resource efficient than the carry-lookahead addition ones. The methods and circuits were implemented in the open-source QUANTIFY software.
Many quantum algorithms make use of oracles which evaluate classical functions on a superposition of inputs. In order to facilitate implementation, testing, and resource estimation of such algorithms, we present quantum circuits for evaluating functions that are often encountered in the quantum algorithm literature. This includes Gaussians, hyperbolic tangent, sine/cosine, inverse square root, arcsine, and exponentials. We use insights from classical high-performance computing in order to optimize our circuits and implement a quantum software stack module which allows to automatically generate…
Quantum algorithms to solve practical problems in quantum chemistry, materials science, and matrix inversion often involve a significant amount of arithmetic operations which act on a superposition of inputs. These have to be compiled to a set of fault-tolerant low-level operations and throughout this translation process, the compiler aims to come close to the Pareto-optimal front between the number of required qubits and the depth of the resulting circuit. In this paper, we provide quantum circuits for floating-point addition and multiplication which we find using two vastly different approac…
This is an investigation of the limits of quantum circuit simulation with Schrodinger's formulation and low precision arithmetic. The goal is to estimate how much memory can be saved in simulations that involve random, maximally entangled quantum states. An arithmetic polar representation of $B$ bits is defined for each quantum amplitude and a normalization procedure is developed to minimize rounding errors. Then a model is developed to quantify the cumulative errors on a circuit of $Q$ qubits and $G$ gates. Depending on which regime the circuit operates, the model yields explicit expressions …
Many computational problems can be formulated in terms of high-dimensional functions. Simple representations of such functions and resulting computations with them typically suffer from the "curse of dimensionality", an exponential cost dependence on dimension. Tensor networks provide a way to represent certain classes of high-dimensional functions with polynomial memory. This results in computations where the exponential cost is ameliorated or in some cases, removed, if the tensor network representation can be obtained. Here, we introduce a direct mapping from the arithmetic circuit of a func…
We demonstrate a technique for optimizing quantum circuits that is analogous to classical windowing. Specifically, we show that small table lookups can allow control qubits to be iterated in groups instead of individually. We present various windowed quantum arithmetic circuits, including a windowed modular exponentiation with nested windowed modular multiplications, which have lower Toffoli counts than previous work at register sizes ranging from tens of qubits to thousands of qubits.
In some quantum algorithms, arithmetic operations are of utmost importance for resource estimation. In binary quantum systems, some efficient implementation of arithmetic operations like, addition/subtraction, multiplication/division, square root, exponential and arcsine etc. have been realized, where resources are reported as a number of Toffoli gates or T gates with ancilla. Recently it has been demonstrated that intermediate qutrits can be used in place of ancilla, allowing us to operate efficiently in the ancilla-free frontier zone. In this article, we have incorporated intermediate qutrit…
Sharpening Worst-Case Error Assessment for Fault-Tolerant Quantum Computing: Fidelity and Its Deviation
Institute for Convergence Research and Education in Advanced Technology, Yonsei University（延世大学先进技术与教育融合研究所）；Department of Statistics and Data Science, Yonsei University（延世大学统计与数据科学系）；Quantum Network Research Center, Korea Institute of Science and Technology Information（韩国科学技术信息研究院量子网络研究中心）；Electronics and Telecommunications Research Institute（电子通信研究院）；Department of Quantum Information, Yonsei University（延世大学量子信息系）
Single flux quantum (SFQ) logic is a promising candidate to replace the CMOS logic for high speed and low power applications due to its superiority in providing high performance and energy efficient circuits. However, developing effective Electronic Design Automation (EDA) tools, which cater to special characteristics and requirements of SFQ circuits such as depth minimization and path balancing, are essential to automate the whole process of designing large SFQ circuits. In this paper, a novel technology mapping tool, called SFQmap, is presented, which provides optimization methods for minimi…
This study presents a quantum circuit for estimating the pi value using arithmetic circuits and by quantum amplitude estimation. We review two types of quantum multipliers and propose quantum squaring circuits based on the multiplier as basic arithmetic circuits required for performing quantum computations. The squarer realized by a quantum adder with the gate size of $ O(n) $ requires $ O(n^2) $ gates and at least one ancillary qubits, while that realized by using quantum Fourier transform (QFT) requires $ O(n^3) $ gates without ancillary qubit. The proposed quantum circuit to estimate pi is …
Worst-case depth hierarchy for shallow quantum circuits
Hon Hai (Foxconn) Quantum Computing Research Center（鸿海（富士康）量子计算研究中心）；University of Oxford（牛津大学）；The University of Hong Kong（香港大学）；University of Technology Sydney（悉尼科技大学）
One of the major promises of quantum computing is the realization of SIMD (single instruction - multiple data) operations using the phenomenon of superposition. Since the dimension of the state space grows exponentially with the number of qubits, we can easily reach situations where we pay less than a single quantum gate per data point for data-processing instructions which would be rather expensive in classical computing. Formulating such instructions in terms of quantum gates, however, still remains a challenging task. Laying out the foundational functions for more advanced data-processing i…
In this work, we provide an overview of circuits for quantum computing. We introduce gates used in quantum computation and then present resource cost measurements used to evaluate circuits made from these gates. We then illustrate how the gates shown are then combined into quantum circuits for basic arithmetic functions. Architectures for addition, subtraction, multiplication, and division are shown. We demonstrate how to calculate the resource costs of quantum circuits. We conclude this overview with by illustrating an application of the elementary quantum circuits for the image rotation oper…
For efficient hardware-accelerated simulations of quantum circuits, we can define hardware-specific quantum-circuit transformations. We use a functional programming approach to create a quantum-circuit analysis and transformation method implemented in Haskell. This tool forms a key part of our larger quantum-computing simulation toolchain. As an example of hardware acceleration, we discuss FPGA-based simulations of selected quantum arithmetic circuits, including the transformation steps to optimise the hardware utilisation. Future development steps in the Haskell-based analysis and transformat…
The quantum Fourier transform (QFT) brings efficiency in many respects, especially usage of resource, for most operations on quantum computers. In this study, the existing QFT-based and non-QFT-based quantum arithmetic operations are examined. The capabilities of QFT-based addition and multiplication are improved with some modifications. The proposed operations are compared with the nearest quantum arithmetic operations. Furthermore, novel QFT-based subtraction, division and exponentiation operations are presented. The proposed arithmetic operations can perform nonmodular operations on all sig…
