We consider the flow of a Newtonian fluid in a nano or microchannel with walls that have patterned variations in slip length. We formulate a set of equations to describe the effects on an incompressible Newtonian flow of small variations in slip, and solve these equations for slow flows. We test these equations using molecular dynamics simulations of flow between two walls which have patterned variations in wettability. Good qualitative agreement and a reasonable degree of quantitative agreement is found between the theory and the molecular dynamics simulations. The results of both analyses show that patterned wettability can be used to induce complex variations in flow. Finally we discuss the implications of our results for the design of microfluidic mixers using slip.
Nanofluidics is an emerging field offering innovative solutions for energy harvesting and desalination. The efficiency of these applications depends strongly on liquid-solid slip, arising from a favorable ratio between viscosity and interfacial friction. Using molecular dynamics simulations, we show that wall slip increases strongly when water is cooled below its melting point. For water on graphene, the slip length is multiplied by up to a factor of five and reaches $230$nm at the lowest simulated temperature, $T \sim 225$K; experiments in nanopores can reach much lower temperatures and could…
Many experiments have shown large flow enhancement ratios (up to 10^5) in carbon nanotubes (CNT) with diameters larger than 5nm. However, molecular dynamics simulations have never replicated these results maintaining a three-order-of-magnitude gap with measurements. Our study provides a generic model of nanofluidics for continuum slip flow (diameter>3nm) that fills this significant gap and sheds light on its origin. Compared to 140 literature cases, the model explains the entire range of experimental flow enhancements by changes of nanotube diameters and finite variations of interfacial energi…
Carbonous materials, such as graphene and carbon nanotube, have attracted tremendous attention in the fields of nanofluidics due to the slip at the interface between solid and liquid. The dependence of slip length for water on the types of supporting substrates and thickness of carbonous layer, which is critical for applications such as sustainable cooling of electronic devices, remains unknown. In this paper, using colloidal probe atomic force microscope, we measured the slip length of water on graphene ls supported by hydrophilic and hydrophobic substrates, i.e., SiO2 and octadecyltrimethoxy…
We propose a method to separate enantiomers in microfluidic or nanofluidic channels. It requires flow profiles which break chiral symmetry and have regions with high local shear. Such profiles can be generated in channels confined by walls with different hydrodynamic boundary conditions (e.g. slip lengths). Due to a nonlinear hydrodynamic effect, particles with different chirality migrate at different speed and can be separated. The mechanism is demonstrated by computer simulations. We investigate the influence of thermal fluctuations (i.e. the Péclet number) and show that the effect disappear…
We investigate the behavior of the slip length in Newtonian liquids subject to planar shear bounded by substrates with mixed boundary conditions. The upper wall, consisting of a homogenous surface of finite or vanishing slip, moves at a constant speed parallel to a lower stationary wall, whose surface is patterned with an array of stripes representing alternating regions of no-shear and finite or no-slip. Velocity fields and effective slip lengths are computed both from molecular dynamics (MD) simulations and solution of the Stokes equation for flow configurations either parallel or perpendicu…
Thermo-osmotic flows - flows generated in micro and nanofluidic systems by thermal gradients - could provide an alternative approach to harvest waste heat. However, such use would require massive thermo-osmotic flows, which are up to now only predicted for special and expensive materials. There is thus an urgent need to design affordable nanofluidic systems displaying large thermo-osmotic coefficients. In this paper we propose a general model for thermo-osmosis of aqueous electrolytes in charged nanofluidic channels, taking into account hydrodynamic slip, together with the different solvent an…
We provide some general theoretical results to guide the optimization of transverse hydrodynamic phenomena in superhydrophobic channels. Our focus is on the canonical micro- and nanofluidic geometry of a parallel-plate channel with an arbitrary two-component (low-slip and high-slip) coarse texture, varying on scales larger than the channel thickness. By analyzing rigorous bounds on the permeability, over all possible patterns, we optimize the area fractions, slip lengths, geometry and orientation of the surface texture to maximize transverse flow. In the case of two aligned striped surfaces, v…
It is known from both experiments and molecular dynamics simulations that chemically patterning a solid surface has an effect on the flow of an adjacent liquid. This fact is in stark contrast with predictions of classical fluid mechanics where the no-slip boundary condition is insensitive to the chemistry of the solid substrate. It has been shown that the influence on the flow caused by a steep change in the wettability of the solid substrate can be described in the framework of continuum mechanics using the interface formation theory. The present work extends this study to the case of intermi…
Patterned surfaces with large effective slip lengths, such as super-hydrophobic surfaces containing trapped gas bubbles, have the potential to greatly enhance electrokinetic phenomena. Existing theories assume either homogeneous flat surfaces or patterned surfaces with thin double layers (compared to the texture correlation length) and thus predict simple surface-averaged, isotropic flows (independent of orientation). By analyzing electro-osmotic flows over striped slip-stick surfaces with arbitrary double-layer thickness, we show that surface anisotropy generally leads to a tensorial electro-…
Superhydrophobic surfaces demonstrate promising potential for skin friction reduction in naval and hydrodynamic applications. Recent developments of superhydrophobic surfaces aiming for scalable applications use random distribution of roughness, such as spray coating and etched process. However, most of previous analyses of the interaction between flows and superhydrophobic surfaces studied periodic geometries that are economically feasible only in lab-scale experiments. We conduct direct numerical simulations of turbulent flows over randomly patterned interfaces considering a range of texture…
Nanofluidic systems show great promises for applications in energy conversion, where their performance can be enhanced by nanoscale liquid-solid slip. However, efficiency is also controlled by surface charge, which is known to reduce slip. Combining molecular dynamics simulations and analytical developments, we show the dramatic impact of surface charge distribution on the slip-charge coupling. Homogeneously charged graphene exhibits a very favorable slip-charge relation (rationalized with a new theoretical model correcting some weaknesses of the existing ones), leading to giant electrokinetic…
In many applications it is advantageous to construct effective slip boundary conditions, which could fully characterize flow over patterned surfaces. Here we focus on laminar shear flows over smooth anisotropic surfaces with arbitrary scalar slip $b(y)$, varying in only one direction. We derive general expressions for eigenvalues of the effective slip-length tensor, and show that the transverse component is equal to a half of the longitudinal one with twice larger local slip, $2b(y)$. A remarkable corollary of this relation is that the flow along any direction of the 1D surface can be easily d…
Although many molecular dynamics simulations have been conducted on slip flow on graphene, experimental efforts remain very limited and our understanding of the flow friction on graphene remains far from sufficient. Here, to accurately measure the slip length in rectangular nanochannels, we develop a 3D capillary flow model that fully considers the nonuniform cross-section velocity profile, slip boundary conditions, and the dynamic contact angle. We show that the 3D analysis is necessary even for a channel with a width/height ratio of 100. We fabricated graphene nanochannels with 45-nm depth a…
We describe a tensorial generalization of the Navier slip boundary condition and illustrate its use in solving for flows around anisotropic textured surfaces. Tensorial slip can be derived from molecular or microstructural theories or simply postulated as an constitutive relation, subject to certain general constraints on the interfacial mobility. The power of the tensor formalism is to capture complicated effects of surface anisotropy, while preserving a simple fluid domain. This is demonstrated by exact solutions for laminar shear flow and pressure-driven flow between parallel plates of arbi…
In a variety of applications, most notably microfluidic design, slip-based boundary conditions have been sought to characterize fluid flow over patterned surfaces. We focus on laminar shear flows over surfaces with periodic height fluctuations and/or fluctuating Navier scalar slip properties. We derive a general formula for the "effective slip", which describes equivalent fluid motion at the mean surface as depicted by the linear velocity profile that arises far from it. We show that the slip and the applied stress are related linearly through a tensorial mobility matrix, and the method of dom…
The classical fluid dynamics boundary condition of no-slip suggests that variation in the wettability of a solid should not affect the flow of an adjacent liquid. However experiments and molecular dynamics simulations indicate that this is not the case. In this paper we show how flow over a solid substrate with variations of wettability can be described in a continuum framework using the interface formation theory developed earlier. Results demonstrate that a shear flow over a perfectly flat solid surface is disturbed by a change in its wettability, i.e. by a change in the chemistry of the sol…
For a microchamber filled with a binary electrolyte and containing a flat un-biased center electrode at one wall, we employ three numerical models to study the strength of the resulting induced-charge electro-osmotic (ICEO) flow rolls: (i) a full nonlinear continuum model resolving the double layer, (ii) a linear slip-velocity model not resolving the double layer and without tangential charge transport inside this layer, and (iii) a nonlinear slip-velocity model extending the linear model by including the tangential charge transport inside the double layer. We show that compared to the full mo…
Motivated by experimental evidence of violations of the no-slip boundary condition for liquid flow in micron-scale geometries, we propose a simple, complementary experimental technique that has certain advantages over previous studies. Instead of relying on externally-induced flow or probe motion, we suggest that colloidal diffusivity near solid surfaces contains signatures of the degree of fluid slip exhibited on those surfaces. To investigate, we calculate the image system for point forces (Stokeslets) oriented perpendicular and parallel to a surface with a finite slip length, analogous to B…
The paper addresses the hydrodynamic behavior of a sphere close to a micro-patterned superhydrophobic surface described in terms of alternated no-slip and perfect-slip stripes. Physically, the perfect-slip stripes model the parallel grooves where a large gas cushion forms between fluid and solid wall, giving rise to slippage at the gas-liquid interface. The potential of the boundary element method (BEM) in dealing with mixed no-slip/perfect-slip boundary conditions is exploited to systematically calculate the mobility tensor for different particle-to-wall relative positions and for different p…
Patterned surfaces with large effective slip lengths, such as super-hydrophobic surfaces containing trapped gas bubbles, have the potential to reduce hydrodynamic drag. Based on lubrication theory, we analyze an approach of a hydrophilic disk to such a surface. The drag force is predicted analytically and formulated in terms of a correction function to the Reynolds equation, which is shown to be the harmonic mean of corrections expressed through effective slip lengths in the two principal (fastest and slowest) orthogonal directions. The reduction of drag is especially pronounced for a thin (co…
Near-boundary Brownian motion is a classic hydrodynamic problem of great importance in a variety of fields, from biophysics to micro-/nanofluidics. However, due to challenges in experimental measurements of near-boundary dynamics, the effect of interfaces on Brownian motion has remained elusive. Here, we report a computational study of this effect using microsecond-long large-scale molecular dynamics simulations and our newly developed Green-Kubo relation for friction at the liquid-solid interface. Our computer experiment unambiguously reveals that the t^(-3/2) long-time decay of the velocity …
This paper presents new analytical formulae for flow in a channel with one or both walls patterned with a longitudinal array of ridges and arbitrarily protruding menisci. Derived from a matched asymptotic expansion, they extend results by Crowdy (J. Fluid Mech., vol. 791, 2016, R7) for shear flow, and thus make no restriction on the protrusion into or out of the liquid. The slip length formula is compared against full numerical solutions and, despite the assumption of small ridge period in its derivation, is found to have a very large range of validity; relative errors are small even for perio…
The present study deals with the effect of ionic advection on electroosmotic flow over charge modulated surfaces in a generalized paradigm when the classically restrictive "weak field" limit may be relaxed. Going beyond the commonly portrayed weak field limit (i.e, the externally applied electric field is over-weighed by the surface-induced electrical potential, towards charge distribution in an electrified wall-adhering layer) for electroosmotic transport, we numerically solve the coupled full set of Poisson-Nernst-Planck (PNP) and Navier-Stokes equations, in a semi-infinite domain, bounded a…
