The waveform of a compact binary coalescence is predicted by general relativity. It is therefore possible to directly constrain the response of a gravitational-wave (GW) detector by analyzing a signal's observed amplitude and phase evolution as a function of frequency. GW signals alone constrain the relative amplitude and phase between different frequencies within the same detector and between different detectors. We analyze GW170817's ability to calibrate the LIGO/Virgo detectors, finding a relative amplitude calibration precision of approximately $\pm20\%$ and relative phase precision of $\pm15^\circ$ (1-$σ$ uncertainty) between the LIGO Hanford and Livingston detectors. Incorporating additional information about the distance and inclination of the source from electromagnetic observations, the relative amplitude of the LIGO detectors can be tightened to $\sim\pm15\%$. We investigate the ability of future events to improve astronomical calibration. By simulating the cumulative uncertainties from an ensemble of detections, we find that with several hundred events with electromagnetic counterparts, or several thousand events without counterparts, we reach percent-level astronomical calibration. This corresponds to $\sim$5-10 years of operation at advanced LIGO and Virgo design sensitivity. It is to be emphasized that direct {\em in-situ}\/ measurements of detector calibration provide significantly higher precision than astronomical sources, and already constrain the calibration to a few percent in amplitude and a few degrees in phase. In this sense, our astronomical calibrators only corroborate existing calibration measurements. Nonetheless, astrophysical calibration may become an important corroboration of existing calibration methods, providing a completely independent constraint of potential systematics.
Pulsed UV lasers can provide useful "testbeams" for observatories that use optical detectors, especially fluorescence detectors, to measure high energy cosmic-rays. The light observed by the detector is proportional to the energy of the laser pulse. Since the absolute laser energy can be measured locally, a well-calibrated laser offers a practical way to test the photometric calibration of the cosmic-ray detector including atmospheric corrections. This poster will describe a robotic system for laser polarization and energy calibration. Laboratory measurements of laser energies and polarization…
Current methods for detector gain calibration require acquisition of tens of special calibration images. Here we propose a method that obtains the gain from the actual image for which the photon count is desired by quantifying out-of-band information. We show on simulation and experimental data that our much simpler procedure, which can be retroactively applied to any image, is comparable in precision to traditional gain calibration procedures.
The Omicron software is a tool developed to perform a multi-resolution time-frequency analysis of data from gravitational-wave detectors: the LIGO, Virgo, and KAGRA detectors. Omicron generates spectrograms from whitened data streams, offering a visual representation of transient detector noises and gravitational-wave events. In addition, these events can be parameterized with an optimized resolution. They can be written to disk to conduct offline noise characterization and gravitational-wave event validation studies. Omicron is optimized to process, in parallel, thousands of data streams reco…
We present a review of modern optical techniques being used and developed for the field of gravitational wave detection. We describe the current state-of-the-art of gravitational waves detector technologies with regard to optical layouts, suspensions and test masses. We discuss the dominant sources and noise in each of these subsystems and the developments that will help mitigate them for future generations of detectors. We very briefly summarise some of the novel astrophysics that will be possible with these upgraded detectors.
Resonant-mass gravitational waves detectors are reviewed from the concept of gravitational waves and its mathematical derivation, using Einstein's general relativity, to the present status of bars and spherical detectors, and their prospects for the future, which include dual detectors and spheres with non-resonant transducers. The review covers not only the technical aspects of detectors and the science that will be done, but also analyses the subject in a historic perspective, covering the various detection efforts over four decades, starting from Weber's pioneering work.
We used a sample of 11 nearby relaxed clusters of galaxies observed with the X-ray instruments XMM-Newton (EPIC) pn and MOS, Chandra ACIS-S and ACIS-I and BeppoSAX MECS to examine the cross-calibration of the energy dependence and normalisation of the effective area of these instruments as of December 2009. We also examined the Fe XXV/XXVI line ratio temperature measurement method for the pn and MOS. We performed X-ray spectral analysis on the XMM-Newton and Chandra data for a sample of 11 clusters. We obtained the information for BeppoSAX from DeGrandi & Molendi (2002). We compared the spectr…
Gravitational wave is a propagation of space-time distortion, which is predicted by Einstein in general relativity. Strong gravitational waves will come from some drastic astronomical objects, e.g. coalescence of neutron star binaries, black holes, supernovae, rotating pulsars and pulsar glitches. Detection of the gravitational waves from these objects will open a new door of \textit{`gravitational wave astronomy'}. Gravitational wave will be a probe to study the physics and astrophysics. To search these gravitational waves, large-scale laser interferometers will compose a global network of de…
Localizing the sky position of the gravitational wave source is a key scientific goal for gravitational wave observations. Employing the Fisher information matrix approximation, we compute the angular resolutions of LISA and TianQin, two planned space-based gravitational wave detectors and examine how detectors' configuration properties, such as the orientation change of the detector plane, heliocentric or geocentric motion and the arm length etc. affect the accuracy of source localization. We find that the amplitude modulation due to the annual changing orientation of the detector plane helps…
A major challenge of any search for gravitational waves is to distinguish true astrophysical signals from those of terrestrial origin. Gravitational-wave experiments therefore make use of multiple detectors, considering only those signals which appear in coincidence in two or more instruments. It is unclear, however, how to interpret loud gravitational-wave candidates observed when only one detector is operational. In this paper, we demonstrate that the observed rate of binary black hole mergers can be leveraged in order to make confident detections of gravitational-wave signals with one detec…
The reliability of the first detection is one of the most interesting challenges for the gravitational wave community. To increase the detection confidence, the LIGO and Virgo collaborations have already started coincident observations between gravitational waves detectors and other astronomical instruments, like electromagnetic or neutrino detectors. This can be done in two directions: searching for gravitational waves triggered by the electromagnetic information, or pointing the electromagnetic telescopes to the sky position given in real time by the gravitational wave analysis. The success …
A folded resonant Fabry-Perot cavity has the potential to significantly reduce the impact of coating thermal noise on the performance of kilometer scale gravitational wave detectors. When constructed using only spherical mirror surfaces it is possible to utilize the extremely robust $TEM_{00}$ mode optical mode. In this paper we investigate the potential thermal noise improvements that can be achieved for third generation gravitational wave detectors using realistic constraints. Comparing the previously proposed beam configurations such as e.g. higher order Laguerre-Gauss modes, we find that s…
Coincident observations with gravitational wave (GW) detectors and other astronomical instruments are in the focus of the experiments with the network of LIGO, Virgo and GEO detectors. They will become a necessary part of the future GW astronomy as the next generation of advanced detectors comes online. The success of such joint observations directly depends on the source localization capabilities of the GW detectors. In this paper we present studies of the sky localization of transient sources with the future advanced detector networks and describe their fundamental properties. By reconstruct…
Parametric instability is an intrinsic risk in high power laser interferometer gravitational wave detectors, in which the optical cavity modes interact with the acoustic modes of the mirrors leading to exponential growth of the acoustic vibration. In this paper, we investigate the potential parametric instability for a proposed next generation gravitational wave detector based on cooled silicon test masses. It is shown that there would be about 2 unstable modes per test mass, with the highest parametric gain of ~76. The importance of developing suitable instability suppression schemes is empha…
In situ substrate birefringence characterization in gravitational wave detectors using a heterodyne polarimetry method
Cardiff University（卡迪夫大学）；The University of Tokyo（东京大学）；University of Birmingham（伯明翰大学）；Nikhef, National Institute for Subatomic Physics（荷兰国家亚原子物理研究所）；University of Glasgow（格拉斯哥大学）；Universit‘ a di Trento（特伦托大学）
The gravitational wave detector of higher sensitivity and greater bandwidth in kilohertz window is required for future gravitational wave astronomy and cosmology. Here we present a new type broadband high frequency laser interferometer gravitational wave detector utilizing polarization of light as signal carrier. Except for Fabry-Perot cavity arms we introduce dual power recycling to further amplify the gravitational wave signals. A novel method of weak measurement amplification is used to amplify signals for detection and to guarantee the long-term run of detector. Equipped with squeezed ligh…
We investigate a Bose-Einstein condensate (BEC) as a gravitational wave detector, and study its sensitivity by optimizing the properties of the condensate and the measurement duration. We show that detecting kilohertz gravitational waves is limited by current experimental techniques in squeezing BEC phonons. Future improvements in technology to squeeze BEC states can make them competitive detectors for gravitational waves of astrophysical and/or cosmological origin.
The ongoing global effort to detect gravitational waves continues to push the limits of precision measurement while aiming to provide a new tool for understanding both astrophysics and fundamental physics. Squeezed states of light offer a proven means of increasing the sensitivity of gravitational wave detectors, potentially increasing the rate at which astrophysical sources are detected by more than an order of magnitude. Since radiation pressure noise plays an important role in advanced detectors, frequency dependent squeezing will be required. In this paper we propose a practical approach t…
Next-generation global gravitational-wave detector network: Impact of detector orientation on compact binary coalescence and stochastic gravitational-wave background searches
We optimize the third-generation gravitational-wave detector to maximize the range to detect core-collapse supernovae. Based on three-dimensional simulations for core-collapse and the corresponding gravitational-wave waveform emitted, the corresponding detection range for these waveforms is limited to within our galaxy even in the era of third-generation detectors. The corresponding event rate is two per century. We find from the waveforms that to detect core-collapse supernovae with an event rate of one per year, the gravitational-wave detectors need a strain sensitivity of 3$\times10^{-27}~$…
We describe an atom interferometric gravitational wave detector design that can operate in a resonant mode for increased sensitivity. By oscillating the positions of the atomic wavepackets, this resonant detection mode allows for coherently enhanced, narrow-band sensitivity at target frequencies. The proposed detector is flexible and can be rapidly switched between broadband and narrow-band detection modes. For instance, a binary discovered in broadband mode can subsequently be studied further as the inspiral evolves by using a tailored narrow-band detector response. In addition to functioning…
We propose a blind, template-free method for the extraction of a common signal between the Hanford and Livingston detectors and apply it especially to the GW150914 event. We construct a log-likelihood method that maximizes the cross-correlation between each detector and the common signal and minimizes the cross-correlation between the residuals. The reliability of this method is tested using simulations with an injected common signal. Finally, our method is used to assess the quality of theoretical gravitational wave templates for GW150914.
Noise of non-astrophysical origin will contaminate science data taken by the Advanced Laser Interferometer Gravitational-wave Observatory (aLIGO) and Advanced Virgo gravitational-wave detectors. Prompt characterization of instrumental and environmental noise transients will be critical for improving the sensitivity of the advanced detectors in the upcoming science runs. During the science runs of the initial gravitational-wave detectors, noise transients were manually classified by visually examining the time-frequency scan of each event. Here, we present three new algorithms designed for the …
I expand on the results of a recent work in which a novel weighting algorithm was shown to substantially increase the accuracy of an old, non-Bayesian computational approach for inferring the source direction of a gravitational wave from the output of a two-detector network. While that work was limited to the consideration of circularly polarized gravitational waves, the current analysis shows that the same approach is even more successful when applied to the generic case of elliptically polarized gravitational waves.
We consider the optimal site selection of future generations of gravitational wave detectors. Previously, Raffai et al. optimized a 2-detector network with a combined figure of merit. This optimization was extended to networks with more than two detectors in a limited way by first fixing the parameters of all other component detectors. In this work we now present a more general optimization that allows the locations of all detectors to be simultaneously chosen. We follow the definition of Raffai et al. on the metric that defines the suitability of a certain detector network. Given the location…
We report the preparation of a Kr-83m source and its subsequent use in calibrating a liquid xenon detector. Kr-83m atoms were produced through the decay of Rb-83 atoms trapped in zeolite molecular sieve and were then introduced into liquid xenon. Decaying Kr-83m nuclei were detected through liquid xenon scintillation. Conversion electrons with energies of 9.4 keV and 32.1 keV from the decay of Kr-83m were both observed. This calibration source will allow the characterization of the scintillation and ionization response of noble liquid detectors at low energies, highly valuable for the search f…
Pre-Big-Bang models in string cosmology predict a relic background of gravitational wave radiation in the early universe. The spectrum of this background shows that the energy density rises rapidly with frequency, which is an interesting target for high-frequency (i.e., kilohertz) detectors. In this paper, we discussed the constraining power of multiple configurations of current and future gravitational wave detector (GWD) networks to the stochastic background predicted in string cosmology. The constraining power is jointly determined by the overlap reduction function and the sensitivity curve…
The detection of particles with only gravitational interactions (Newtorites) in gravitational bar detectors was studied in 1984 by Bernard, De Rujula and Lautrup. The negative results of dark matter searches suggest to look to exotic possibilities like Newtorites. The limits obtained with the Nautilus bar detector will be presented and the possible improvements will be discussed. Since the gravitational coupling is very weak, the possible limits are very far from what is needed for dark matter, but for large masses are the best limits obtained on the Earth. An update of limits for MACRO partic…
The next generation of gravitational wave detectors will improve the detection prospects for gravitational waves from core-collapse supernovae. The complex astrophysics involved in core-collapse supernovae pose a significant challenge to modeling such phenomena. The Supernova Model Evidence Extractor (SMEE) attempts to capture the main features of gravitational wave signals from core-collapse supernovae by using numerical relativity waveforms to create approximate models. These models can then be used to perform Bayesian model selection to determine if the targeted astrophysical feature is pre…
