Heiko Augustin, Niklaus Berger, Sebastian Dittmeier, Carsten Grzesik, Jan Hammerich, Qinhua Huang, Lennart Huth, Moritz Kiehn, Alexandr Kozlinskiy, Frank Meier … 展开作者
Heiko Augustin, Niklaus Berger, Sebastian Dittmeier, Carsten Grzesik, Jan Hammerich, Qinhua Huang, Lennart Huth, Moritz Kiehn, Alexandr Kozlinskiy, Frank Meier Aeschbacher, Ivan Perić, Ann-Kathrin Perrevoort, André Schöning, Shruti Shrestha, Dorothea vom Bruch, Frederik Wauters, Dirk Wiedner
备注：
Replaced with final version accepted by the publisher
Mu3e is a novel experiment searching for charged lepton flavor violation in the rare decay $μ^+ \rightarrow e^+e^-e^+$. Decay vertex position, decay time and particle momenta have to be precisely measured in order to reject both accidental and physics background. A silicon pixel tracker based on $50\,μ$m thin high voltage monolithic active pixel sensors (HV-MAPS) in a 1 T solenoidal magnetic field provides precise vertex and momentum information. The MuPix chip combines pixel sensor cells with integrated analog electronics and a periphery with a complete digital readout. The MuPix7 is the first HV-MAPS prototype implementing all functionalities of the final sensor including a readout state machine and high speed serialization with 1.25 Gbit/s data output, allowing for a streaming readout in parallel to the data taking. The observed efficiency of the MuPix7 chip including the full readout system is $\geq99\%$ in a high rate test beam.
The MuPix7 chip is a monolithic HV-CMOS pixel chip, thinned down to 50 μm. It provides continuous self-triggered, non-shuttered readout at rates up to 30 Mhits/chip of 3x3 mm^2 active area and a pixel size of 103x80 μm^2. The hit efficiency depends on the chosen working point. Settings with a power consumption of 300 mW/cm^2 allow for a hit efficiency >99.5%. A time resolution of 14.2 ns (Gaussian sigma) is achieved. Latest results from 2016 test beam campaigns are shown.
Many years of research and development of High Voltage Monolithic Active Pixel Sensors (HVMAPS) have culminated in the final design for the Mu3e pixel sensor. MuPix10 is a fully monolithic sensor with an active pixel matrix size of $20\times20\,\mathrm{mm}^2$ produced in the $180\,\mathrm{nm}$ HV-CMOS process at TSI Semiconductors. The pixel size is $80\times80\,\mathrm{μm}^2$. Hits are read out using a column-drain architecture and sent over up to four serial links with up to $1.6\,\left.\mathrm{Gbit}\middle/\mathrm{s}\right.$ each. By means of DC/DC converters and exclusive usage of on-chip …
The MuPix Telescope is a particle tracking telescope, optimized for tracking low momentum particles and high rates. It is based on the novel High-Voltage Monolithic Active Pixel Sensors (HV-MAPS), designed for the Mu3e tracking detector. The telescope represents a first application of the HV-MAPS technology and also serves as test bed of the Mu3e readout chain. The telescope consists of up to eight layers of the newest prototypes, the MuPix7 sensors, which send data self-triggered via fast serial links to FPGAs, where the data is time-ordered and sent to the PC. A particle hit rate of 1 MHz pe…
The Mu3e experiment searches for the lepton flavor violating decay $μ^+~\rightarrow~e^+~e^+~e^-$ with an ultimate aimed sensitivity of 1 event in $10^{16}$ decays. This goal can only be achieved by reducing the material budget per tracking layer to $X/X_0 \approx 0.1 \%$. High-Voltage Monolithic Active Pixel Sensors (HV-MAPS) which are thinned to $50\ μm$ serve as sensors. Gaseous helium is chosen as coolant. Results of recent studies related to the sensor prototypes, the helium cooling, and module prototyping are presented. The recent chip submission MuPix10 has proven its functionality regar…
The Mu3e experiment is searching for the charged lepton flavour violating decay $ μ^+\rightarrow e^+ e^- e^+ $, aiming for an ultimate sensitivity of one in $10^{16}$ decays. In an environment of up to $10^9$ muon decays per second the detector needs to provide precise vertex, time and momentum information to suppress accidental and physics background. The detector consists of cylindrical layers of $50\, μ\text{m}$ thin High Voltage Monolithic Active Pixel Sensors (HV-MAPS) placed in a $1\,\text{T}$ magnetic field. The measurement of the trajectories of the decay particles allows for a precise…
High-Voltage Monolithic Active Pixel Sensors (HV-MAPS) based on the 180 nm HV-CMOS process have been proposed to realize thin, fast and highly integrated pixel sensors. The MuPix7 prototype, fabricated in the commercial AMS H18 process, features a fully integrated on-chip readout, i.e. hit-digitization, zero suppression and data serialization. It is the first fully monolithic HV-CMOS pixel sensor that has been tested for the use in high irradiation environments like HL-LHC. We present results from laboratory and test beam measurements of MuPix7 prototypes irradiated with neutrons (up to $5.0\c…
High Voltage Monolithic Active Pixel Sensors (HV-MAPS) are based on a commercial High Voltage CMOS process and collect charge by drift inside a reversely biased diode. HV-MAPS represent a promising technology for future pixel tracking detectors. Two recent developments are presented. The MuPix has a continuous readout and is being developed for the Mu3e experiment whereas the ATLASPix is being developed for LHC applications with a triggered readout. Both variants have a fully monolithic design including state machines, clock circuitries and serial drivers. Several prototypes and design variant…
Coherent elastic neutrino-nucleus scattering (CE$ν$NS) offers a valuable approach in searching for physics beyond the Standard Model. The Ricochet experiment aims to perform a precision measurement of the CE$ν$NS spectrum at the Institut Laue-Langevin (ILL) nuclear reactor with cryogenic solid-state detectors. The experiment will employ an array of cryogenic thermal detectors, each with a mass of around 30 g and an energy threshold of 50 eV. One section of this array will contain 9 Transition Edge Sensor (TES) based calorimeters. The design will not only fulfill requirements for Ricochet, but …
This paper presents the experimental results of $17~MeV$ proton irradiation on a $60~GHz$ low power, half-duplex transceiver (TRX) chip implemented in $65~nm$ CMOS technology. It supports short range point-to-point data rate up to $6~Gbps$ by employing on-off keying (OOK). To investigate the irradiation hardness for high energy physics applications, two TRX chips were irradiated with total ionizing doses (TID) of $74~kGy$ and $42~kGy$ and fluence of $1.4~\times$10$^{14}~ N_{eq}/cm^2$ and $0.8~\times$10$^{14}~N_{eq}/cm^2$ for RX and TX modes, respectively. The chips were characterized by pre- a…
In the context of the Silicon tracking for a Linear Collider (SiLC) R&D collaboration, a highly compact mixed-signal chip has been designed in 130nm CMOS technology intended to read Silicon strip detectors for the experiments at the future International Linear Collider. The chip includes eighty eight channels of a full analog signal processing chain and analog to digital conversion with the corresponding digital controls and readout channels. The chip is 5x10mm2 where the analog implementation represents 4/5 of the total Silicon area.
A new silicon-strip readout chip named "SliT" has been developed for the measurement of the muon anomalous magnetic moment and electric dipole moment at J-PARC. The SliT is designed in the Silterra 180 nm CMOS technology with mixed-signal integrated circuits. An analog circuit incorporates a conventional charge-sensitive amplifier, shaping amplifiers, and two distinct discriminators for each of 128 identical channels. A digital part includes storage memories, an event building block, a serializer, and LVDS drivers. A distinct feature of the SliT is utilization of the zero-cross architecture, w…
CHIPS (CHerenkov detectors In mine PitS ) is a novel neutrino detector concept, aimed at building megaton water-Cherenkov neutrino detectors in a flexible and cheap way, while yielding science results comparable and contributing to conventional long-baseline neutrino experiments. In the summer of 2018, a 5 kiloton proof-of-principle detector will be installed in a disused water-filled mine pit located in the NuMI neutrino beamline path in Minnesota, USA. The submerged cylindrical detector volume is 25 meters in diameter and 10 meter tall and is surrounded by light-tight liners. All inside wall…
Characteristics of high sensitivity MEMS pressure sensor chip for 10 kPa utilizing a novel electrical circuit are presented. The electrical circuit uses piezosensitive differential amplifier with negative feedback loop (PDA-NFL) based on two bipolar-junction transistors (BJT). The BJT has a vertical structure of n-p-n type (V-NPN) formed on a non-deformable chip area. The circuit contains eight piezoresistors located on a profiled membrane in the areas of maximum mechanical stresses. The experimental results prove that pressure sensor chip PDA-NFL with 4.0x4.0 mm2 chip area has sensitivity S =…
The RD53 collaboration is currently designing a large scale prototype pixel readout chip in 65 nm CMOS technology for the phase 2 upgrades at the HL-LHC. The RD53A chip will be available by the end of the year 2017 and will be extensively tested to confirm if the circuit and the architecture make a solid foundation for the final pixel readout chips for the experiments at the HL-LHC. A test and data acquisition system for the RD53A chip is currently under development to perform single-chip and multi-chip module measurements. In addition, the verification of the RD53A design is performed in a de…
The phase-2 upgrade of the LHC will require novel pixel readout chips, which deliver hit information at drastically increased data rates and tolerate unprecedented radiation levels. The large-scale prototype chip RD53A has been designed by the RD53 collaboration and manufactured in a 65 nm CMOS process, suitable for the innermost layers of both the ATLAS and the CMS experiment. In order to verify the radiation hardness design goal of 500 Mrad total ionizing dose, RD53A has been irradiated using X-rays. The radiation effects on the performance of the data link, reset circuit and the clock gener…
Most atomic physics experiments are controlled by a digital pattern generator used to synchronize all equipment by providing triggers and clocks. Recently, the availability of well-documented open-source development tools has lifted the barriers to using programmable systems on chip (PSoC), making them a convenient and versatile tool for synthesizing digital patterns. Here, we take advantage of these advancements in the design of a versatile clock and pattern generator using a PSoC. We present our design with the intent of highlighting the new possibilities that PSoCs have to offer in terms of…
