The dusty regolith covering the surfaces of asteroids and planetary satellites differs in size, shape, and composition from terrestrial soil particles and is subject to very different environmental conditions. Experimental studies of the response of planetary regolith in the relevant environmental conditions are thus necessary to facilitate future Solar System exploration activities. We combined the results and provided new data analysis elements for a series of impact experiments into simulated planetary regolith in low-gravity conditions using two experimental setups: the Physics of Regolith Impacts in Microgravity Experiment (PRIME) and the COLLisions Into Dust Experiment (COLLIDE). Results of these experimental campaigns found that there is a significant change in the regolith behavior with the gravity environment. In a 10-2g environment (Lunar g levels), only embedding of the impactor was observed and ejecta production was produced for most impacts at > 20 cm/s. Once at microgravity levels (<10-4g), the lowest impact energies also produced impactor rebound. In these microgravity conditions, ejecta started to be produced for impacts at > 10 cm/s. The measured ejecta speeds were lower than the ones measured at reduced-gravity levels, but the ejected masses were higher. The mean ejecta velocity shows a power-law dependence on the impact energy with an index of ~0.7. When projectile rebound occurred, we observed that its coefficients of restitution on the bed of regolith simulant decrease by a factor of 10 with increasing impact speeds from ~5 cm/s up to 100 cm/s. We could also observe an increased cohesion between the JSC-1 grains compared to the quartz sand targets.
Shape, regolith size and thickness, SMFe^0 content, and spectral type of Tianwen-2 target asteroid (469219) Kamo'oalewa
Center for Lunar and Planetary Sciences, Institute of Geochemistry, Chinese Academy of Sciences(中国科学院地球化学研究所);State Key Laboratory of Lunar and Planetary Sciences, Macau University of Science and Technology(澳门科技大学);School of Engineering, Guangzhou College of Technology and Business(广州工商学院);ESA ESRIN/PDO/NEO Coordination Centre(欧洲航天局地球系统数据中心);Deimos Italia;Aix Marseille Université, CNRS, CNES, Laboratoire d’Astrophysique de Marseille(马赛大学);Institute of Analysis and testing, Beijing Academy of Science and Technology, Beijing Center for Physical & Chemical Analysis(北京科学院测试技术研究所);Chongqing University State Key Laboratory of Power Transmission Equipment and System Security and New Technology, Institute of Systems Engineering, Chongqing(重庆大学);Shandong Key Laboratory of Optical Astronomy and Solar-Terrestrial Environment, School of Space Science and Physics, Institute of Space Sciences, Shandong University(山东大学);State Key Laboratory of Space Weather, National Space Science Center, Chinese Academy of Sciences(中国科学院国家空间科学中心)
Developing and characterizing a new-generation regolith simulant "IGCAS-AST01" for the Tianwen-2 target asteroid (469219) Kamo'oalewa
Center for Lunar and Planetary Sciences, Institute of Geochemistry, Chinese Academy of Sciences(中国科学院地球化学研究所月球与行星科学中心);School of Earth Sciences, China University of Geosciences(中国地质大学地球科学学院);Department of Earth, Environmental and Planetary Sciences, Brown University(布朗大学地球、环境与行星科学系);Institute of Analysis and testing, Beijing Academy of Science and Technology, Beijing Center for Physical & Chemical Analysis(北京科学院测试技术研究所,北京物理化学分析中心);Department of Geography, University of Winnipeg(温尼伯大学地理系);State Key Laboratory of Lunar and Planetary Sciences, Macau University of Science and Technology(澳门科技大学月球与行星科学国家重点实验室);ESA ESRIN/PDO/NEO Coordination Centre(欧洲空间局ESRIN/PDO近地天体协调中心);Deimos Italia;China Academy of Aerospace Science and Innovation(中国航天科技创新研究院);Key Laboratory of Space Active Opto-Electronics Technology, Shanghai Institute of Technical Physics, Chinese Academy of Sciences(中国科学院上海技术物理研究所空间主动光电技术重点实验室);National Astronomical Observatories, Chinese Academy of Sciences(中国科学院国家天文台);Institute of Geology and Geophysics, Chinese Academy of Sciences(中国科学院地质与地球物理研究所);China Academy of Space Technology(中国空间技术研究院)
Mid-IR Observations of IRAS, AKARI, WISE/NEOWISE and Subaru for Large Icy Asteroid (704) Interamnia: a New Perspective of Regolith Properties and Water Ice Fraction
Physical Analysis of Bennu Samples Reveals Regolith Production by Collisional Disruption on Near-Earth Asteroids
Johns Hopkins University Applied Physics Laboratory(约翰斯·霍普金斯大学应用物理实验室);Lunar and Planetary Laboratory, University of Arizona(亚利桑那大学月球与行星实验室);Vatican Observatory(梵蒂冈天文台);Hopkins Extreme Materials Institute, Johns Hopkins University(约翰斯·霍普金斯大学霍普金斯极端材料研究所);Jacobs-JETS, NASA Johnson Space Center(NASA约翰逊航天中心雅各布斯-JETS);University of Calgary(卡尔加里大学);EAPS, Massachusetts Institute of Technology(麻省理工学院地球、大气与行星科学系);Arizona State University(亚利桑那州立大学);National Air and Space Museum, Smithsonian Institution(史密森尼学会国家航空和航天博物馆);Astromaterials Research and Exploration Science (ARES), NASA Johnson Space Center(NASA约翰逊航天中心天体物质研究与探索科学部);Planetary Science Institute(行星科学研究所);INAF, Astronomical Observatory of Padova(意大利国家天体物理研究所帕多瓦天文台);University of Rochester(罗切斯特大学);Southwest Research Institute(西南研究院);Department of Geology, Rowan University(罗恩大学地质系);Department of Earth and Planetary Sciences, American Museum of Natural History(美国自然历史博物馆地球与行星科学系)
Low thermal conductivity of the superfast rotator (499998) 2011 PT
背景:直径达几十米的小行星可能旋转得非常快,并在几分钟内完成整个旋转。这些小而快速旋转的物体被认为是整体物体,因为它们的小尺寸所产生的引力不足以抵消快速旋转所产生的强大向心力。此外,尚不清楚快速旋转是否会阻止灰尘和小颗粒(风化层)留在其表面。目的:我们开发了一个模型,用于限制小型快速旋转的近地小行星表面的热导率。这个模型可能表明这些物体上是否可能存在风化层。研究方法:我们的方法是基于测量的Yarkovsky漂移和预测值的比较,使用的理论模型,取决于轨道,物理和热参数的对象。必要的参数要么从近地小行星群的统计分布中推导出来,要么从具有相关不确定性的观测中确定。利用这些信息,我们进行了蒙特卡罗模拟,并产生了热导率的概率密度分布。结果如下:将我们的模型应用于超高速旋转小行星(499998)2011 PT,我们发现只有当小行星表面的热导率$K$较低时,才能测量到Yarkovsky漂移。所得的电导率的概率密度函数是双峰的,其中两个最可能的值为约0.0001和0.005 W m $^{-1}$ K $^{-1}$。在此基础上,我们发现$K$小于0. 1 W m $^{-1}$ K $^{-1}$的概率至少为95%。这种低导热性可能表明2011 PT的表面覆盖着一层隔热层,由类似月球尘埃的风化物组成。
The low surface thermal inertia of the rapidly rotating near-Earth asteroid 2016 GE1
据观测,小于100米的小行星自转速度非常快,其周期通常比2.2小时的临界极限短得多。这些超高速旋转器中的一些还可以实现由雅科夫斯基效应引起的非常大的半长轴漂移,这反过来又由内部和表面物理性质决定。我们认为小型超高速旋转的近地小行星2016 GE1。这个天体旋转仅需34秒,并且已经从天体测量学中确定了一个大的Yarkovsky效应。在这里,我们的目标是限制这个极端物体表面的热惯性。我们使用最近开发的统计方法来确定近地小行星的热特性。该方法是基于观察到的和模拟的Yarkovsky效应之间的比较,和热导率(惯性)由蒙特卡洛方法确定。雅科夫斯基效应模型的参数要么是固定的,如果它们的不确定性可以忽略不计,如果它们被测量,则用高斯分布的误差建模,或者在它们未知时从近地小行星群的一般特性推导出来。使用完善的轨道确定程序,我们确定了2016 GE1上的Yarkovsky效应,并验证了显着的半长轴漂移率。使用统计方法,我们发现,这种半长轴漂移率可以解释只有低的热惯性值低于100焦耳米$^{-2}$ K $^{-1}$ S $^{-1/2}$:即,90%的概率密度函数的模型结果包含在值小于100焦耳米$^{-2}$ K $^{-1}$ S $^{-1/2}$。我们提出了两种可能的解释极低的值:高孔隙度或开裂的表面,或在表面上的细风化层的薄层。虽然这在任何一种情况下似乎都是出乎意料的,但它开辟了一个低热…