Low-temperature formation of platinum silicides on polycrystalline silicon

探测超薄钛硅化物的形成与外延生长使用低能和中等能量离子散射

Probing formation and epitaxy of ultrathin Titanium Silicide using low and medium energy ion scattering

研究通过低能和中等能量离子散射技术探测超薄钛硅化物的形成与外延生长，揭示了界面有序性对电子性能的影响及硅化物层厚度的变化。

Effect of grain shape on the agglomeration of polycrystalline thin films

Grain-boundary grooving is a general phenomenon occurring in all polycrystalline materials at the intersection between the grain-boundary and the interface or free surface. It has been studied theoretically for some time. Grain-boundary grooving in the context of faceted interfaces in particular has attracted some attention. However, these works did not consider the case of thin films and the consequences on agglomeration of the shape of the interface. In this Letter, we compare the agglomeration of thin films with rounded and faceted interfaces. The shape of the grains can dramatically affect…

Infrared-induced ultrafast melting of nanostructured platinum films probed by an X-ray free-electron laser

Understanding melting in metals is a hot topic of present research. This may be accomplished by pumping the system with infrared (IR) laser radiation, and probing it with hard X-rays produced by an X-ray Free-Electron Laser (XFEL). In this work we studied nanostructured polycrystalline thin films of platinum that were illuminated by IR radiation of increasing fluences. We characterized the structural response as well as the nucleation and propagation of the liquid phase as a function of time delay between the IR pump and X-ray probe. We observed partial melting of the samples for IR fluences h…

Real space texture and pole figure analysis using the three-dimensional pair distribution function (PDF) on a Platinum thin film

An approach is described for studying texture in nanostructured materials. The approach implements the real space texture PDF, txPDF, laid out in [Gong and Billinge (2018) arXiv:1805.10342 [cond-mat]]. It is demonstrated on a fiber textured polycrystalline Pt thin film. The approach uses 3D PDF methods to reconstruct the orientation distribution function (ODF) of the powder crystallites from a set of diffraction patterns taken at different tilt angles of the substrate with respect to the incident beam directly from the 3D PDF of the sample. A real space equivalent of the reciprocal space pole …

Grain-boundary grooving and agglomeration of alloy thin films with a slow-diffusing species

We present a general phase-field model for grain-boundary grooving and agglomeration of polycrystalline alloy thin films. In particular, we study the effects of slow-diffusing species on grooving rate. As the groove grows, the slow species becomes concentrated near the groove tip so that further grooving is limited by the rate at which it diffuses away from the tip. At early times the dominant diffusion path is along the boundary, while at late times it is parallel to the substrate. This change in path strongly affects the time-dependence of grain boundary grooving and increases the time to ag…

Microstructure-dependent local strain behavior in polycrystals through in situ scanning electron microscope tensile experiments

Digital image correlation of laser-ablated platinum nanoparticles on the surface of a polycrystalline metal (nickel-based superalloy Rene 88DT) was used to obtain the local strain behavior from an in situ scanning electron microscope tensile experiment at room temperature. By fusing this information with crystallographic orientations from EBSD, a subsequent analysis shows that the average maximum shear strain tends to increase with increasing Schmid factor. Additionally, the range of the extreme values for the maximum shear strain also increases closer to the grain boundary, signifying that gr…

Phase-field model for grain boundary grooving in multi-component thin films

Polycrystalline thin films can be unstable with respect to island formation (agglomeration) through grooving where grain boundaries intersect the free surface and/or thin film-substrate interface. We develop a phase-field model to study the evolution of the phases, composition, microstructure and morphology of such thin films. The phase-field model is quite general, describing compounds and solid solution alloys with sufficient freedom to choose solubilities, grain boundary and interface energies, and heats of segregation to all interfaces. We present analytical results which describe the inte…

Low-temperature synthesis and electrocatalytic application of large-area PtTe2 thin films

The synthesis of transition metal dichalcogenides (TMDs) has been a primary focus for 2D nanomaterial research over the last 10 years, however, only a small fraction of this research has been concentrated on transition metal ditellurides. In particular, nanoscale platinum ditelluride (PtTe2) has rarely been investigated, despite its potential applications in catalysis, photonics and spintronics. Of the reports published, the majority examine mechanically-exfoliated flakes from chemical vapor transport (CVT) grown crystals. While this production method is ideal for fundamental studies, it is ve…

Pd、Pt、Rh和Ir通过固相外延形成的超导锗化物与锗硅化物薄膜的表征

Characterization of superconducting germanide and germanosilicide films of Pd, Pt, Rh and Ir formed by solid-phase epitaxy

本研究比较了Pt、Pd、Rh和Ir锗化物的超导特性，发现通过固相外延在最佳条件下形成的Ir(Si)Ge薄膜临界温度达3.4 K，且与Ge基底形成清晰界面。