We develop sparse array receive beamformer design methods achieving maximum signal-to-interference plus noise ratio (MaxSINR) for wideband sources and jammers. Both tapped delay line (TDL) filtering and the DFT realizations to wideband array processing are considered. The array sparsity stems from the limited number of available RF transmission chains that switch between the sensors, thereby configuring different arrays at different times. The sparse array configuration design problem is formulated as a quadratically constraint quadratic program (QCQP) and solved by using SDR (semidefinite relaxation). A computationally viable approach through SCA (successive convex relaxation) is also pursued. In order to realize an implementable design, in presence of missing autocorrelation lags, we propose parameter-free block Toeplitz matrix completion to estimate the received data correlation matrix across the entire array aperture. It is shown that the optimum wideband sparse array effectively utilizes the array aperture and provides considerable performance improvement over suboptimal array topologies.
Intelligent reflecting surface (IRS) has emerged as a revolutionizing solution to enhance wireless communications by intelligently changing the propagation environment. Prior studies on IRS are based on an ideal reflection model with a constant amplitude and a variable phase shift. However, it is difficult and unrealistic to implement an IRS satisfying such ideal reflection model in practical applications. In this letter, we aim to investigate the phase-amplitude-frequency relationship of the reflected signals and propose a practical model of reflection coefficient for an IRS-aided wideband sy…
A Fully Reconfigurable RF Vector Modulator based Wideband Phase Shifter for NextG Beamforming Phased Array in Satellite Communications (SATCOM)
University of North Dakota（北达科他大学）；Florida A&M University - Florida State University College of Engineering（佛罗里达农工大学-佛罗里达州立大学工程学院）；University of Massachusetts, Lowell（马萨诸塞大学洛厄尔分校）
Switch-based hybrid beamforming (SW-HBF) architectures are promising for realizing massive multiple-input multiple-output (MIMO) communications systems because of their low cost and low power consumption. In this paper, we study the performance of SW-HBF in a wideband multi-carrier MIMO communication system considering the beam squint effect. We aim at designing the switch-based combiner that maximizes the system spectral efficiency (SE). However, the design problem is challenging because the analog combing matrix elements are binary variables. To overcome this, we propose tabu search-based (T…
Full-duplex (FD) systems have the capability to transmit and receive at the same time in the same frequency band. FD systems can reduce congestion and latency and improve coverage and spectral efficiency. As a relay, they can increase range and decrease outages. Full-duplex (FD) wireless systems have been emerging as a practical solution to provide high bandwidth, low latency, and big data processing in millimeter wave and Terahertz systems to support cellular networks, autonomous driving, platooning, advanced driving assistance and other systems. However, FD systems suffer from loopback self-…
The decadal research in integrated true-time-delay arrays have seen organic growth enabling realization of wideband beamformers for large arrays with wide aperture widths. This article introduces highly reconfigurable delay elements implementable at analog or digital baseband that enables multiple SSP functions including wideband beamforming, wideband interference cancellation, and fast beam training. Details of the beam-training algorithm, system design considerations, system architecture and circuits with large delay range-to-resolution ratios are presented leveraging integrated delay compen…
Recently, full duplex (FD) has been studied in 5G LTE millimeter wave (mmWave) cellular communications for New Radio in 3GPP releases 15-17. FD allows bidirectional transmission over the same resources and has the potential to reduce latency and double spectral efficiency. Self-interference (SI) is the primary drawback. SI can be several orders of magnitude greater than the received signal power, saturate the analog-to-digital converters (ADCs) and degrade communication performance severely. Massive mmWave antenna arrays may provide enough degrees of freedom for spatial multiplexing and SI sup…
The wide bandwidths offered at millimeter-wave (mmWave) frequencies have made them an attractive choice for future wireless communication systems. Recent works have presented beamforming strategies for enabling in-band full-duplex (FD) capability at mmWave even under the constraints of hybrid beamforming, extending the exciting possibilities of next-generation wireless. Existing mmWave FD designs, however, do not consider frequency-selective mmWave channels. Wideband communication at mmWave suggests that frequency-selectivity will likely be of concern since communication channels will be on th…
Sparse arrays are popular for performance optimization while keeping the hardware and computational costs down. In this paper, we consider sparse arrays design method for wideband source operating in a wideband jamming environment. Maximizing the signal-to-interference plus noise ratio (MaxSINR) is adopted as an optimization objective for wideband beamforming. Sparse array design problem is formulated in the DFT domain to process the source as parallel narrowband sources. The problem is formulated as quadratically constraint quadratic program (QCQP) alongside the weighted mixed $l_{1-\infty}$-…
We present a beamforming algorithm for multiuser wideband millimeter wave (mmWave) communication systems where one access point uses hybrid analog/digital beamforming while multiple user stations have phased-arrays with a single RF chain. The algorithm operates in a more general mode than others available in literature and has lower computational complexity and training overhead. Throughout the paper, we describe: i) the construction of novel beamformer sets (codebooks) with wide sector beams and narrow beams based on the orthogonality property of beamformer vectors, ii) a beamforming algorith…
Dual-function radar-communication (DFRC) systems, which can efficiently utilize the congested spectrum and costly hardware resources by employing one common waveform for both sensing and communication (S&C), have attracted increasing attention. While the orthogonal frequency division multiplexing (OFDM) technique has been widely adopted to support high-quality communications, it also has great potentials of improving radar sensing performance and providing flexible S&C. In this paper, we propose to jointly design the dual-functional transmit signals occupying several subcarriers to realize mul…
This paper proposes a new sparse array source enumeration algorithm for underdetermined scenarios with more sources than sensors. The proposed algorithm decomposes the wideband signals into multiple uncorrelated frequency bands, computes the narrowband spatial periodograms and then averages periodograms to reinforce the sources' spectral information. The inverse spatial Fourier transform of the wideband periodogram estimates the spatial correlation function, which then populates the diagonals of a Hermitian Toeplitz augmented covariance matrix (ACM) after lag redundancy averaging. A modified m…
Hybrid beamforming for Terahertz (THz) ultra-massive multiple-input multiple-output (UM-MIMO) systems is a promising technology for 6G space-air-ground integrated networks, which can overcome huge propagation loss and offer unprecedented data rates. With ultra-wide bandwidth and ultra-large-scale antennas array in THz band, the beam squint becomes one of the critical problems which could reduce the array gain and degrade the data rate substantially. However, the traditional phase-shifters-based hybrid beamforming architectures cannot tackle this issue due to the frequency-flat property of the …
The narrowband and far-field assumption in conventional wireless system design leads to a mismatch with the optimal beamforming required for wideband and near-field systems. This discrepancy is exacerbated for larger apertures and bandwidths. To characterize the behavior of near-field and wideband systems, we derive the beamforming gain expression achieved by a frequency-flat phased array designed for plane-wave propagation. To determine the far-field to near-field boundary for a wideband system, we propose a frequency-selective distance metric. The proposed far-field threshold increases for f…
In this article, we discuss the potential of radio frequency (RF) lens for ultra-wideband millimeter-wave (mmWave) systems. In terms of the beam squint, we compare the proposed RF lens antenna with the phase shifter-based array for hybrid beamforming. To reduce the complexities for fully digital beamforming, researchers have come up with RF lens-based hybrid beamforming. The use of mmWave systems, however, causes an increase in bandwidth, which gives rise to the beam squint phenomenon. We first find the causative factors for beam squint in the dielectric RF lens antenna. Based on the beamformi…
Beamspace multi-input multi-output (MIMO) relying on lens antenna arrays can significantly reduce the number of radio-frequency chains in millimeter-wave (mmWave) communication systems through beam selection. However, the beamforming gain is actually frequency-dependent in wideband mmWave MIMO systems. This phenomenon is called beam squint, which will deteriorate the system's performance when traditional beam selection methods are used. To solve this problem, we propose a wideband beam selection method for mmWave MIMO systems relying on lens antenna arrays. Firstly, we select one beam with the…
In the area of near-field millimeter-wave imaging, the generalized sparse array synthesis (SAS) method is in great demand. The traditional methods usually employ the greedy algorithms, which may have the convergence problem. This paper proposes a convex optimization model for the multiple-input multiple-output (MIMO) array design based on the compressive sensing (CS) approach. We generate a block shaped reference pattern, to be used as an optimizing target. The pattern occupies the entire imaging area of interest in order to involve the effect of each pixel into the optimization model. In MIMO…
Beamforming technology is widely used in millimeter wave systems to combat path losses, and beamformers are usually selected from a predefined codebook. Unfortunately, the traditional codebook design neglects the beam squint effect, and this will cause severe performance degradation when the bandwidth is large. In this letter, we consider that a codebook with fixed size is adopted in the wideband beamforming system. First, we analyze how beam squint affects system performance when all beams have the same width. The expression of average spectrum efficiency is derived based on the ideal beam pa…
Sparse array design aided by emerging fast sensor switching technologies can lower the overall system overhead by reducing the number of expensive transceiver chains. In this paper, we examine the active sparse array design enabling the maximum signal to interference plus noise ratio (MaxSINR) beamforming at the MIMO radar receiver. The proposed approach entails an entwined design, i.e., jointly selecting the optimum transmit and receive sensor locations for accomplishing MaxSINR receive beamforming. Specifically, we consider a co-located multiple-input multiple-output (MIMO) radar platform wi…
