The theoretical effects of phase separation on encounter-limited charge carrier recombination in organic semiconductor blends are investigated using kinetic Monte Carlo (KMC) simulations of pump-probe experiments. Using model bulk heterojunction morphologies, the dependence of the recombination rate on domain size and charge carrier mobility are quantified. Unifying competing models and simulation results, we show that the mobility dependence of the recombination rate can be described using the power mean of the electron and hole mobilities with a domain size dependent exponent. Additionally, for domain sizes typical of organic photovoltaic devices, we find that phase separation reduces the recombination rate by less than one order of magnitude compared to the Langevin model and that the mobility dependence can be approximated by the geometric mean.
Understanding how the complex intermolecular- and nano-structure present in organic semiconductor donor-acceptor blends impacts charge carrier motion, interactions, and recombination behavior is a critical fundamental issue with a particularly major impact on organic photovoltaic applications. In this study, kinetic Monte Carlo (KMC) simulations are used to numerically quantify the complex bimolecular charge carrier recombination behavior in idealized phase-separated blends. Recent KMC simulations have identified how the encounter-limited bimolecular recombination rate in these blends deviates…
Non-radiative recombination processes are the biggest hindrance to approaching the radiative limit of the open-circuit voltage for wide-band gap perovskite solar cells. In addition, to high bulk quality, good interfaces and good energy level alignment for majority carriers at charge transport layer-absorber interfaces are crucial to minimize non-radiative recombination pathways. By tuning the lowest-unoccupied molecular-orbital of electron transport layers via the use of different fullerenes and fullerene blends, we demonstrate open-circuit voltages exceeding 1.35 V in CH3NH3Pb(I0.8Br0.2)3 dev…
Organic solar cells (OSCs) have recently shown a rapid improvement in their performance, bringing power conversion efficiencies (PCEs) closer to the point where commercial applications of the technology become viable. However, the low open-circuit voltage (Voc) of OSCs relative to their optical gap still limits PCEs to below 20%. A key factor contributing to the large Voc deficit in OSCs is non-radiative recombination to spin-triplet excitons, which is widely, but not universally, observed in blends using both fullerene and non-fullerene electron acceptors. Here, we present an experimental fra…
Suppressing charge recombination is key for organic solar cells to become commercial reality. However, there is still no conclusive picture of how recombination losses are influenced by the complex nanoscale morphology. Here, new insight is provided by revisiting the P3HT:PCBM blend, which is still one of the best performers regarding reduced recombination. By changing small details in the annealing procedure, two model morphologies were prepared that vary in phase separation, molecular order and phase purity, as revealed by electron tomography and optical spectroscopy. Both systems behave ver…
Influence of Charge Carrier Mobility on the Performance of Organic Solar Cells
基于供体-受体共混物的有机太阳能电池的功率转换效率由极化子对解离和双分子极化子复合的相互作用决定。这两个过程都强烈依赖于载流子的迁移率，解离随着更快的电荷传输而增加，同时提高了复合损失。使用宏观有效介质模拟，我们计算了最佳的载流子迁移率的最高功率转换效率，第一次占注入势垒和减少Langevin型复合。载流子迁移率从现有技术聚合物：富勒烯太阳能电池的$10^{-8}$ m $^2$ /Vs提高到产生最大效率的约$10^{-6}$ m $^2$ /Vs，对应于给定参数组仅约20%的提高。
The great progress in organic photovoltaics (OPV) over the past few years has been largely achieved by the development of non-fullerene acceptors (NFAs), with power conversion efficiencies now approaching 20%. To further improve device performance, loss mechanisms must be identified and minimized. Triplet states are known to adversely affect device performance, since they can form energetically trapped excitons on low-lying states that are responsible for non-radiative losses or even device degradation. Halogenation of OPV materials has long been employed to tailor energy levels and to enhance…
The power conversion efficiencies (PCEs) of organic solar cells (OSCs) using non-fullerene acceptors (NFAs) have now reached 18%. However, this is still lower than inorganic solar cells, for which PCEs >20% are commonplace. A key reason is that OSCs still show low open-circuit voltages (Voc) relative to their optical band gaps, attributed to non-radiative recombination. For OSCs to compete with inorganics in efficiency, all non-radiative loss pathways must be identified and where possible, removed. Here, we show that in most NFA OSCs, the majority of charge recombination at open-circuit procee…
Rethinking Charge Transport and Recombination in Donor-diluted Organic Solar Cells
Technische Universität Chemnitz（德国化学技术大学）；University of Freiburg（弗赖堡大学）；Fraunhofer Institute for Solar Energy Systems ISE（弗劳恩霍夫太阳能系统研究所）；Freiburg Materials Research Center FMF（弗赖堡材料研究中心）；University of Bayreuth（拜罗伊特大学）；Leibniz-Institut für Festkörper- und Werkstoffforschung Dresden (IFW)（德累斯顿莱布尼茨固体与材料研究所）；Durham University（杜伦大学）
While charge carrier dynamics and thermal management are both keys to the operational efficiency and stability for energy-related devices, experimental techniques that can simultaneously characterize both properties are still lacking. In this paper, we use laser-induced transient grating (TG) spectroscopy to characterize thin films of the archetypal organic semiconductor regioregular poly(3-hexylthiophene) (P3HT) and its blends with the electron acceptor [6,6]-phenyl-C61-butyric acid methyl ester (PCBM) on glass substrates. While the thermal response is determined to be dominated by the substr…
We demonstrate that blending fluorinated molecules in PEDOT:PSS hole transport layers (HTL) induces charge transfers which impact on both charge extraction and photogeneration within organic photovoltaic (OPV) devices. OPVs fabricated with modified HTL and two photoactive polymer blends led systematically to power conversion efficiencies (PCE) increases, with PTB7:PC70BM blend exhibiting PCE of ~ 8.3 %, i.e. ~ 15 % increase compared to pristine HTL devices. A reduced device-to-device characteristics variations was also noticed when fluorinated additives were used to modify the PEDOT:PSS. Shadi…
Triplet Excitons Reconcile Charge Generation and Recombination in Low-Offset Organic Solar Cells: Efficiency Limits from a 5-State Model
Paul-Drude-Institut für Festkörperelektronik (PDI), Leibniz-Institut im Forschungsverbund Berlin e.V.（柏林莱布尼茨研究所保罗·德鲁德固态电子学研究所）；University of Potsdam（波茨坦大学）
The energetic landscape at the interface between electron donating and accepting molecular materials favors efficient conversion of intermolecular charge-transfer states (CTS) into free charge carriers in high-performance organic solar cells. Here, we elucidate how interfacial energetics, charge generation and radiative recombination are affected by structural ordering. We experimentally determine the CTS binding energy of a series of model, small molecule donor-acceptor blends, where the used acceptors (B2PYMPM, B3PYMPM and B4PYMPM) differ only in the nitrogen position of their lateral pyridi…
Kinetic Monte Carlo (KMC) simulations are a powerful tool to study the dynamics of charge carriers in organic photovoltaics. However, the key characteristic of any photovoltaic device, its current-voltage ($J$-$V$) curve under solar illumination, has proven challenging to simulate using KMC. The main challenges arise from the presence of injecting contacts and the importance of charge recombination when the internal electric field is low, i.e., close to open-circuit conditions. In this work, an experimentally calibrated KMC model is presented that can fully predict the $J$-$V$ curve of a disor…
The active layer crystallinity has long been associated with favourable organic solar cells (OSCs) properties such as high mobility and Fill Factor. In particular, this applies to acceptor materials such as fullerene-derivatives and the most recent Non-Fullerene Acceptors (NFAs), which are now surpassing 19% of Power Conversion Efficiency. Despite these advantages are being commonly attributed to their 3-dimensional crystal packing motif in the single crystal, the bridge that links the acceptor crystal packing from single crystals to solar cells has not clearly been shown yet. In this work, we…
