arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 1011.4157cs.AR
收藏

采用0.35 um CMOS技术的8位、25 MHz、流水线ADC的全定制ASIC设计

A full-custom ASIC design of a 8-bit, 25 MHz, Pipeline ADC using 0.35 um CMOS technology

Moslem Rashidi, Mikael Hogrud, Donatas Siaudinis, Affaq Qamar, Imran Khan

摘要:

本计画的目的是利用0.35微米CMOS工艺设计并实现一个管线式类比数位转换器。初始要求为25 MHz转换速率和8位分辨率,其中仅给定。虽然附加的次要目标,如低功耗和小面积的陈述。该架构基于每级1.5位结构,每级利用数字校正[12]。每一级的采样和放大都使用了一个由200 MHz ft的级联gm-C运算放大器组成的差分开关电容电路[12]。差分动态比较器用于实现每级1.5-b结构所需的判决电平。流水线的校正由D锁存器和全加器组成的数字校正电路完成。整个设计的面积和功耗分别为0.24mm ~ 2和35 mW。转换器提供适当输出的最大采样率为33 MHz。

英文摘要:

The purpose of this project was to design and implement a pipeline Analog-to-Digital Converter using 0.35um CMOS technology. Initial requirements of a 25-MHz conversion rate and 8-bits of resolution where the only given ones. Although additional secondary goals such as low power consumption and small area were stated. The architecture is based on a 1.5 bit per stage structure utilizing digital correction for each stage [12]. A differential switched capacitor circuit consisting of a cascade gm-C op-amp with 200MHz ft is used for sampling and amplification in each stage [12]. Differential dynamic comparators are used to implement the decision levels required for the 1.5-b per stage structure. Correction of the pipeline is accomplished by using digital correction circuit consist of D-latches and full-adders. Area and Power consumption of whole design was 0.24mm2 and 35mW respectively. The maximum sample rate at which the converter gave an adequate output was 33MHz.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑