The structural evolution and dynamics of silver nanodrops Ag${}_{2896}$ (4.4 nm in diameter) during rapid cooling conditions has been studied by means of molecular dynamics simulations and electronic density of state calculations. The interaction of silver atoms is modeled by a tight-binding semiempirical interatomic potential proposed by Cleri and Rosato. The pair correlation functions and the pair analysis technique is applied to reveal the structural transition in the process of solidification. It is shown that Ag nanoparticles evolve into different nanostructures under different cooling processes. At a cooling rate of $1.5625\times10^{13} Ks^{-1}$ the nanoparticles preserve an amorphous like structure containing a large amount of 1551 and 1541 pairs which correspond to the icosahedral symmetry. For a lower cooling rate ($1.5625\times10^{12} Ks^{-1}$), the nanoparticles transform into a crystal-like structure consisting mainly of 1421 and 1422 pairs which correspond to the fcc and hcp structures, respectively. The variations of the electronic density of states for the differently cooled nanoparticles are small but in correspondence with the structural changes.
Understanding and controlling properties of plasmon-induced hot carriers is a key step towards next-generation photovoltaic and photocatalytic devices. Here, we uncover a route to engineering hot-carrier generation rates of silver nanoparticles by designed embedding in dielectric host materials. Extending our recently established quantum-mechanical approach to describe the decay of quantized plasmons into hot carriers we capture both external screening by the nanoparticle environment and internal screening by silver d-electrons through an effective electron-electron interaction. We find that h…
The paper presents the results of investigation of the structure of porous condensates of Ag-NaCl and Cu-NaCl composition; chemical and phase compositions and dimensions of nanoparticles, produced from the vapour phase by EBPVD method. Silver and copper nanoparticles in a porous matrix, when removed from vacuum, oxidize in air to lower oxides, and have considerable sorption capacity relative to oxygen and moisture. Heating in air is accompanied by lowering of porous condensate mass, primarily, due to desorption of physically sorbed moisture, as well as afteroxidation to higher oxides due to ph…
The development of enhanced optical devices relies on key materials properties. In this context, researchers have investigated the effects of metal nanoparticles incorporation in active rare-earth materials. Here, we discuss the effects of Silver nitrate addition 0.5%, 1.0% and 2.0% mol%) into a Pr3+ doped tellurite-tungstate glasses (TWNN) formed by the conventional melt-quenching technique. The XRD curves confirmed the amorphous structural nature of TWNN glasses. The FTIR spectra identified the presence of different vibrational groups. DSC curves verified the increase around 70 oC for therma…
Metal nanoparticles have a substantial impact across different fields of science, such as photochemistry, energy conversion, and medicine. Among the commonly used nanoparticles, silver nanoparticles are of special interest due to their antibacterial properties and applications in sensing and catalysis. However, many of the methods used to synthesize silver nanoparticles often do not result in well-defined products, the main obstacles being high polydispersity or a lack of particle size tunability. We describe an automated approach to on-demand synthesis of adjustable particles with mean radii …
Plasmonic nanoparticles from unconventional materials can improve or even bring some novel functionalities into the disciplines inherently related to plasmonics such as photochemistry or (spectro)electrochemistry. They can, for example, catalyze various chemical reactions or act as nanoelectrodes and optical transducers in various applications. Silver amalgam is the perfect example of such an unconventional plasmonic material, albeit it is well-known in the field of electrochemistry for its wide cathodic potential window and strong adsorption affinity of biomolecules to its surface. In this st…
In this work, we report X-ray photoelectron (XPS) and valence band (VB) spectroscopy measurements of surfactant-free silver nanoparticles and silver/linear carbon chains (Ag@LCC) structures prepared by pulse laser ablation (PLA) in water. Our measurements demonstrate significant oxidation only on the surfaces of the silver nanoparticles with many covalent carbon-silver bonds but only negligible traces of carbon-oxygen bonds. Theoretical modeling also provides evidence of the formation of robust carbon-silver bonds between linear carbon chains and pure and partially oxidized silver surfaces. A …
This study utilizes molecular dynamics simulations to scrutinize the influence of type and volume fraction of nanoparticle on the density of nanofluids, i.e. silver (as a hydrophilic case) and titanium dioxide (as a hydrophobic case) water-based nanofluids. Ionic structure of TiO2 distinguishes the solid-liquid interactions with those in silver-water nanofluid. The thickness of nanolayer is estimated from density profile formed around the nanoparticle and is included in the density calculation. It is found that the type of interatomic potential between the nanoparticle and surrounding water ca…
Parity is a ubiquitous notion in science and serves as a fundamental principle for describing a physical system. Nanometer-scale metal objects are predicted to show dramatic differences in physical properties depending on the electron-number parity. However, the identification of the electron-number parity effects in real metal nanoparticles has remained elusive because of the variations in various features of nanoparticles. Here we report the nuclear magnetic resonance (NMR) detection of the dynamic effect of the electron-number parity in silver nanoparticles. With theoretical modeling of the…
Heat transfer between a silver nanoparticle and surrounding water has been studied using molecular dynamics (MD) simulations. The thermal conductance (Kapitza conductance) at the interface between a nanoparticle and surrounding water has been calculated using four different approaches: transient with/without temperature gradient (internal thermal resistance) in the nanoparticle, steady-state non-equilibrium and finally equilibrium simulations. The results of steady-state non-equilibrium and equilibrium are in agreement but differ from the transient approach results. MD simulations results also…
Bimetallic plasmonic nanoparticles enable tuning of the optical response and chemical stability by variation of the composition. The present numerical simulation study compares Ag-Au alloy, Ag@Au core-shell, and Au@Ag core-shell bimetallic plasmonic nanoparticles of both spherical and anisotropic (nanotriangle and nanorods) shapes. By studying both spherical and anisotropic (with LSPR in the near-infrared region) shapes, cases with and without interband transitions of Au can be decoupled. Explicit comparisons are facilitated by numerical models supported by careful validation and examination o…
Few inventions have shaped the world like the incandescent bulb. While Edison used thermal radiation from ohmically heated conductors, some noble metals exhibit "cold" electroluminescence (EL) in percolation films, tunnel diodes, electromigrated nanoparticle aggregates, optical antennae, or scanning-tunnelling microscopy (STM). The origin of this radiation, which is spectrally broad and depends on applied bias, is controversial given the low radiative yields of electronic transitions. Nanoparticle EL is particularly intriguing since it involves localized surface-plasmon resonances with large d…
In this paper, we performed four modifications on the solar still, as (A) adding the graphite nanoparticles, (B) the graphite nanoparticles together with the phase change material (PCM), (C) the graphite nanoparticles together with glass film cooling, and (D) graphite nanoparticles with both PCM and glass film cooling. The effects of modifications are measured and compared with each other. The productivities of modified (A), (B), (C), and (D) solar stills are enhanced by about 50.28%, 65.00%, 56.15% and 73.80%, respectively, as compared with the conventional solar still. The influences of sali…
Clear influence of particle size, surfactants and dispersion medium on surface plasmon resonance (SPR) features of Ag nanoparticles (NPs), synthesized in thermal decomposition method, in the broad range of ultraviolet (UV) radiation, critical for many potential applications such as a photocatalyst, UV-sensor and detector, has been demonstrated here. It involves adsorbate coverage, interparticle distance or agglomeration, surface charge density and solvent refractive index (μ). NP agglomeration and surface charge density in solvents of varying μ have been studied systematically through zeta-pot…
One photon up-conversion photoluminescence is an optical phenomenon whereby the thermal energy of a fluorescent material increases the energy of an emitted photon compared with the energy of the photon that was absorbed. When this occurs with near unity efficiency, the emitting material undergoes a net decrease in temperature--so called optical cooling. Because the up-conversion mechanism is thermally activated, the yield of up-converted photoluminescence is also a reporter of the temperature of the emitter. Taking advantage of this optical signature, cesium lead trihalide nanocrystals are sho…
