It is now commonly accepted that the unit disk graph used to model the physical layer in wireless networks does not reflect real radio transmissions, and that the lognormal shadowing model better suits to experimental simulations. Previous work on realistic scenarios focused on unicast, while broadcast requirements are fundamentally different and cannot be derived from unicast case. Therefore, broadcast protocols must be adapted in order to still be efficient under realistic assumptions. In this paper, we study the well-known multipoint relay protocol (MPR). In the latter, each node has to choose a set of neighbors to act as relays in order to cover the whole 2-hop neighborhood. We give experimental results showing that the original method provided to select the set of relays does not give good results with the realistic model. We also provide three new heuristics in replacement and their performances which demonstrate that they better suit to the considered model. The first one maximizes the probability of correct reception between the node and the considered relays multiplied by their coverage in the 2-hop neighborhood. The second one replaces the coverage by the average of the probabilities of correct reception between the considered neighbor and the 2-hop neighbors it covers. Finally, the third heuristic keeps the same concept as the second one, but tries to maximize the coverage level of the 2-hop neighborhood: 2-hop neighbors are still being considered as uncovered while their coverage level is not higher than a given coverage threshold, many neighbors may thus be selected to cover the same 2-hop neighbors.
In this paper, we design and implement a reliable broadcast algorithm over a VANET for supporting multi-hop forwarding of vehicle sensor and control packets that will enable vehicles to platoon with each other in order to form a road train behind the lead truck. In particular, we use multipoint relays (MPRs) for packet transmission, which leads to more efficient communication in a VANET. We evaluate the performance based on simulation by running a platooning simulation application program, and show that with MPRs, the communication in the VANET to form a road train is more efficient and reliab…
We consider the problem of efficient packet dissemination in wireless networks with point-to-multi-point wireless broadcast channels. We propose a dynamic policy, which achieves the broadcast capacity of the network. This policy is obtained by first transforming the original multi-hop network into a precedence-relaxed virtual single-hop network and then finding an optimal broadcast policy for the relaxed network. The resulting policy is shown to be throughput-optimal for the original wireless network using a sample-path argument. We also prove the NP-completeness of the finite-horizon broadcas…
Fine-Grained AI Model Caching and Downloading With Coordinated Multipoint Broadcasting in Multi-Cell Edge Networks
State Key Laboratory of Alternate Electrical Power System with Renewable Energy Sources, School of Electrical and Electronic Engineering, North China Electric Power University（替代电力系统与可再生能源电源国家重点实验室，电气与电子工程学院，华北电力大学）；China Satellite Network Group Shanghai Research Institute（中国卫星网络集团上海研究院）
Relaying techniques for millimeter-wave wireless networks represent a powerful solution for improving the transmission performance. In this work, we quantify the benefits in terms of delay and throughput for a random-access multi-user millimeter-wave wireless network, assisted by a full-duplex network cooperative relay. The relay is equipped with a queue for which we analyze the performance characteristics (e.g., arrival rate, service rate, average size, and stability condition). Moreover, we study two possible transmission schemes: fully directional and broadcast. In the former, the source no…
We propose a method for reconfiguring a relay node for polarization encoded quantum key distribution (QKD) networks. The relay can be switched between trusted and untrusted modes to adapt to different network conditions, relay distances, and security requirements. This not only extends the distance over which a QKD network operates but also enables point-to-multipoint (P2MP) network topologies. The proposed architecture centralizes the expensive and delicate single-photon detectors (SPDs) at the relay node with eased maintenance and cooling while simplifying each user node so that it only need…
In this work, we analyze the throughput of random access multi-user relay-assisted millimeter-wave wireless networks, in which both the destination and the relay have multipacket reception capability. We consider a full-duplex network cooperative relay that stores the successfully received packets in a queue, for which we analyze the performance. Moreover, we study the effects on the network throughput of two different strategies, by which the source nodes transmit either a packet to both the destination and the relay in the same timeslot by using wider beams (broadcast approach) or to only on…
In this paper an innovative Radio Resource Management (RRM) algorithm is proposed with the purpose of increasing High Speed Packet Access (HSPA) performances, in terms of system capacity and service quality, when the Multimedia Broadcast Multicast Services (MBMS) is supplied. The proposed RRM algorithm exploits channel quality indications to set up point-to-multipoint connections to subgroups of multicast users and to select the proper modulation and coding schemes on the downlink. The number of subgroups is determined through an optimization technique that also takes into account the user sat…
We focus on interference mitigation and energy conservation within a single wireless body area network (WBAN). We adopt two-hop communication scheme supported by the the IEEE 802.15.6 standard (2012). In this paper, we propose a dynamic channel allocation scheme, namely DCAIM to mitigate node-level interference amongst the coexisting regions of a WBAN. At the time, the sensors are in the radius communication of a relay, they form a relay region (RG) coordinated by that relay using time division multiple access (TDMA). In the proposed scheme, each RG creates a table consisting of interfering se…
Auckland University of Technology（奥克兰理工大学）；University of Charleston（查尔斯顿大学）
The 5G vehicle-to-everything (V2X) communication for autonomous and semi-autonomous driving utilizes the wireless technology for communication and the Millimeter Wave bands are widely implemented in this kind of vehicular network application. The main purpose of this paper is to broadcast the messages from the mmWave Base Station to vehicles at LOS (Line-of-sight) and NLOS (Non-LOS). Relay using Machine Learning (RML) algorithm is formulated to train the mmBS for identifying the blockages within its coverage area and broadcast the messages to the vehicles at NLOS using a LOS nodes as a relay. …
In this paper, we investigate the performance of LTE Multicast-Broadcast Single-Frequency Networks (MBSFN). LTE-MBSFN is viewed as one of the most promising candidates for vehicular communications which can enhance reliability of vehicular application traffic. This is achieved due to the possibility to efficiently support message exchange in-between vehicles by multicasting information to several vehicles in parallel (point-to-multipoint transmission) employing an Multimedia Broadcast/Multicast Service (MBMS). We investigate two metrics to gauge the performance of MBMS/MBSFN transmissions in c…
This paper studies a novel cooperation method in a two-user wireless powered communication network (WPCN), in which one hybrid access point (HAP) broadcasts wireless energy to two distributed wireless devices (WDs), while the WDs use the harvested energy to transmit their independent information to the HAP. To tackle the user unfairness problem caused by the near-far effect in WPCN, we allow the WD with the stronger WD-to-HAP channel to use part of its harvested energy to help relay the other weaker user's information to the HAP. In particular, we exploit the use of backscatter communication d…
Relay drones in delay-tolerant applications are dispatched to remote locations in order to gather data transmitted by a source node. Collected data are stored on the drones and delivered to one or multiple bases. This paper considers two schemes for broadcasting data to drones when feedback channels are not available: a data carousel and systematic random linear network coding (RLNC). We propose a theoretical framework for the calculation of the probability that a base will fully or partially recover the transmitted data and the probability that all involved bases will successfully obtain the …
The broadcast nature of the wireless medium allows unintended users to eavesdrop the confidential information transmission. In this regard, we investigate the problem of secure communication between a source and a destination via a wireless energy harvesting untrusted node which acts as a helper to relay the information; however, the source and destination nodes wish to keep the information confidential from the relay node. To realize the positive secrecy rate, we use destination-assisted jamming. Being an energy-starved node, the untrusted relay harvests energy from the received radio frequen…
