我们基于Altera的Stratix II GX收发器信号完整性开发套件,开发了一款定制的误码率测试台,在数据速率高达5 Gbps的点对点串行光链路上对其进行了验证,并将其与商用独立测试仪进行了对比。我们实现了8B/10B协议并研究了其影响。我们在光纤环路中插入一个可变光衰减器,以引入传输劣化并测量接收器灵敏度。我们报告称,基于FPGA的测试仪与商用测试仪得出的接收器灵敏度结果相当。FPGA的测试结果还显示,在较低误码率下,1到0的比特翻转数量多于0到1的比特翻转数量。在8B/10B编码传输中,字错误数量多于比特翻转数量,且总误码率不到非编码传输总误码率的两倍。根据协议设置,测得的总误码率与仿真结果一致。
英文摘要:
We develop a custom Bit Error Rate test bench based on Altera's Stratix II GX transceiver signal integrity development kit, demonstrate it on point-to-point serial optical link with data rate up to 5 Gbps, and compare it with commercial stand alone tester. The 8B/10B protocol is implemented and its effects studied. A variable optical attenuator is inserted in the fibre loop to induce transmission degradation and to measure receiver sensitivity. We report comparable receiver sensitivity results using the FPGA based tester and commercial tester. The results of the FPGA also shows that there are more one-to-zero bit flips than zero-to-one bit flips at lower error rate. In 8B/10B coded transmission, there are more word errors than bit flips, and the total error rate is less than two times that of non-coded transmission. Total error rate measured complies with simulation results, according to the protocol setup.
Serenity-S1, a CMS Tracker Readout and Data Processing Card for HL-LHC
Imperial College London(帝国理工学院);Karlsruhe Institute of Technology(卡尔斯鲁厄理工学院);STFC Rutherford Appleton Laboratory(STFC卢瑟福阿普尔顿实验室);University of Bristol(布里斯托大学);Chinese Academy of Sciences(中国科学院)
Design and implementation of a high-density sub-nanosecond timing system for a C-band photocathode electron gun test platform
Institute of High Energy Physics, Chinese Academy of Sciences(中国科学院高能物理研究所);Spallation Neutron Source Science Center(散裂中子源科学中心);University of Chinese Academy of Sciences(中国科学院大学)
PCI-express based high-speed readout for the BelleII DAQ upgrade
Belle II是新一代的B工厂实验,致力于探索风味领域基本粒子标准模型之外的新物理。Belle~II于2018年4月开始使用基于流水线触发流控制的同步数据采集(DAQ)系统进行数据采集。Belle II DAQ系统设计用于处理30 kHz触发率,在原始事件大小为1 MB的假设下,约有1%的死区时间。数据采集系统可靠,在2020年1月至2020年6月的运行期间,整体数据采集效率达到84. 2%。从DAQ可维护性的角度来看,目前的读出系统无法在10年内运行;同时,读出系统阻碍了高速数据传输。Belle II数据采集系统升级采用了基于PCI-express的读取模块,数据吞吐量高达100 Gb/s。我们特别关注基于这款新一代读出板(称为PCIe 40)的固件和软件设计,该读出板采用Altera Arria 10现场可编程门阵列芯片。设计了48个GBT(GigaBit Transceiver)串行链路、PCI-express硬IP DMA架构、定时和触发分配系统接口以及慢速控制系统,与现有Belle II DAQ系统集成。本文介绍了在数据读出和慢控制测试期间完成的性能,使用测试台和现场前端电子设备进行演示,特别是涉及Belle II TOP和KLM子探测器。