Crystallographic defects play a key role in determining the properties of crystalline materials. The new class of two-dimensional materials, foremost graphene, have enabled atomically resolved studies of defects, such as vacancies, grain boundaries, dislocations, and foreign atom substitutions. However, atomic resolution imaging of implanted self-interstitials has so far not been reported in any three- but also not in any two-dimensional material. Here, we deposit extra carbon into single-layer graphene at soft landing energies of ~1 eV using a standard carbon coater. We identify all the self-interstitial dimer structures theoretically predicted earlier, employing 80 kV aberration-corrected high-resolution transmission electron microscopy. We demonstrate accumulation of the interstitials into larger aggregates and dislocation dipoles, which we predict to have strong local curvature by atomistic modeling, and to be energetically favourable configurations as compared to isolated interstitial dimers. Our results contribute to the basic knowledge on crystallographic defects, and lay out a pathway into engineering the properties of graphene by pushing the crystal into a state of metastable supersaturation.
Interstitial Fe-Cr alloys: Tuning of magnetism by nanoscale structural control and by implantation of nonmagnetic atoms
使用密度泛函理论,我们进行了一个完整的原子弛豫的散装铁氧体与12.5%的浓度的单原子间隙Cr周期性地位于bcc Fe $_α$细胞的边缘。我们表明,在这种人工设计的合金结构弛豫导致显着的原子位移,并在形成新的高度稳定的配置与平行链的八面体排列的铁的结果。这种类型的合金的低对称金属状态下的增强的磁极化可以通过额外包含诸如氮的非金属杂质来外部控制。我们讨论了生成的间隙合金在自旋电子器件中的可能应用,并建议将其作为新型耐用不锈钢的基础。
The MRO-accompanied modes of Re-implantation into SiO2-host matrix: XPS and DFT based scenarios
在XPS和DFT电子结构分析的基础上,推导并讨论了脉冲Re注入SiO_2基质的几种可能的情况:(1)低Re浓度模式--在氧空位附近形成具有类Re_2 O_7原子和电子结构的替位型和间隙型混合杂质;(ii)高Re杂质浓度模式->间隙Re金属团簇的制造伴随着类ReO 2原子结构的形成和(iii)中间瞬态模式,其中Re杂质浓度增加,当出现间隙缺陷团簇的前驱体并在基质结构中生长时。作为中间瞬态模的序列之一,发现稀土金属对最终价带结构的贡献占多数的放大区。结果表明,在a-SiO_2基质的初始氧子网络中,由于出现了混合缺陷组态,大多数合格的和讨论的模式都伴随着MRO(middle range ordering)畸变。
将杂原子引入石墨烯晶格中可用于调整其电子、机械和化学性质。因此,直接取代仅限于使用低能离子注入引入的附带Si杂质和P、N和B掺杂剂。我们在这里提出了迄今为止最重的杂质,即$^{74}$ Ge $^+$离子注入单层石墨烯。虽然样品污染仍然是一个问题,原子分辨率扫描透射电子显微镜成像和定量图像模拟表明,锗可以直接取代单原子,键合到三个碳邻居在一个屈曲的面外配置,或占据一个面内的位置在一个双空位。第一性原理分子动力学提供了对注入过程的进一步原子洞察,揭示了使注入低于石墨烯位移阈值能量的强化学效应。我们的研究结果表明,重原子可以被注入到石墨烯晶格中,为石墨烯作为模板的单原子催化等高级应用指明了方向。
Electrical transport and ferromagnetism in Ga1-xMnxAs synthesized by ion implantation and pulsed-laser melting
我们提出了一个详细的调查的磁性和磁输运性质的薄膜的铁磁Ga 1-xMnxAs合成离子注入和脉冲激光熔化(II-PLM)。场和温度相关的磁化强度,磁各向异性,温度相关的电阻率,磁阻,和霍尔效应的II-PLM Ga 1-xMnxAs薄膜具有所有的特征签名的空穴和Mn离子的强p-d相互作用中观察到的稀空穴介导的铁磁相。II-PLM膜的铁磁和电输运性质对应于峰值置换Mn浓度,这意味着非均匀Mn深度分布在确定膜性质中是不重要的。与低温分子束外延(LT-MBE)生长的具有类似替代Mn_Ga组分的薄膜具有良好的定量一致性。此外,我们证明了II-PLM Ga_(1-x)Mn_xAs薄膜由于高温处理而没有间隙Mn_I。在高Mn注入剂量下,凝固过程中溶质再分布的动力学单独决定了最大Mn_Ga浓度。II-PLM Ga 1-xMnxAs中存在面内[-110]和[110]方向之间的单轴各向异性,这证明了载流子介导的铁磁相的固有特性。
The influence of implantation conditions on dopant activation in Al-implanted 4H-SiC: A MD study applying an Al potential fitted to DFT barriers
CDL for Multi-Scale Process Modeling of Semiconductor Devices and Sensors, at the Institute for Microelectronics, TU Wien(维也纳工业大学微电子研究所多尺度半导体器件与传感器工艺建模中心);Silvaco Europe Ltd.(Silvaco欧洲有限公司)
Vacancy-Enhanced $N-N$ Bonding and Deep Level Complex Defect Formation in $β-Ga_2O_3$
International Research Centre Magtop, Institute of Physics Polish Academy of Sciences(波兰科学院物理研究所马格托国际研究中心);Institute of Plasma Physics and Laser Microfusion(等离子体物理与激光微聚变研究所);Institute of Fundamental Technological Research Polish Academy of Sciences(波兰科学院基础技术研究所);Institute of Microelectronics and Optoelectronics, Warsaw University of Technology(华沙理工大学微电子与光电子研究所);National Center for Nuclear Research(国家核研究中心);The Centre for Advanced Materials and Technologies, CEZAMAT at the Warsaw University of Technology(华沙理工大学先进材料与技术中心CEZAMAT)