谐振波束通信的设计与性能——第二部分:移动场景
Design and Performance of Resonant Beam Communications -- Part II: Mobile Scenario
AI总结:
本文研究移动场景下点对点谐振波束通信系统,推导了联合多普勒效应、信道变化和回波干扰的信道模型,证明无频率补偿时信道增益随帧数递减,并以序列参数凸近似方法求解吞吐量最大化问题,仿真验证了分析。
摘要:
这篇分为两部分的文章专注于准静态和移动场景下点对点谐振波束通信(RBCom)系统的系统设计与性能分析。本文第一部分提出了一种基于同步的信息传输方案,并推导了准静态信道情况下的容量上下界。在第二部分中,我们处理移动场景,其中接收机相对于发射机运动,并推导了一个联合考虑多普勒效应、信道变化和回波干扰的移动 RBCom 信道模型。利用获得的信道模型,我们证明了移动 RBCom 的信道增益随着传输帧数的增加而减小,从而表明所考虑的移动 RBCom 在发射机发送一定数量的帧且没有频率补偿的情况下会终止。通过推导成功传输帧数的上界,我们为所考虑的移动 RBCom 系统构建了吞吐量最大化问题,并通过序列参数凸近似(SPCA)方法求解。最后,仿真结果验证了所提方法在一些典型场景中的分析。
英文摘要:
This two-part paper focuses on the system design and performance analysis for a point-to-point resonant beam communication (RBCom) system under both the quasi-static and mobile scenarios. Part I of this paper proposes a synchronization-based information transmission scheme and derives the capacity upper and lower bounds for the quasi-static channel case. In Part II, we address the mobile scenario, where the receiver is in relative motion to the transmitter, and derive a mobile RBCom channel model that jointly considers the Doppler effect, channel variation, and echo interference. With the obtained channel model, we prove that the channel gain of the mobile RBCom decreases as the number of transmitted frames increases, and thus show that the considered mobile RBCom terminates after the transmitter sends a certain number of frames without frequency compensation. By deriving an upper bound on the number of successfully transmitted frames, we formulate the throughput maximization problem for the considered mobile RBCom system, and solve it via a sequential parametric convex approximation (SPCA) method. Finally, simulation results validate the analysis of our proposed method in some typical scenarios.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。