We report the first demonstration to our knowledge of a continuously tunable picosecond laser operating around 1 MHz. The emission can be tuned from 640 to 685 nm and the repetition rate from 200 kHz to 1 MHz with a pulse duration of less than 200 ps. The system is based on a Nd:YVO4 passively Q-switched microchip laser providing a few tens of nJ per pulse. Two cascaded stages of amplification are then used to increase the pulse energy to several microJ . The frequency doubled radiation is then used to pump a periodically-poled-niobate-lithium (PPLN)-based optical parametric generator in an all-solid-state architecture. 20 nJ of tunable signal radiation are obtained. We also demonstrated 300-ps pulses generation in the UV (355 nm) at 1 MHz.
The thermal lensing effects in the lasing crystal appear to be dominant when the pump laser focused on the lasing crystal which causes the local heating effect. The spatial refractive index variations observed if the crystal has non-uniform temperature distribution. In the present study, the demonstration of thermal lensing effect of Brewster-cut Ti: Sapphire crystal carried out when pumped by 25 ps pulses at 80 MHz repetition rate with 532 nm central wavelength, while the average pump power controlled by the attenuator. The thermal lensing effects measured first at the ~293 K temperature and …
We demonstrate the operation of an ultra low repetition rate, high peak power, picosecond diode pumped Nd:YVO4 passively mode locked laser oscillator. Repetition rates even below 1 MHz were achieved with the use of a new design multiple-pass cavity and a semiconductor saturable absorber. Long term stable operation at 1.2 MHz, pulse duration of 16.3 ps and average output power of 470 mW corresponding to 24 KW peak power pulses is reported. This is, to our knowledge, the lowest repetition rate high peak power pulses ever generated directly from a picosecond laser resonator without cavity dumping…
We present a free-running 80-MHz dual-comb polarization-multiplexed solid-state laser which delivers 1.8 W of average power with 110-fs pulse duration per comb. With a high-sensitivity pump-probe setup, we apply this free-running dual-comb laser to picosecond ultrasonic measurements. The ultrasonic signatures in a semiconductor multi-quantum-well structure originating from the quantum wells and superlattice regions are revealed and discussed. We further demonstrate ultrasonic measurements on a thin-film metalized sample and compare these measurements to ones obtained with a pair of locked femt…
We present a simple autocorrelator for ultraviolet pulses based on two-photon conductivity in a bench-top fabricatable sapphire sensor. We perform measurements on femtosecond 226 - 278 nm ultraviolet pulses from the third and fourth harmonics of a standard 76 MHz titanium sapphire oscillator and picosecond 266 nm pulses from the fourth harmonic of a 1064 nm 50 MHz neodymium vanadate oscillator. Our device is sensitive to 2.6 pJ ultraviolet pulses with peak powers below 20 W. These results represent the lowest measured autocorrelation peak powers by over one order of magnitude for a system with…
Mode-locked fiber laser technology to date has been limited to sub-3 μm wavelengths, despite significant application-driven demand for compact picosecond and femtosecond pulse sources at longer wavelengths. Erbium- and holmium-doped fluoride fiber lasers incorporating a saturable absorber are emerging as promising pulse sources for 2.7--2.9 μm, yet it remains a major challenge to extend this coverage. Here, we propose a new approach using dysprosium-doped fiber with frequency shifted feedback (FSF). Using a simple linear cavity with an acousto-optic tunable filter, we generate 33 ps pulses wit…
Absolute output power optimization and performance of a near- to mid-infrared picosecond optical parametric oscillator (OPO) is studied at two high pump powers using a widely-tunable output coupling (OC) technique which provides 15% to 68% OC. The MgO:PPLN-based OPO is synchronously pumped at 81.1 MHz by an Yb:fiber laser with double-peak spectrum. At 2 W pump power, maximum signal (at 1.46 $μ$m) and idler (at 3.92 $μ$m) power of 670 mW and 270 mW are obtained at 27% OC at 47% total extraction efficiency and 58% pump power depletion where at 15.5 W pump power, 7.4 W signal and 2.7 W idler powe…
High spectral purity frequency agile room temperature sources in the terahertz spectrum are foundational elements for imaging, sensing, metrology, and communications. Here we present a chip scale optical parametric oscillator based on an integrated nonlinear microresonator that provides broadly tunable single frequency and multi frequency oscillators in the terahertz regime. Through optical to terahertz down conversion using a plasmonic nanoantenna array, coherent terahertz radiation spanning 2.8 octaves is achieved from 330 GHz to 2.3 THz, with 20 GHz cavity mode limited frequency tuning step…
Here, we demonstrate all-fiber direct amplification of 11 picosecond pulses from a gain-switched laser diode at 1063nm. The diode was driven at a repetition rate of 40MHz and delivered 13$μ$W of fiber-coupled average output power. For the low output pulse energy of 0.33pJ we have designed a multi-stage core pumped preamplifier based on single clad Yb-doped fibers in order to keep the contribution of undesired amplified spontaneous emission as low as possible and to minimize temporal and spectral broadening. After the preamplifier we reduced the 40MHz repetition rate to 1MHz using a fiber coupl…
As we read this text, our eyes dynamically adjust the focal length to keep the line image in focus on the retina. Similarly, in many optics applications the focal length must be dynamically tunable. In the quest for compactness and tunability, flat lenses based on metasurfaces were introduced. However, their dynamic tunability is still limited because their functionality mostly relies upon fixed geometry. In contrast, we put forward an original concept of a tunable Optical Magnetic Lens (OML) that focuses photon beams using a subwavelength-thin layer of a magneto-optical material in a non-unif…
We report on a mid-infrared frequency comb source of unprecedented tunability covering the entire 3-10 μm molecular fingerprint region. The system is based on difference frequency generation in a GaSe crystal pumped by a 151 MHz Yb:fiber frequency comb. The process was seeded with Raman shifted solitons generated in a highly nonlinear suspended-core fiber with the same source. Average powers up to 1.5 mW were achieved at 4.7 μm wavelength.
Optical frequency comb is an enabling technology for a multitude of applications from metrology to ranging and communications. The tremendous progress in sources of optical frequency combs has mostly been centered around the near-infrared spectral region while many applications demand sources in the visible and mid-infrared, which have so far been challenging to achieve, especially in nanophotonics. Here, we report frequency combs tunable from visible to mid-infrared on a single chip based on ultra-widely tunable optical parametric oscillators in lithium niobate nanophotonics. Using picosecond…
Millimeter-scale wide-field mid-infrared photothermal imaging enabled by a broadly tunable picosecond optical parametric oscillator
Leibniz Institute of Photonic Technology（莱布尼茨光子技术研究所）；Otto Schott Institute of Materials Research, Friedrich-Schiller-University Jena（弗里德里希·席勒大学耶拿分校奥托·肖特材料研究所）；Friedrich-Schiller-University Jena（弗里德里希·席勒大学耶拿分校）
Parameter regulations of narrow-linewidth fiber lasers in frequency domain has drawn considerable interests for widespread applications in the light quantum computing, precise coherent detection, and generation of micro-waves. All-optical methods provide compact, precise and fast accesses to achieving these lasers with wavelength-tunability. Here, the optical-thermal effects of graphene is utilized to precisely control operations of free-running lasers with a tuning speed of 140 MHz/ms. Assisted by the single-longitude-mode operation and linewidth suppression of stimulated Brillouin backscatte…
We developed a simple three-stage amplifying tunable cw diode laser system that comprises: a Littrow configuration master laser, frequency stabilized with a dichroic atomic vapor laser lock (DAVLL), an acousto-optic frequency shifter (AOM), an injection-locked slave laser and a tapered amplifier (TA). Slave amplifies the frequency-shifted beam and suppresses (within 0.5%) the strong dependence of its intensity on the AOM carrier frequency, thus acting as an efficient optical limiter. The beam is further amplified in TA. System operates at 780 nm, with an output power above 700 mW, a time-avera…
We use hollow-core fibre to preserve the spectrum and temporal profile of picosecond laser pulses in CBD to suppress 2.6 dB of amplitude noise at MHz noise frequencies, to within 0.01 dB of the shot-noise limit. We provide an enhanced version of the CBD scheme that concatenates circuits to suppress over multiple frequencies and over broad frequency ranges --- we perform a first demonstration that reduces total excess amplitude noise, between 2 - 6 MHz, by 85%. These demonstrations enable passive, broad-band, all-guided fibre laser technology operating at the shot-noise limit.
In this paper, we propose a low-noise, bandwidth tunable microwave photonics filter (MPF) based on stimulated Brillouin scattering (SBS) losses. By suppressing the out-of-band signal with two broadened symmetric SBS losses, pass bandwidth can be tuned from 500 MHz to 10 GHz. Considering the limited interaction in the center frequency range, a flat-top response with 0.3 dB ripple is easily achieved. Unlike a SBS gain based filter, due to the transparency of the pass band in our proposed filter, hardly no noise is detected in a noise measurement against an obvious maximum 5 dB noise pedestal for…
Higher repetition-rate optical pulse trains have been desired for various applications such as high-bit-rate optical communication, photonic analogue-to-digital conversion, and multi- photon imaging. Generation of multi GHz and higher repetition-rate optical pulse trains directly from mode-locked oscillators is often challenging. As an alternative, harmonic injection locking can be applied for extra-cavity repetition-rate multiplication (RRM). Here we have investigated the operation conditions and achievable performances of all-fibre, highly tunable harmonic injection locking-based pulse RRM. …
We report an approach for high-resolution spectroscopy using a widely tunable laser emitting in the molecular fingerprint region. The laser is based on difference-frequency generation (DFG) in a nonlinear orientation-patterned GaAs crystal. The signal laser, a CO2 gas laser, is operated in a kHz-pulsed mode while the pump laser, an external-cavity quantum cascade laser, is finely mode-hop-free tuned. The idler radiation covers a spectral range of 11.6 - 15 μm with a laser linewidth of 2.3 MHz. We showcase the versatility and the potential for molecular fingerprinting of the developed DFG laser…
Directive optical leaky wave antennas (OLWAs) with tunable radiation pattern are promising integrated optical modulation and scanning devices. OLWAs fabricated using CMOS-compatible semiconductor planar waveguide technology have the potential of providing high directivity with electrical tunability for modulation and switching capabilities. We experimentally demonstrate directive radiation from a silicon nitride ($Si_3N_4$) waveguide-based OLWA. The OLWA design comprises 50 crystalline Si perturbations buried inside the waveguide, with a period of 1 μm, each with a length of 260 nm and a heigh…
Optical quantum technologies such as quantum sensing, quantum cryptography and quantum computation all utilize properties of non-classical light, such as precise photon-number and entangled photon-pair states, to surpass technologies based on the classical light. A common route for obtaining heralded single photons is spontaneous four-wave mixing in optical fibers, allowing for a well-defined spatial mode, for high efficiency integration into optical fiber networks. These fibers are typically pumped using large, commercial, pulsed lasers requiring high-power (~10 W) pump lasers and are limited…
Integrated femtosecond pulse and frequency comb sources are critical components for a wide range of applications. The leading approaches for on-chip pulse generation rely on mode locking inside microresonator with either third-order nonlinearity or with semiconductor gain. These approaches, however, are limited in noise performance, wavelength tunability and repetition rates. Alternatively, sub-picosecond pulses can be synthesized without mode-locking, by modulating a continuous-wave (CW) single-frequency laser using a cascade of electro-optic (EO) modulators. This method is particularly attra…
We present a novel, highly versatile, and self-referenced arrival time monitor for measuring the femtosecond time delay between a hard X-ray pulse from a free-electron laser and an optical laser pulse, measured directly on the same sample used for pump-probe experiments. Two chirped and picosecond long optical supercontinuum pulses traverse the sample with a mutually fixed time delay of 970 fs, while a femtosecond X-ray pulse arrives at an instant in between both pulses. Behind the sample the supercontinuum pulses are temporally overlapped to yield near-perfect destructive interference in the …
