The evolution of point defect concentrations under irradiation is controlled by their diffusion properties, and by their formation and elimination mechanisms. The latter include the mutual recombination of vacancies and interstitials, and the elimination of point defects at sinks. We show here that the modelling of this evolution by means of atomistic kinetic Monte Carlo (AKMC) simulations, necessarily using small system sizes, introduces strong space and time correlations between the vacancies and interstitials, which may strongly affect the recombination rate and the point defect concentrations. In such situations, standard rate theory models fail to predict the actual point defect concentrations. The effect is especially strong when the elimination of point defects occurs only by recombination, but can still be significant in the presence of sinks. We propose a new Correlated Pair Theory that fully takes into account the correlations between vacancy and interstitial pairs and predicts point defect concentrations in good agreement with AKMC simulations, even in very small systems. The Correlated Pair Theory can be used to modify the elimination rates in AKMC simulations to yield point defect concentrations as predicted by the standard rate theory, i.e. representative of large systems, even when using small simulation boxes.
Unlike the vast amount of irradiated material data that exists for stainless steel internals from LWRs, with high fast neutron flux and an irradiation temperature of~330oC, the CANDU reactor is unique with a high thermal spectrum stainless steel components peripheral to the core. In particular, the CANDU design contains an austenitic stainless steel calandria vessel, which contains the heavy water moderator at a temperature of 60-80oC. This article explores the effects of low (60-80oC) and moderate (300-360oC) irradiation temperature on irradiation induced defects and defect sinks, both in ter…
The low energy structures of irradiation-induced defects have been studied in detail, as these determine the available modes by which a defect can diffuse or relax. As a result, there are many studies concerning the relative energies of possible defect structures, and empirical potentials are commonly fitted to or evaluated with respect to these energies. But recently [Dudarev et al Nuclear Fusion 2018], we have shown how to determine the stresses, strains and swelling of reactor components under irradiation from the elastic properties of ensembles of irradiation-induced defects. These elastic…
Elastic interactions play an important role in controlling irradiation damage evolution, but remain largely unexplored experimentally. Using transmission electron microscopy (TEM) and high-resolution on-axis transmission Kikuchi diffraction (HR-TKD), we correlate the evolution of irradiation-induced damage structures and the associated lattice strains in self-ion irradiated pure tungsten. TEM reveals different dislocation loop structures as a function of sample thickness, suggesting that free surfaces limit the formation of extended defect structures found in thicker samples. HR-TKD strain ana…
Proton irradiation of both n-type and semi-insulating bulk samples of \b{eta}-Ga2O3 leads to the formation of one paramagnetic defect with spin S=1/2, monoclinic point symmetry, a g-tensor with principal values of gb=2.0313, gc=2.0079, ga*= 2.0025 and quasi isotropic superhyperfine interaction of 13G with two equivalent Ga neigbours. Its high introduction rate indicates it to be a primary irradiation induced defect. At low temperature, photoexcitation transforms this defect into a different metastable S=1/2 center with principal g-values of gb=2.0064, gc=2.0464, ga*= 2.0024 and a reduced hyper…
Studying the atomic structure of intrinsic defects in two-dimensional transition metal dichalcogenides is difficult since they damage quickly under the intense electron irradiation in transmission electron microscopy (TEM). However, this can also lead to insights into the creation of defects and their atom-scale dynamics. We first show that MoTe 2 monolayers without protection indeed quickly degrade during scanning TEM (STEM) imaging, and discuss the observed atomic-level dynamics, including a transformation from the 1H phase into 1T', three-fold rotationally symmetric defects, and the migrati…
Irradiation-induced lattice defects in silicon carbide (SiC) have already exceeded their previous reputation as purely performance-inhibiting. With their remarkable quantum properties, such as long room-temperature spin coherence and the possibility of downscaling to single-photon source level, they have proven to be promising candidates for a multitude of quantum information applications. One of the most crucial parameters of any quantum system is how long its quantum coherence can be preserved. By using the pulsed optically detected magnetic resonance (ODMR) technique, we investigate the spi…
In this paper, the Fe-20Ni-25Cr alloy that is used for fuel cladding or pressure vessels with various grain boundaries (GBs) was investigated by employing molecular dynamics simulations. The bi-crystals comprised of Σ3(111), Σ3(112), Σ9(114), Σ11(113), Σ19(116), and Σ17(223) types GBs were considered to systematically examine the interplay between irradiation defects, irradiation microstructure evolution under stress, and irradiation mechanical properties with irradiation intensity, coincidence site lattice parameter, tilt angle, and GB thickness. It is found that irradiated vacancies and inte…
Structural as well as magnetization studies have been carried out on graphite samples irradiated by neutrons over 50 years in the CIRUS research reactor at Trombay. Neutron diffraction studies reveal that the defects in irradiated graphite samples are not well annealed and remain significant up to high temperatures much greater than 653 K where the Wigner energy is completely released. We infer that the remnant defects may be intralayer Frenkel defects, which do not store large energy, unlike the interlayer Frenkel defects that store the Wigner energy. Magnetization studies on the irradiated g…
Potential applications of Zr/Al ODS alloys vests on the irradiation stability of the Y4Zr3O12 dispersoids. Fundamental studies to identify the type of defects are important in order to recognize pathways for damage alleviation. In this context, studies relating to identification of point defects and their clusters by in-situ ionoluminescence spectroscopy were taken up. The ionoluminescence spectrum acquired during 100 keV He+ ion irradiation shows two prominent bands, at 330 nm and 415 nm. Using density functional theory calculations with HSE06 hybrid exchange correlation functional, the lumin…
Thin foils of the double solid solution $(Zr{_0.5},Ti{_0.5})_{2}(Al_{0.5},Sn_{0.5})C$ MAX phase were in situ irradiated in a transmission electron microscope (TEM) up to a fluence of $1.3\times10^{17} ions$ $cm^{-2}$ (${\sim}$ 7.5 dpa), using 6 keV $He^{+}$ ions. Irradiations were performed in the 350-800 °C temperature range. In situ and post-irradiation examination (PIE) by TEM was used to study the evolution of irradiation-induced defects as function of dose and temperature. Spherical He bubbles and string-like arrangements thereof, He platelets, and dislocation loops were observed. Disloca…
Here, we report a study on the radiation resistance enhancement of Gd2Zr2O7 nanograin ceramics, in which amorphization, cell volume expansion and multi-stage helium (He) bubble formation are investigated and discussed. Gd2Zr2O7 ceramics with a series of grain sizes (55-221 nm) were synthesized and irradiated by 190 keV He ion beam up to a fluence of 5x10^17 ions/cm2. Both the degree of post irradiation cell volume expansion and the amorphization fraction appear to be size dependent. As the average grain size evolves from 55 to 221 nm, the degree of post irradiation cell volume expansion increa…
Defect engineering is applied to hybrid (CH$_3$NH$_3$)PbI$_3$ organic-inorganic perovskites. These materials have become one of the most promising low-cost alternatives to traditional semiconductors in the field of photovoltaics and light emitting devices. We use here Helium ion irradiation at low energy as a tool for the controlled introduction of point defects in both single crystals and polycrystalline thin films. The irradiation defects modify the opto-electronic properties as probed using photoluminescence spectroscopy from 10K to room-temperature. 2 Contrary to usual semiconductors, we o…
The combination of two-dimensional (2D) materials into heterostructures enabled the formation of atomically thin devices with designed properties. To achieve a high density, bottom-up integration, the growth of these 2D heterostructures via van der Waals epitaxy (vdWE) is an attractive alternative to the currently mostly employed mechanical transfer, which is still problematic in terms of scaling and reproducibility. However, controlling the location of the nuclei formation remains a key challenge in vdWE. Here, we use a focused He ion beam for a deterministic placement of defects in graphene …
Exchange bias stems from the interaction between different magnetic phases and therefore it generally occurs in magnetic multilayers. Here we present a large exchange bias in a single SrRuO3 layer induced by helium ion irradiation. When the fluence increases, the induced defects not only suppress the magnetization and the Curie temperature, but also drive a metal-insulator transition at a low temperature. In particular, a large exchange bias field up to around 0.36 T can be created by the irradiation. This large exchange bias is related to the coexistence of different magnetic and structural p…
The delafossite metals PdCoO$_{2}$, PtCoO$_{2}$ and PdCrO$_{2}$ are among the highest conductivity materials known, with low temperature mean free paths of tens of microns in the best as-grown single crystals. A key question is whether these very low resistive scattering rates result from strongly suppressed backscattering due to special features of the electronic structure, or are a consequence of highly unusual levels of crystalline perfection. We report the results of experiments in which high energy electron irradiation was used to introduce point disorder to the Pd and Pt layers in which …
The dephasing of coherent longitudinal optical (LO) phonons in ion-irradiated GaP has been investigated with a femtosecond pump-probe technique based on electro-optic sampling. The dephasing time of the coherent LO phonon is found to be dramatically prolonged by the introduction of a small amount of defects by means of Ga-ion irradiation. The maximum dephasing time observed at room temperature is 9.1 ps at a Ga$^{+}$ ion dose of 10$^{13}$/cm$^{2}$, which is significantly longer than the value of 8.3 ps for GaP before ion irradiation. The longer dephasing time is explained in terms of the suppr…
Local chemical order suppresses grain boundary migration under irradiation in CrCoNi
University of California, Irvine（加州大学尔湾分校）；Hopkins Extreme Materials Institute, Johns Hopkins University（约翰斯·霍普金斯大学霍普金斯极端材料研究所）；Johns Hopkins University（约翰斯·霍普金斯大学）
Combining spatially resolved X-ray Laue diffraction with atomic-scale simulations, we observe how ion-irradiated tungsten undergoes a series of non-linear structural transformations with increasing irradiation exposure. Nanoscale defect-induced deformations accumulating above 0.02 displacements per atom (dpa) lead to highly fluctuating strains at ~0.1 dpa, collapsing into a driven quasi-steady structural state above ~1 dpa. The driven asymptotic state is characterized by finely dispersed vacancy defects coexisting with an extended dislocation network, and exhibits positive volumetric swelling …
Understanding defect production and evolution under irradiation is a long-standing multi-scale problem. Conventionally, experimental examination of irradiation-induced defects (IIDs) has mainly relied on transmission electron microscopy (TEM), which offers high spatial resolution but requires destructive sample preparation. Furthermore, limited field of view and low strain sensitivity make multi-scale characterisation and quantitative strain measurements difficult. Here we explore the potential of using advanced techniques in the scanning electron microscope (SEM) to non-destructively probe ir…
Twin boundaries have been exploited to stabilize ultrafine grains and improve the mechanical properties of nanomaterials. The production of twin boundaries and nanotwins is however prohibitively challenging in carbide ceramics. Using scanning transmission electron microscopes as a unique platform for atomic-scale structure engineering, we demonstrate that twin platelets could be produced in carbides by engineering antisite defects. Antisite defects at metal sites in various layered ternary carbides are collectively and controllably generated and the metal elements are homogenized by electron i…
Ion-irradiated FeCr alloys are useful for understanding and predicting neutron-damage in the structural steels of future nuclear reactors. Previous studies have largely focused on the structure of irradiation-induced defects, probed by transmission electron microscopy (TEM), as well as changes in mechanical properties. Across these studies, a wide range of irradiation conditions has been employed on samples with different processing histories, which complicates the analysis of the relationship between defect structures and material properties. Furthermore, key properties, such as irradiation-i…
Understanding the mechanisms of plasticity in structural steels is essential for the operation of next-generation fusion reactors. Elemental composition, particularly the amount of Cr present, and irradiation can have separate and synergistic effects on the mechanical properties of ferritic/martensitic steels. The study of ion-irradiated FeCr alloys is useful for gaining a mechanistic understanding of irradiation damage in steels. Previous studies of ion-irradiated FeCr did not clearly distinguish between the nucleation of dislocations to initiate plasticity, and their propagation through the …
