arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 2403.16042eess.SYcs.SY
收藏

材料挤出增材制造的力控制打印

Force Controlled Printing for Material Extrusion Additive Manufacturing

Xavier Guidetti, Nathan Mingard, Raul Cruz-Oliver, Yannick Nagel, Marvin Rueppel, Alisa Rupenyan, Efe C. Balta, John Lygeros

AI总结:

针对材料挤出增材制造中前馈控制无法适应干扰且依赖大量调参的问题,提出首个基于实时挤出力反馈的闭环力控制打印框架,显著提升了打印质量与抗干扰能力。

摘要:

在材料挤出增材制造中,挤出过程通常以前馈方式进行控制。每个打印位置要挤出的材料量由规划软件预先计算。这种方法本质上无法使挤出适应外部和意外的干扰,且结果的质量很大程度上取决于许多建模和调参参数。为了克服这些限制,我们提出了首个用于材料挤出增材制造的力控制打印框架。我们利用定制的挤出机实时测量挤出力,并将该量作为反馈,以闭环方式连续控制材料流量。我们证明了挤出力与线宽之间存在强相关性,并利用这一点在33%至233%喷嘴直径的宽度范围内沉积所需宽度的线条。我们还展示了力控制打印在打印质量和抗干扰能力方面如何优于传统的前馈挤出,同时只需少量调参并能自动适应硬件设置的变化。无需任何适应性调整,力控制打印即可在底床调平受到严重干扰的情况下沉积所需宽度的线条,例如在20%至200%标称高度的层高范围内。

英文摘要:

In material extrusion additive manufacturing, the extrusion process is commonly controlled in a feed-forward fashion. The amount of material to be extruded at each printing location is pre-computed by a planning software. This approach is inherently unable to adapt the extrusion to external and unexpected disturbances, and the quality of the results strongly depends on a number of modeling and tuning parameters. To overcome these limitations, we propose the first framework for Force Controlled Printing for material extrusion additive manufacturing. We utilize a custom-built extruder to measure the extrusion force in real time, and use this quantity as feedback to continuously control the material flow in closed-loop. We demonstrate the existence of a strong correlation between extrusion force and line width, which we exploit to deposit lines of desired width in a width range of 33 % up to 233 % of the nozzle diameter. We also show how Force Controlled Printing outperforms conventional feed-forward extrusion in print quality and disturbance rejection, while requiring little tuning and automatically adapting to changes in the hardware settings. With no adaptation, Force Controlled Printing can deposit lines of desired width under severe disturbances in bed leveling, such as at layer heights ranging between 20 % and 200 % of the nominal height.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑