In this letter, we consider a uniform circular array (UCA)-based line-of-sight multiple-input-multiple-output system, where the transmit and receive UCAs are parallel but non-coaxial with each other. We propose a simple channel-independent beamforming scheme with fast symbol-wise maximum likelihood detection.
In this letter, we consider a uniform circular array (UCA) based line-of-sight (LOS) multiple-input-multiple-output (MIMO) system, where the transmit and receive UCAs are aligned with each other. We propose a simple channel independent beamforming scheme with fast symbol-wise maximum likelihood (ML) detection.
This paper summarizes an investigation around millimeter-wave (mmWave) multimode circular antenna array based beamformer capable of specially encoded data transmission in a wide coverage area. The circular antenna array is capable of an entire 360 deg. azimuth sector coverage where broadcast, uni-cast and multi-cast radio transmissions are possible. Orbital angular momentum (OAM) mode transmission along the elevation axis, i.e., perpendicular to the azimuth plane, can also be achieved. These two types of spatially encoded beamforming makes coverage in almost an entire hemisphere possible. The …
Cognitive multiple-input multiple-output (MIMO) radar is capable of adjusting system parameters adaptively by sensing and learning in complex dynamic environment. Beamforming performance of MIMO radar is guided by both beamforming weight coefficients and the transceiver configuration. We propose a cognitive-driven MIMO array design where both the beamforming weights and the transceiver configuration are adaptively and concurrently optimized under different environmental conditions. The perception-action cycle involves data collection of full virtual array, covariance reconstruction and joint d…
The transmitter signals in the fifth generation (5G) wireless networks suffer from significant path loss due to the use of higher frequencies in Sub-6 GHz and millimeter-wave (mmWave) bands. Therefore, beamforming is an essential and powerful tool in 5G to enhance signal for the desired direction and suppress interferences from other directions. For a given number of antenna elements, the geometry of the array dictates its beam pattern. Most of the works in the existing literature address the use of rectangular planar antenna (RPA) arrays for 5G beamforming. In this work, we demonstrate that a…
This paper studies hybrid beamforming for active sensing applications, such as millimeter-wave or ultrasound imaging. Hybrid beamforming can substantially lower the cost and power consumption of fully digital sensor arrays by reducing the number of active front ends. Sparse arrays can be used to further reduce hardware costs. We consider phased arrays and employ linear beamforming with possibly sparse array configurations at both the transmitter and receiver. The quality of the acquired images is improved by adding together several component images corresponding to different transmissions and …
Sparse array design aided by emerging fast sensor switching technologies can lower the overall system overhead by reducing the number of expensive transceiver chains. In this paper, we examine the active sparse array design enabling the maximum signal to interference plus noise ratio (MaxSINR) beamforming at the MIMO radar receiver. The proposed approach entails an entwined design, i.e., jointly selecting the optimum transmit and receive sensor locations for accomplishing MaxSINR receive beamforming. Specifically, we consider a co-located multiple-input multiple-output (MIMO) radar platform wi…
We propose an efficient method for designing broad beams with spatially flat array factor and efficient power utilization for cell-specific coverage in communication systems equipped with large antenna arrays. To ensure full power efficiency, the method is restricted to phase-only weight manipulations. Our framework is based on the discovered connection between dual-polarized beamforming and polyphase Golay sequences. Exploiting this connection, we propose several methods for array expansion from smaller to larger sizes, while preserving the radiation pattern. In addition, to fill the gaps in …
Efficient and low-complexity beamforming design is an important element of satellite communication systems with mobile receivers equipped with phased arrays. In this work, we apply the simultaneous perturbation stochastic approximation (SPSA) method with successive sub-array selection for finding the optimal antenna weights that maximize the received signal power at a uniform plane array (UPA). The proposed algorithms are based on iterative gradient approximation by injecting some carefully designed perturbations on the parameters to be estimated. Additionally, the successive sub-array selecti…
The paper considers sparse array design for receive beamforming achieving maximum signal-to-interference plus noise ratio (MaxSINR) for both single point source and multiple point sources, operating in an interference active environment. Unlike existing sparse design methods which either deal with structured environment-independent or non-structured environment-dependent arrays, our method is a hybrid approach and seeks a full augumentable array that optimizes beamformer performance. This approach proves important for limited aperture that constrains the number of possible uniform grid points …
In this paper, we propose a beamforming design for dual-functional radar-communication (DFRC) systems at the millimeter wave (mmWave) band, where hybrid beamforming and sub-arrayed MIMO radar techniques are jointly exploited. We assume that a base station (BS) is serving a user equipment (UE) located in a Non-Line-of-Sight (NLoS) channel, which in the meantime actively detects multiple targets located in a Line-of-Sight (LoS) channel. Given the optimal communication beamformer and the desired radar beampattern, we propose to design the analog and digital beamformers under non-convex constant-m…
Beamforming makes possible a focused communication method. It is extensively employed in many disciplines involving electromagnetic waves, including arrayed ultrasonic, optical, and high-speed wireless communication. Conventional beam steering often requires the addition of separate active amplitude phase control units after each radiating element. The high power consumption and complexity of large-scale phased arrays can be overcome by reducing the number of active controllers, pushing beamforming into satellite communications and deep space exploration. Here, we suggest a brand-new design fo…
This paper studies analog beamforming in active sensing applications, such as millimeter-wave radar or ultrasound imaging. Analog beamforming architectures employ a single RF-IF chain connected to all array elements via inexpensive phase shifters. This can drastically lower costs compared to fully-digital beamformers having a dedicated RF-IF chain for each sensor. However, controlling only the element phases may lead to elevated side-lobe levels and degraded image quality. We address this issue by image addition, which synthesizes a high resolution image by adding together several lower resolu…
This paper discusses early results associated with a fully-digital direct-conversion array receiver at 28~GHz. The proposed receiver makes use of commercial off-the-shelf (COTS) electronics, including the receiver chain. The design consists of a custom 28~GHz patch antenna sub-array providing gain in the elevation plane, with azimuthal plane beamforming provided by real-time digital signal processing (DSP) algorithms running on a Xilinx Radio Frequency System on Chip (RF SoC). The proposed array receiver employs element-wise fully-digital array processing that supports ADC sample rates up to 2…
The passive electronically scanned array (PESA) is widely used due to its simple structure and low cost. {Its antenna weights have unit modulus and thus, only the weights phases can be controlled. PESA has limited degrees of freedom for beampattern design, where only the direction of the main beam can be controlled.} In this paper we propose a novel way to improve the beamforming capability of PESA by endowing it with more degrees of freedom via the use of double phase shifters (DPS). By doing so, both the magnitude and the phase of the antenna weights can be controlled, allowing for more flex…
We develop sparse array receive beamformer design methods achieving maximum signal-to-interference plus noise ratio (MaxSINR) for wideband sources and jammers. Both tapped delay line (TDL) filtering and the DFT realizations to wideband array processing are considered. The array sparsity stems from the limited number of available RF transmission chains that switch between the sensors, thereby configuring different arrays at different times. The sparse array configuration design problem is formulated as a quadratically constraint quadratic program (QCQP) and solved by using SDR (semidefinite rel…
Flexible Beamforming Design with Two-layer Rotatable Antenna: Synergizing Array and Antenna Rotations
The Chinese University of Hong Kong, Shenzhen（香港中文大学（深圳））；Southern University of Science and Technology (SUSTech)（南方科技大学）；University of Waterloo（滑铁卢大学）；National University of Singapore（新加坡国立大学）
A new approach to distributed syntonization (frequency alignment) for the coordination of nodes in open loop coherent distributed antenna arrays to enable distributed beamforming is presented. This approach makes use of the concept of consensus optimization among nodes without requiring a centralized control. Decentralized frequency consensus can be achieved through iterative frequency exchange among nodes. We derive a model of the signal received from a coherent distributed array and analyze the effects on beamforming of phase errors induced by oscillator frequency drift. We introduce and dis…
This paper presents a spatial-temporal single harmonic switching (STHS) transmitter array architecture with enhanced efficiency in the power back-off (PBO) region. STHS is an electromagnetic and circuit co-designed and jointly optimized transmitter array that realizes beamforming and back-off power generation at the same time. The temporal dimension is originally added in STHS to achieve back-off efficiency enhancement, which can be combined with conventional power back-off enhancement methods such as Doherty amplifiers and envelope tracking. The design is validated through a simulation of a t…
In this paper, we propose a beamforming method for the calibration of the direction-independent gain of the analog chains of aperture arrays. The gain estimates are obtained by cross-correlating the output voltage of each antenna with a voltage beamformed using the other antennas of the array. When the beamforming weights are equal to the average cross-correlated power, a relation is drawn with the StEFCal algorithm. An example illustrates this approach for few point sources and a 256-element array.
In modern applications multi-sensor arrays are subject to an ever-present demand to accommodate signals with higher bandwidths. Standard methods for broadband beamforming, namely digital beamforming and true-time delay, are difficult and expensive to implement at scale. In this work, we explore an alternative method of broadband beamforming that uses a set of linear measurements and a robust low-dimensional signal subspace model. The linear measurements, taken directly from the sensors, serve as a method for dimensionality reduction and serve to limit the array readout. From these embedded sam…
In this article, we propose a novel digital predistortion (DPD) solution that allows to considerably reduce the complexity resulting from linearizing a set of power amplifiers (PAs) in single-user large-scale digital beamforming transmitters. In contrast to current state-of-the art solutions that assume a dedicated DPD per power amplifier, which is unfeasible in the context of large antenna arrays, the proposed solution only requires a single DPD in order to linearize an arbitrary number of power amplifiers. To this end, the proposed DPD predistorts the signal at the input of the digital preco…
This paper considers a lens antenna array-assisted millimeter wave (mmWave) multiuser multiple-input multiple-output (MU-MIMO) system. The base station's beam selection matrix and user terminals' phase-only beamformers are jointly designed with the aim of maximizing the uplink sum rate. In order to deal with the formulated mixed-integer optimization problem, a penalty dual decomposition (PDD)-based iterative algorithm is developed via capitalizing on the weighted minimum mean square error (WMMSE), block coordinate descent (BCD), and minorization-maximization (MM) techniques. Moreover, a low-co…
Reconfigurable intelligent surface (RIS) assisted millimeter-wave (mmWave) communication systems relying on hybrid beamforming structures are capable of achieving high spectral efficiency at a low hardware complexity and low power consumption. In this paper, we propose an RIS-assisted mmWave point-to-point system relying on dynamically configured sub-array connected hybrid beamforming structures. More explicitly, an energy-efficient analog beamformer relying on twin-resolution phase shifters is proposed. Then, we conceive a successive interference cancelation (SIC) based method for jointly des…
Increasing the number of transmit and receive elements in multiple-input-multiple-output (MIMO) antenna arrays imposes a substantial increase in hardware and computational costs. We mitigate this problem by employing a reconfigurable MIMO array where large transmit and receive arrays are multiplexed in a smaller set of k baseband signals. We consider four stages for the MIMO array configuration and propose four different selection strategies to offer dimensionality reduction in post-processing and achieve hardware cost reduction in digital signal processing (DSP) and radio-frequency (RF) stage…
Implicit Neural Representation for Multiuser Continuous Aperture Array Beamforming
School of Electronics and Information Engineering, Beihang University（北京航空航天大学电子信息工程学院）；School of Electronic Engineering and Computer Science, Queen Mary University of London（伦敦大学玛丽女王学院电子工程与计算机科学学院）
Millimeter wave (mmW) communications is the key enabler of 5G cellular networks due to vast spectrum availability that could boost peak rate and capacity. Due to increased propagation loss in mmW band, transceivers with massive antenna array are required to meet link budget, but their power consumption and cost become limiting factors for commercial systems. Radio designs based on hybrid digital and analog array architectures and the usage of radio frequency (RF) signal processing via phase shifters have emerged as potential solutions to improve energy efficiency and deliver performances close…
Dual Orthogonal Projections for Multiuser Interference Cancellation in mmWave Beamforming With Uniform Planar Arrays
Harbin Institute of Technology（哈尔滨工业大学）；National Research Council, Institute of Electronics, Computer and Telecommunication Engineering (CNR-IEIIT)（国家研究委员会电子、计算机和电信工程研究所）；University of Bologna（博洛尼亚大学）
A Fully Reconfigurable RF Vector Modulator based Wideband Phase Shifter for NextG Beamforming Phased Array in Satellite Communications (SATCOM)
University of North Dakota（北达科他大学）；Florida A&M University - Florida State University College of Engineering（佛罗里达农工大学-佛罗里达州立大学工程学院）；University of Massachusetts, Lowell（马萨诸塞大学洛厄尔分校）
