单片3D DRAM架构中位线布线与键合路径的系统-技术协同优化
System-Technology Co-Optimization of Bitline Routing and Bonding Pathways in Monolithic 3D DRAM Architectures
AI总结:
本文针对3D DRAM布线和键合限制导致的密度扩展问题,提出基于TCAD和SPICE仿真优化位线结构,实现2.6Gb/mm²的高密度和60%的读写能耗降低。
摘要:
3D DRAM已成为持续密度扩展的有前景方法,但其可行性受限于布线和混合键合对外围的限制,可能降低感测裕度、延迟和阵列效率。通过从TCAD中提取器件特性及阵列寄生参数,利用CMOS-Bonded-Array (CBA)进行SPICE仿真,分析表明,采用非晶氧化半导体(AOS)选择器的位线strap架构对于缓解布线拥堵和寄生效应至关重要。优化设计实现了2.6Gb/mm²的位密度(137层Si访问晶体管或87层AOS),相比D1b 2D DRAM密度提升约6倍。设计进一步展示了名义行周期时间(tRC)为10.5ns,相比D1b的21.3ns减少了约50%,读写能耗降低了60%。
英文摘要:
3D DRAM has emerged as a promising approach for continued density scaling, but its viability is limited by routing and hybrid bonding constraints to periphery, which may degrade sensing margin, latency, and array efficiency. With device characteristics and array parasitics extracted from TCAD, SPICE simulations are performed with peri logic in a CMOS-Bonded-Array (CBA). The analysis shows that the bitline strap architecture with amorphous oxide semiconductor (AOS) selectors is essential to manage routing congestion and parasitics. The optimized design achieves a bit density of 2.6 Gb/mm^2 (137 layers with Si access transistors or 87 layers with AOS), representing ~6x density scaling over D1b 2D DRAM. The design further demonstrates a nominal row cycle time (tRC) of 10.5 ns, compared to 21.3 ns in D1b, and a 60% reduction in read/write energy.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。