At linear colliders, the e+e- luminosity is limited by beam-collision effects, which determine the required emittances of beams in damping rings (DRs). While in gamma-gamma collisions at the photon collider, these effects are absent, and so smaller emittances are desirable. In present damping rings designs, nominal DR parameters correspond to those required for e+e- collisions. In this note, I would like to stress once again that as soon as we plan the photon-collider mode of ILC operation, the damping-ring emittances are dictated by the photon-collider requirements--namely, they should be as small as possible. This can be achieved by adding more wigglers to the DRs; the incremental cost is easily justified by a considerable potential improvement of the gamma-gamma luminosity. No expert analysis exists as of yet, but it seems realistic to obtain a factor five increase of the gamma-gamma luminosity compared to the ``nominal'' DR design.
One of the interaction regions at the linear colliders should be compatible both with e+e- and gamma-gamma, gamma-electron modes of operation. In this paper, the differences in requirements and possible design solutions are discussed.
This paper is the second part of my overview on photon colliders given at the conference ``The photon: its first hundred years and the future'' (PHOTON2005 + PLC2005). The first paper describes the first 25 years of the history and evolution of photon colliders. The present paper considers the photon collider at the ILC: possible parameters, technical problems and present status.
In this lecture, the physics potential for the e+e- linear collider experiments ILC and CLIC is reviewed. The experimental conditions are compared to those at hadron colliders and their intrinsic value for precision experiments, complementary to the hadron colliders, is discussed. The detector concepts for ILC and CLIC are outlined in their most important aspects related to the precision physics. Highlights from the physics program and from the benchmark studies are given. It is shown that linear colliders are a promising tool, complementing the LHC in essential ways to test the Standard Model…
The construction of the ILC tangential to Tevatron ring will give opportunity to investigate electron-proton, positron-proton, electron-antiproton, positron-antiproton interactions at 1 TeV center of mass energy. The analysis of the lepton-hadron collisions in these energy region is very important both for understanding of strong interaction dynamics and for adequate interpretation of future LHC and VLHC data. In addition, ILC-Tevatron collider will provide a possibility to realize photon-hadron collisions in the same energy region using Compton backscattered laser photon off ILC electron beam…
Future electron-positron linear colliders require a highly polarized electron beam with a pulse structure that depends primarily on whether the acceleration utilizes warm or superconducting rf structures. The International Linear Collider (ILC) will use cold structures for the main linac. It is shown that a dc-biased polarized photoelectron source such as successfully used for the SLC can meet the charge requirements for the ILC micropulse with a polarization approaching 90%.
Gamma-proton collisions allow unprecedented investigations of the low x and high $Q^{2}$ regions in quantum chromodynamics. In this paper, we investigate the luminosity for "ILC"$\times$LHC ($\sqrt{s_{ep}}=1.3$ TeV) and "CLIC"$\times$LHC ($\sqrt{s_{ep}}=1.45$ TeV) based $γp$ colliders. Also we determine the laser properties required for high conversion efficiency.
The International Linear Collider (ILC) is a proposed electron-positron collider for the centre-of-mass energy range of 200 to 500 GeV and with upgrade options towards 1 TeV. The ILC would be the ideal tool to explore with high precision the properties of the new Higgs-like particle that has recently been discovered at the LHC with a mass of around 125 GeV. The ILC accelerator design is based on the mature superconducting technology that has been developed in the TESLA collaboration and that is currently being used for the European XFEL. The exploitation of the huge physics potential of the IL…
The International Linear Collider (ILC) is a 200-500 GeV center-of-mass high-luminosity linear electron-positron collider, based on 1.3 GHz superconducting radio-frequency (SCRF) accelerating cavities. The ILC has a total footprint of about 31 km and is designed for a peak luminosity of 2x10^34 cm^-2s^-1. This report is the Executive Summary (Volume I) of the four volume Reference Design Report. It gives an overview of the physics at the ILC, the accelerator design and value estimate, the detector concepts, and the next steps towards project realization.
In this article, we describe the key features of the recently completed technical design for the International Linear Collider (ILC), a 200-500 GeV linear electron-positron collider (expandable to 1 TeV) that is based on 1.3 GHz superconducting radio-frequency (SCRF) technology. The machine parameters and detector characteristics have been chosen to complement the Large Hadron Collider physics, including the discovery of the Higgs boson, and to further exploit this new particle physics energy frontier with a precision instrument. The linear collider design is the result of nearly twenty years …
At this time, the design of the International Linear Collider (ILC) is optimized for e+e- collisions; the photon collider (gamma-gamma and gamma-electron) is considered as an option. Unexpected discoveries, such as the diphoton excess F(750 GeV) seen at the LHC, could strongly motivate the construction of a photon collider. In order to enable the gamma-gamma collision option, the ILC design should be compatible with it from the very beginning. In this paper, we discuss the problem of the beam crossing angle. In the ILC technical design, this angle is 14 mrad, which is just enough to provide en…
We attracted attention to some peculiarities of positron production for linear collider (ILC). The conversion system with many targets and low K-factor is our primary interest.
The International Linear Collider (ILC) being proposed in Japan is an electron-positron linear collider with an initial energy of 250 GeV. The ILC accelerator is based on the technology of superconducting radio-frequency cavities. This technology has reached a mature stage in the European XFEL project and is now widely used. The ILC will start by measuring the Higgs properties, providing high-precision and model-independent determinations of its parameters. The ILC at 250 GeV will also search for direct new physics in exotic Higgs decays and in pair-production of weakly interacting particles. …
The International Linear Collider (ILC) is a 200-500 GeV center-of-mass high-luminosity linear electron-positron collider, based on 1.3 GHz superconducting radio-frequency (SCRF) accelerating cavities. The ILC has a total footprint of about 31 km and is designed for a peak luminosity of 2x10^34 cm^-2 s^-1. The complex includes a polarized electron source, an undulator-based positron source, two 6.7 km circumference damping rings, two-stage bunch compressors, two 11 km long main linacs and a 4.5 km long beam delivery system. This report is Volume III (Accelerator) of the four volume Reference D…
We summarize the physics case for the International Linear Collider (ILC). We review the key motivations for the ILC presented in the literature, updating the projected measurement uncertainties for the ILC experiments in accord with the expected schedule of operation of the accelerator and the results of the most recent simulation studies.
The International Linear Collider (ILC) is now under consideration as the next global project in particle physics. In this report, we review of all aspects of the ILC program: the physics motivation, the accelerator design, the run plan, the proposed detectors, the experimental measurements on the Higgs boson, the top quark, the couplings of the W and Z bosons, and searches for new particles. We review the important role that polarized beams play in the ILC program. The first stage of the ILC is planned to be a Higgs factory at 250 GeV in the centre of mass. Energy upgrades can naturally be im…
High energy e+e- linear colliders are the next large scale project in particle physics. They need intense sources to achieve the required luminosity. In particular, the positron source must provide about 10E+14 positrons per second. The positron source for the International Linear Collider (ILC) is based on a helical undulator passed by the electron beam to create an intense circularly polarized photon beam. With these photons a longitudinally polarized positron beam is generated; the degree of polarization can be enhanced by collimating the photon beam. However, the high photon beam intensity…
The fast ion instability is simulated in different gas pressures and fill patterns for the damping ring of the International Linear Collider (ILC) and PETRA III respectively. Beam size variation due to beta function and dispersion function change is taken into account. Feedback is also applied in the simulation.
In the baseline design of the International Linear Collider (ILC) an undulator-based source is foreseen for the positron source in order to match the physics requirements. The recently chosen first energy stage with sqrt(s)=250 GeV requires high luminosity and imposes an effort for all positron source designs at high-energy colliders. In this paper we perform a simulation study and adopt the new technology of plasma lenses to capture the positrons generated by the undulator photons and to create the required high luminosity positron beam.
The International Linear Collider (ILC) will collide polarised electrons and positrons at beam energies of 45.6 GeV to 250 GeV and optionally up to 500 GeV. To fully exploit the physics potential of this machine, not only the luminosity and beam energy have to be known precisely, but also the polarisation of the particles has to be measured with an unprecedented precision of dP/P ~ 0.25% for both beams. An overall concept of high precision polarisation measurements at high beam energies will be presented. The focus will be on the polarimeters (up- and downstream of the e+e- interaction point) …
More than twenty institutes join the FCAL Collaboration in study of design of the very forward region of a detector for ILC and CLIC. Of particular importance is an accurate luminosity measurement to the level of 10-3, a requirement driven by the potential for precision physics at a future linear collider. In this paper, the method for luminosity measurement, requirements on luminometer and its integration in the forward region are presented. The impact of several effects contributing to the systematic uncertainty of luminosity measurement is given.
To achieve the physics goals of future Linear Colliders, it is important that electron and positron beams are polarized. The positron source planned for the International Linear Collider (ILC) is based on a helical undulator system and can deliver a polarised beam with positron polarization of 60%. To ensure that no significant polarization is lost during the transport of the electron and positron beams from the source to the interaction region, spin tracking has to be included in all transport elements which can contribute to a loss of polarization. These are the positron source, the damping …
The strength of the electromagnetic fields in the bunch collision at a linear collider will have a significant effect, yielding large numbers of beamstrahlung photons and associated coherent pair production. These effects are limited in the proposed ILC beam parameters which limit the strength of the bunch field to $Υ_{\text{ave}}=0.27$. The CLIC 3 Tev design by comparison has a $Υ_{\text{ave}}=3.34$ yielding huge number of coherent pairs. In terms of the precision physics programs of these proposed colliders there is an imperative to investigate the effect of the strong bunch fields on higher…
In order to achieve the physics goals of future Linear Colliders, it is important that electron and positron beams are polarized. The baseline design at the International Linear Collider (ILC) foresees an e+ source based on helical undulator. Such a source provides high luminosity and polarizations. The positron source planned for ILC is based on a helical undulator system and can deliver a positron polarization of 60%. To ensure that no significant polarization is lost during the transport of the e- and e+ beams from the source to the interaction region, precise spin tracking has to be includ…
The discovery of the Higgs boson (and still nothing else) have triggered appearance of many proposals of Higgs factories for precision measurement of the Higgs properties. Among them there are several projects of photon colliders (PC) without e+e- in addition to PLC based on e+e- linear colliders ILC and CLIC. In this paper, following a brief discussion of Higgs factories physics program I give an overview of photon colliders based on linear colliders ILC and CLIC, and of the recently proposed photon-collider Higgs factories with no e+e- collision option based on recirculation linacs in ring t…
This Snowmass 2021 contributed paper discusses a Higgs-Energy LEptoN (HELEN) $e^+e^-$ linear collider based on advances superconducting radio frequency technology. The proposed collider offers cost and AC power savings, smaller footprint (relative to the ILC), and could be built at Fermilab with an Interaction Region within the site boundaries. After the initial physics run at 250 GeV, the collider could be upgraded either to higher luminosity or to higher (up to 500 GeV) energies. If the ILC could not be realized in Japan in a timely fashion, the HELEN collider would be a viable option to bui…
