We perform quantum state reconstruction of coherent and thermal states with a detector which has an enhanced multiphoton response. The detector is based on superconducting nanowires, where the bias current sets the dependence of the click probability on the photon number; this bias current is used as tuning parameter in the state reconstruction. The nonlinear response makes our nanowire-based detector superior to the linear detectors that are conventionally used for quantum state reconstruction.
We propose an approach to reconstruct any superconducting charge qubit state by using quantum state tomography. This procedure requires a series of measurements on a large enough number of identically prepared copies of the quantum system. The experimental feasibility of this procedure is explained and the time scales for different quantum operations are estimated according to experimentally accessible parameters. Based on the state tomography, we also investigate the possibility of the process tomography.
The analysis of wave-packet dynamics may be greatly simplified when viewed in phase-space. While harmonic oscillators are often used as a convenient platform to study wave-packets, arbitrary state preparation in these systems is more challenging. Here, we demonstrate a direct measurement of the Wigner distribution of complex photon states in an anharmonic oscillator - a superconducting phase circuit, biased in the small anharmonicity regime. We test our method on both non-classical states composed of two energy eigenstates and on the dynamics of a phase-locked wavepacket. This method requires …
A number of superconducting qubits, such as the transmon or the phase qubit, have an energy level structure with small anharmonicity. This allows for convenient access of higher excited states with similar frequencies. However, special care has to be taken to avoid unwanted higher-level populations when using short control pulses. Here we demonstrate the preparation of arbitrary three-level superposition states using optimal control techniques in a transmon. Performing dispersive read-out we extract the populations of all three levels of the qutrit and study the coherence of its excited states…
We demonstrate and verify quantum detector tomography of a superconducting nanowire single-photon detector (SNSPD) in a multiplexing scheme which permits measurement of up to 71000 photons per input pulse. We reconstruct the positive operator valued measure (POVM) of this device in the low photon-number regime, and use the extracted parameters to show the POVMs spanning the whole dynamic range of the device. We verify this by finding the mean photon number of a bright state. Our work shows that a reliable quantum description of large-scale SNSPD devices is possible, and should be applicable to…
We demonstrate quantum detector tomography of a commercial 2x2 array of superconducting nanowire single photon detectors. We show that detector-specific figures of merit including efficiency, dark-count and cross-talk probabilities can be directly extracted, without recourse to the underlying detector physics. These figures of merit are directly identified from just four elements of the reconstructed positive operator valued measure (POVM) of the device. We show that the values for efficiency and dark-count probability extracted by detector tomography show excellent agreement with independent …
As progress is made towards the first generation of error-corrected quantum computers, robust characterization and validation protocols are required to assess the noise environments of physical quantum processors. While standard coherence metrics and characterization protocols such as T1 and T2, process tomography, and randomized benchmarking are now ubiquitous, these techniques provide only partial information about the dynamic multi-qubit loss channels responsible for processor errors, which can be described more fully by a Lindblad operator in the master equation formalism. Here, we introdu…
I propose an iterative expectation maximization algorithm for reconstructing a quantum optical ensemble from a set of balanced homodyne measurements performed on an optical state. The algorithm applies directly to the acquired data, bypassing the intermediate step of calculating marginal distributions. The advantages of the new method are made manifest by comparing it with the traditional inverse Radon transformation technique.
Dynamical decoupling is a technique that protects qubits against noise. The ability to preserve quantum coherence in the presence of noise is essential for the development of quantum devices. Here the Rigetti quantum computing platform was used to test different dynamical decoupling sequences. The performance of the sequences was characterized by Quantum Process Tomography and analyzed using the quantum channels formalism. It is shown that dynamical decoupling can reduce qubit dephasing but cannot protect against spontaneous emission. Furthermore, from process tomography results, it was also p…
We compare direct state measurement (DST or weak state tomography) to conventional state reconstruction (tomography) through accurate Monte-Carlo simulations. We show that DST is surprisingly robust to its inherent bias. We propose a method to estimate such bias (which introduces an unavoidable error in the reconstruction) from the experimental data. As expected we find that DST is much less precise than tomography. We consider both finite and infinite-dimensional states of the DST pointer, showing that they provide comparable reconstructions.
New type of tomographic probability distribution, which contains complete information on the density matrix (wave function) related to the Fresnel transform of the complex wave function, is introduced. Relation to symplectic tomographic probability distribution is elucidated. Multimode generalization of the Fresnel tomography is presented. Examples of applications of the present approach are given.
We investigate quantum state reconstruction of a superconducting qubit threaded by an Aharonov-Bohm flux, with particular attention to the local geometric phase. A state reconstruction scheme is introduced with a proper account of the local geometric phase generated by Faraday's law of induction. Our scheme is based on measurement of three complementary quantities, that is, the extra charge and two local currents. Incorporating time-reversal symmetry and the Faraday's law, we show that the full density matrix can be reconstructed without ambiguity in the choice of gauge. This procedure clearly…
Superconducting nanostrip photon detectors have been used as single photon detectors, which can discriminate only photons' presence or absence. It has recently been found that they can discriminate the number of photons by analyzing the output signal waveform, and they are expected to be used in various fields, especially in optical quantum information processing. Here, we improve the photon-number-resolving performance for light with a high-average photon number by pattern matching of the output signal waveform. Furthermore, we estimate the positive-operator-valued measure of the detector by …
We consider the task of performing quantum state tomography on a $d$-level spin qudit, using only measurements of spin projection onto different quantization axes. After introducing a basis of operators closely related to the spherical harmonics, which obey the rotational symmetries of spin qudits, we map our quantum tomography task onto the classical problem of signal recovery on the sphere. We then provide algorithms with $O(rd^3)$ serial runtime, parallelizable down to $O(rd^2)$, for (i) computing a priori upper bounds on the expected error with which spin projection measurements along $r$ …
In open quantum systems, phenomenological master equations with unknown parameters are often introduced. Here we propose a time-independent procedure based on quantum tomography to reconstruct the potentially unknown parameters of a wide class of Markovian master equations. According to our scheme, the system under investigation is initially prepared in a Gaussian state. At an arbitrary time t, in order to retrieve the unknown coefficients one needs to measure only a finite number (ten at maximum) of points along three time-independent tomograms. Due to the limited amount of measurements requi…
The experimental implementation of selective quantum process tomography (SQPT) involves computing individual elements of the process matrix with the help of a special set of states called quantum 2-design states. However, the number of experimental settings required to prepare input states from quantum 2-design states to selectively and precisely compute a desired element of the process matrix is still high, and hence constructing the corresponding unitary operations in the lab is a daunting task. In order to reduce the experimental complexity, we mathematically reformulated the standard SQPT …
Recently quantum tomography has been proposed as a fundamental tool for prototyping a few qubit quantum device. It allows the complete reconstruction of the state produced from a given input into the device. From this reconstructed density matrix, relevant quantum information quantities such as the degree of entanglement and entropy can be calculated. Generally orthogonal measurements have been discussed for this tomographic reconstruction. In this paper, we extend the tomographic reconstruction technique to two new regimes. First we show how non-orthogonal measurement allow the reconstruction…
We analyze the possibility of tomographic reconstruction of a system of three-level atoms in both non-degenerate and degenerate cases. In the non-degenerate case (when both transitions can be accessed independently) a complete reconstruction is possible. In the degenerate case (when both transitions are excited simultaneously) the complete reconstruction is achievable only for a single atom in the Sigma configuration. For multiple Sigma atoms, or even a single atom in the Lambda configuration, only partial reconstruction is possible. Examples of one and two-atom cases are explicitly considered…
We present the experimental reconstruction of the Wigner function of an individual electronic spin qubit associated with a nitrogen-vacancy (NV) center in diamond at room temperature. This spherical Wigner function contains the same information as the density matrix for arbitrary spin systems. As an example, we exactly characterize the quantum state of a single qubit undergoing a nearly pure dephasing process by Wigner function. The fidelities and purities during this process are extracted from the experimental reconstructed Wigner functions, whose dynamics agree with the theoretical predictio…
The efficiency of Quantum Characterisation, Verification, and Validation (QCVV) protocols highly hinges on the agreement between the assumed noise model and the underlying error mechanisms. As a matter of fact, errors in Quantum Processing Units (QPUs) incorporate various aspects of context-dependability which are overlooked by the majority of the commonly used QCVV protocols. As QCVV protocols are indispensable when it comes to characterizing and evaluating quantum operations, there is a serious need for a detailed characterization taking into account such aspects. In this work, we address th…
Quantum state reconstruction involves measurement devices that are usually described by idealized models, but not known in full detail in experiments. For weak propagating microwaves, the detection process requires linear amplifiers which obscure the signal with random noise. Here, we introduce a theory which nevertheless allows one to use these devices for measuring all quadrature moments of propagating quantum microwaves based on cross-correlations from a dual-path amplification setup. Simultaneously, the detector noise properties are determined, allowing for tomography. We demonstrate the f…
We characterize the Majorana zero modes in topological hybrid superconductor-semiconductor wires with spin-orbit coupling and magnetic field, in terms of generalized Bloch coordinates $φ, θ, δ$, and analyze their transformation under SU(2) rotations. We show that, when the spin-orbit coupling and the magnetic field are perpendicular, $φ$ and $δ$ are universal in an appropriate coordinate system. We use these geometric properties to explain the behavior of the Josephson current in junctions of two wires with different orientations of the magnetic field and/or the spin-orbit coupling. We show ho…
The high-fidelity analysis of many-body quantum states of indistinguishable atoms requires the accurate counting of atoms. Here we report the tomographic reconstruction of an atom-number-resolving detector. The tomography is performed with an ultracold rubidium ensemble that is prepared in a coherent spin state by driving a Rabi coupling between the two hyperfine clock levels. The coupling is followed by counting the occupation number in one level. We characterize the fidelity of our detector and show that a negative-valued Wigner function is associated with it. Our results offer an exciting p…
A method to reconstruct weakly anisotropic inhomogeneous dielectric tensors inside a transparent medium is proposed. The mathematical theory of Integral Geometry is cast into a workable framework which allows the full determination of dielectric tensor fields by scalar Radon inversions of the polarization transformation data obtained from six planar tomographic scanning cycles. Furthermore, a careful derivation of the usual equations of integrated photoelasticity in terms of heuristic length scales of the material inhomogeneity and anisotropy is provided, making the paper a self-contained acco…
A new reconstruction method for Wigner function is reported for quantum tomography based on compressed sensing. By analogy with computed tomography, Wigner functions for some quantum states can be reconstructed with less measurements utilizing this compressed sensing based method.
