Cloaking techniques conceal objects by controlling the flow of electromagnetic waves to minimize scattering. Herein, the effectiveness of homogenized anisotropic materials in non-resonant dielectric multilayer cloaking is studied. Because existing multilayer cloaking by isotropic materials can be regarded as homogenous anisotropic cloaking from a macroscopic view, anisotropic materials can be efficiently designed through optimization of their physical properties. Anisotropic properties can be realized in two-phase composites if the physical properties of the material are within appropriate bounds. The optimized anisotropic physical properties are identified by a numerical optimization technique based on a full-wave simulation using the finite element method. The cloaking performance measured by the total scattering width is improved by about 2.8% and 25% in eight- and three-layer cylindrical cloaking materials, respectively, compared with multilayer cloaking by isotropic materials. In all cloaking examples, the optimized microstructures of the two-phase composites are identified as the simple lamination of two materials, which maximizes the anisotropy. The same performance as published for eight-layer cloaking by isotropic materials is achieved by three-layer cloaking using the anisotropic material. Cloaking with an approximately 50% reduction of total scattering width is achieved even in an octagonal object. Since the cloaking effect can be realized using just a few layers of the laminated anisotropic dielectric composite, this may have an advantage in the mass production of cloaking devices.
Scattering from a dielectric nanowire coated by helical graphene strips (nanoribbons) is investigated for dual-polarized wave at oblique incidence. In the long-wavelength approximation, the helical strips are treated as a homogeneous layer with averaged tensor conductivity. It is shown that performance of well-known surface cloaks in the form of graphene monolayer, axial and azimuthal graphene strips can be deteriorated in a wide range of incidence angles. To overcome this problem, helical graphene strips are proposed as an advanced metasurface for dual-polarized all-angle cloaking of dielectr…
Electromagnetic cloaking of cylindrical objects by multilayer or uniform dielectric claddings
我们表明，介电，甚至完全导电的圆柱体可以通过均匀或分层的电介质包覆，而不需要任何外来的或磁性材料的参数。特别是，我们首先提出了一个简单的分析概念，可以准确地描述在可见光谱中的锥形银盘获得的隐身效果。模型结构最初在[S. A. Tretyakov，P. Alitalo，O.卢科宁角R. Simovski，Phys. Rev. Lett. Vol.103，p.103905，2009]，其中仅数值地研究了其在光学频率中作为斗篷的操作。我们严格地模拟这种配置作为一个多层介质覆盖周围的隐形物体，与实际设备的模拟结果非常吻合。使用均匀或多层介质覆盖的概念，相对介电常数大于1，然后成功地扩展到不可穿透的对象，如导电圆柱体的隐身。
We demonstrate a novel and simple approach to cloaking a scatterer on a ground plane. We use an extremely thin dielectric metasurface (λ/12) to reshape the wavefronts distorted by a scatterer in order to mimic the reflection pattern of a flat ground plane. To achieve such carpet cloaking, the reflection angle has to be equal to the incident angle everywhere on the scatterer. We use a graded metasurface and calculate the required phase gradient to achieve cloaking. Our metasurface locally provides additional phase to the wavefronts to compensate for the phase difference amongst light paths indu…
While practical realizations of optical invisibility have been achieved so far by various ingenious methods, they generally rely on complex materials which prevent the wide implementation of such schemes. Here, we propose an alternative indivisibility procedure to design objects (i.e. self-cloaked structures) that have optical properties identical to the surrounding environment and are, thereby, intrinsically invisible to an external observer as such (without the necessity of an external cloak). The proposed method is based on the uncoupling of the scattered waves from the incident radiation b…
We investigate the generation of entanglement between two quantum emitters through the inverse-design engineering of their photonic environment. By means of a topology-optimization approach acting at the level of the electromagnetic Dyadic Green's function, we generate dielectric cloaks operating at different inter-emitter distances and incoherent pumping strengths. We show that the structures obtained maximize the dissipative coupling between the emitters under extremely different Purcell factor conditions, and yield steady-state concurrence values much larger than those attainable in free sp…
In this manuscript, we demonstrate the design and experimental proof of an optical cloaking structure which multi-directionally conceals a perfectly electric conductor (PEC) object from an incident plane wave. The dielectric modulation around the highly reflective scattering PEC object is determined by an optimization process for multi-directional cloaking purposes. And to obtain the multi-directional effect of the cloaking structure, an optimized slice is mirror symmetrized through a radial perimeter. Three-dimensional (3D) finite-difference time-domain method is integrated with genetic optim…
We show that it is possible to design an invisible wavelength-sized metal-dielectric metamaterial object without evoking cloaking. Our approach is an extension of the neutral inclusion concept by Zhou and Hu [Phys.Rev.E 74, 026607 (2006)] to Mie scatterers. We demonstrate that an increase of metal fraction in the metamaterial leads to a transition from dielectric-like to metal-like scattering, which proceeds through invisibility or optical neutrality of the scatterer. Formally this is due to cancellation of multiple scattering orders, similarly to plasmonic cloaking introduced by Alu and Enghe…
Coordinate transformations are a versatile tool to mould the flow of light, enabling a host of astonishing phenomena such as optical cloaking with metamaterials. Moving away from the usual restriction that links isotropic materials with conformal transformations, we show how non-conformal distortions of optical space are intimately connected to the complex refractive index distribution of an isotropic non-Hermitian medium. Remarkably, this insight can be used to circumvent the material requirement of working with refractive indices below unity, which limits the applications of transformation o…
Fundamental bounds on the performance of monochromatic scattering-cancellation and field-zeroing cloaks made of prescribed linear passive materials occupying a predefined design region are formulated by projecting field quantities onto a sub-sectional basis and applying quadratically constrained quadratic programming. Formulations are numerically tested revealing key physical trends as well as advantages and disadvantages between the two classes of cloaks. Results show that the use of low-loss materials with high dielectric contrast affords the highest potential for effective cloaking.
Subwavelength structures demonstrate many unusual optical properties which can be employed for engineering functional metadevices, as well as scattering of light and invisibility cloaking. Here we demonstrate that the suppression of light scattering for any direction of observation can be achieved for an uniform dielectric object with high refractive index, in a sharp contrast to the cloaking with multilayered plasmonic structures suggested previously. Our finding is based on the novel physics of cascades of Fano resonances observed in the Mie scattering from a homogeneous dielectric rod. We o…
In this study, the design of a directional cloaking based on the Luneburg lens system is proposed and its operating principle is experimentally verified. The cloaking concept is analytically investigated via geometrical optics and numerically realized with the help of the finite-difference time-domain method. In order to benefit from its unique focusing and/or collimating characteristics of light, the Luneburg lens is used. We show that by the proper combination of Luneburg lenses in an array form, incident light bypasses the region between junctions of the lenses, i.e., the "dark zone." Hence…
In this paper, we address non-radiating and cloaking problems exploiting the surface equivalence principle, by imposing at any arbitrary boundary the control of the admittance discontinuity between the overall object (with or without cloak) and the background. After a rigorous demonstration, we apply this model to a non-radiating problem, appealing for anapole modes and metamolecules modeling, and to a cloaking problem, appealing for non-Foster metasurface design. A straightforward analytical condition is obtained for controlling the scattering of a dielectric object over a surface boundary of…
Cloaking of Arbitrarily Shaped Large-Scale Objects Through the Injection of Electromagnetic Invisibility Genes
Key Lab of Advanced Transducers and Intelligent Control System, Ministry of Education and Shanxi Province, College of Physics and Optoelectronics, Taiyuan University of Technology（先进换能器与智能控制系统重点实验室（教育部和山西省），物理与光电工程学院，太原理工大学）；The Department of Electronic Systems, Aalborg University（电子系统系，奥尔堡大学）
All-dielectric photonic quasicrystals may act as zero-refractive-index homogeneous materials despite their lack of translational symmetry and periodicity, stretching wavelengths to infinity and offering applications in light wavefront sculpting and optical cloaking.
The article demonstrates uncommon manifestation of spatial dispersion in low refractive index contrast 3D periodic dielectric composites with periods of about one tenth of the wavelength. First principles simulations by the well established plane wave method reveal that spatial dispersion leads to appearance of additional optical axes and can compensate anisotropy in certain directions.
Concealing objects by making them invisible to an external electromagnetic probe is coined by the term cloaking. Cloaking devices, having numerous potential applications, are still face challenges in realization, especially in the visible spectral range. In particular, inherent losses and extreme parameters of metamaterials required for the cloak implementation are the limiting factors. Here, we numerically demonstrate nearly perfect suppression of scattering from arbitrary shaped objects in spatially dispersive metamaterial acting as an alignment-free concealing cover. We consider a realizati…
A composite plasmonic slab based on double-layer metallic gratings and a dielectric film is experimentally and numerically demonstrated in terahertz (THz) regions, which can support two resonance modes and then form a broad bandgap (40%). As compared to the double-layer metal grating, the dielectric film in composite THz slabs significantly enhances the transmission of the transverse magnetic (TM) mode. Electric field vector proved that the low-frequency resonance mode originates from the symmetric plasmonic mode and the high-frequency resonance mode is induced by the hybrid mode of plasmonic …
Metamaterials are artificially structured media that can focus (lensing) or reroute (cloaking) waves, and typically this is developed for electromagnetic waves at millimetric down to nanometric scales or for acoustics or thin elastic plates at centimeter scales. Extending the concepts of Kadic et al. 2013 we show that the underlying ideas are generic across wave systems and scales by generalizing these concepts to seismic waves at frequencies, and lengthscales of the order of hundreds of meters, relevant to civil engineering. By applying ideas from transformation optics we can manipulate and s…
The homogenization of a composite material comprising three isotropic dielectric materials was investigated. The component materials were randomly distributed as spherical particles, with the particles of two of the component materials being coupled to form dimers. The Bruggeman and Maxwell Garnett formalisms were developed to estimate the permittivity dyadic of the homogenized composite material (HCM), under the quasi-electrostatic approximation. Both randomly oriented and identically oriented dimers were accommodated; in the former case the HCM is isotropic, whereas in the latter case the HC…
