A hardware model for active simultaneously transmitting and reflecting reconfigurable intelligent surfaces (STAR-RISs) is proposed consisting of reflection-type amplifiers. The amplitude gains of the STAR element are derived for both coupled and independent phase-shift scenarios. Based on the proposed hardware model, an active STAR-RIS-aided two-user downlink communication system is investigated. Closed-form expressions are obtained for the outage probabilities of both the coupled and independent phase-shift scenarios. To obtain further insights, scaling laws and diversity orders are derived for both users. Analytical results confirm that active STAR-RIS achieves the same diversity orders as passive ones while their scaling laws are different. It is proved that average received SNRs scale with M and M^2 for active and passive STAR-RISs, respectively. Numerical results show that active STAR-RISs outperform passive STAR-RISs in terms of outage probability especially when the number of elements is small.
In this letter, simultaneous transmitting and reflecting reconfigurable intelligent surfaces (STAR-RISs) are studied. Compared with the conventional reflecting-only RISs, the coverage of STAR-RISs is extended to 360 degrees via simultaneous transmission and reflection. A general hardware model for STAR-RISs is presented. Then, channel models are proposed for the near-field and the far-field scenarios, base on which the diversity gain of the STAR-RISs is analyzed and compared with that of the conventional RISs. Numerical simulations are provided to verify analytical results and to demonstrate t…
A hardware model and a signal model are proposed for dual-sided simultaneously transmitting and reflecting reconfigurable intelligent surfaces (STAR-RISs), where the signal simultaneously incident on both sides of the surface. Based on the proposed hardware model, signal models for dual-sided STAR-RISs are developed. For elements with scalar surface impedance, it is proved that their transmission and reflection coefficients on both sides are identical. Based on the obtained symmetrical dual-sided STAR model, a STAR-RIS-aided two-user uplink communication system is investigated for both non-ort…
Reconfigurable intelligent surfaces (RISs) have emerged as a cost- and energy-efficient technology that can customize and program the physical propagation environment by reflecting radio waves in preferred directions. However, the purely passive reflection of RISs not only limits the end-to-end channel beamforming gains, but also hinders the acquisition of accurate channel state information for the phase control at RISs. In this paper, we provide an overview of a hybrid relay-reflecting intelligent surface (HR-RIS) architecture, in which only a few elements are active and connected to power am…
A simultaneously transmitting and reflecting reconfigurable intelligent surface (STAR-RIS) aided communication system is investigated, where an access point sends information to two users located on each side of the STAR-RIS. Different from current works assuming that the phase-shift coefficients for transmission and reflection can be independently adjusted, which is non-trivial to realize for purely passive STAR-RISs, a coupled transmission and reflection phase-shift model is considered. Based on this model, a power consumption minimization problem is formulated for both non-orthogonal multip…
Different from traditional reflection-only reconfigurable intelligent surfaces (RISs), simultaneously transmitting and reflecting RISs (STAR-RISs) represent a novel technology, which extends the half-space coverage to full-space coverage by simultaneously transmitting and reflecting incident signals. STAR-RISs provide new degrees-of-freedom (DoF) for manipulating signal propagation. Motivated by the above, a novel STAR-RIS assisted non-orthogonal multiple access (NOMA) (STAR-RIS-NOMA) system is proposed in this paper. Our objective is to maximize the achievable sum rate by jointly optimizing t…
Reconfigurable intelligent surfaces (RISs) are envisioned as a promising technology for future wireless communications. With various hardware realizations, RISs can work under different modes (reflective/transmissive/hybrid) or have different architectures (single/group/fully-connected). However, most existing research focused on single-connected reflective RISs, mathematically characterized by diagonal phase shift matrices, while there is a lack of a comprehensive study for RISs unifying different modes/architectures. In this paper, we solve this issue by analyzing and proposing a general RIS…
Integrating the reconfigurable intelligent surface in a cell-free (RIS-CF) network is an effective solution to improve the capacity and coverage of future wireless systems with low cost and power consumption. The reflecting coefficients of RISs can be programmed to enhance signals received at users. This letter addresses a joint design of transmit beamformers at access points and reflecting coefficients at RISs to maximize the energy efficiency (EE) of RIS-CF networks, taking into account the limited backhaul capacity constraints. Due to a very computationally challenging nonconvex problem, we…
In this letter, we investigate a cell-free network aided by hybrid reconfigurable intelligent surfaces (RISs), which consists of a mixture of passive and active elements that are capable of amplifying and reflecting the incident signal. To maximize the energy efficiency (EE) of the system, we formulate a joint transmit beamforming and RIS coefficients optimization problem. To deal with the fractional objective function, Dinkelbach transform, Lagrangian dual reformulation, and quadratic transform are utilized, with a block coordinate descent (BCD) based algorithm proposed to decouple the variab…
The performance of over-the-air computation (AirComp) systems degrades due to the hostile channel conditions of wireless devices (WDs), which can be significantly improved by the employment of reconfigurable intelligent surfaces (RISs). However, the conventional RISs require that the WDs have to be located in the half-plane of the reflection space, which restricts their potential benefits. To address this issue, the novel family of simultaneously transmitting and reflecting reconfigurable intelligent surfaces (STAR-RIS) is considered in AirComp systems to improve the computation accuracy acros…
The reconfigurable intelligent surface (RIS) is a promising technology to provide smart radio environment. In contrast to the well-studied patch-array-based RISs, this work focuses on the metasurface-based RISs and simultaneously transmitting and reflecting (STAR)-RISs where the elements have millimeter or even molecular sizes. For these meticulous metasurface structures, near-field effects are dominant and a continuous electric current distribution should be adopted for capturing their electromagnetic response instead of discrete phase-shift matrices. Exploiting the electric current distribut…
With the rapid development of advanced electromagnetic manipulation technologies, researchers and engineers are starting to study smart surfaces that can achieve enhanced coverages, high reconfigurability, and are easy to deploy. Among these efforts, simultaneously transmitting and reflecting intelligent omni-surface (STAR-IOS) is one of the most promising categories. Although pioneering works have demonstrated the benefits of STAR-IOSs in terms of its wireless communication performance gain, several important issues remain unclear including practical hardware implementations and physics-compl…
Reconfigurable Intelligent Surfaces (RISs) are envisioned to play a key role in future wireless communications, enabling programmable radio propagation environments. They are usually considered as nearly passive planar structures that operate as adjustable reflectors, giving rise to a multitude of implementation challenges, including an inherent difficulty in estimating the underlying wireless channels. In this paper, we propose the concept of Hybrid RISs (HRISs), which do not solely reflect the impinging waveform in a controllable fashion, but are also capable of sensing and processing a port…
Reconfigurable intelligent surfaces (RISs) or intelligent reflecting surfaces (IRSs), are regarded as one of the most promising and revolutionizing techniques for enhancing the spectrum and/or energy efficiency of wireless systems. These devices are capable of reconfiguring the wireless propagation environment by carefully tuning the phase shifts of a large number of low-cost passive reflecting elements. In this article, we aim for answering four fundmental questions: 1) Why do we need RISs? 2) What is an RIS? 3) What are RIS's applications? 4) What are the relevant challenges and future resea…
In this paper, the novel simultaneously transmitting and reflecting (STAR) reconfigurable intelligent surface (RIS), which enables full-space coverage on users located on both sides of the surface, is investigated in the multi-user mobile edge computing (MEC) system. A computation rate maximization problem is formulated via the joint design of the STAR-RIS phase shifts, reflection and transmission amplitude coefficients, the receive beamforming vectors at the access point, and the users' energy partition strategies for local computing and offloading. Two operating protocols of STAR-RIS, namely…
The opening of the millimeter wave (mmWave) spectrum bands for 5G communications has motivated the need for novel spectrum sharing solutions at these high frequencies. In fact, reconfigurable intelligent surfaces (RISs) have recently emerged to enable spectrum sharing while enhancing the incumbents' quality-of-service (QoS). Nonetheless, co-existence over mmWave bands remains persistently challenging due to their unfavorable propagation characteristics. Hence, initiating mmWave spectrum sharing requires the RIS to further assist in improving the QoS over mmWave bands without jeopardizing spect…
Reconfigurable intelligent surfaces (RISs) have recently emerged as a promising technology that can achieve high spectrum and energy efficiency for future wireless networks by integrating a massive number of low-cost and passive reflecting elements. An RIS can manipulate the properties of an incident wave, such as the frequency, amplitude, and phase, and, then, reflect this manipulated wave to a desired destination, without the need for complex signal processing. In this paper, the asymptotic optimality of achievable rate in a downlink RIS system is analyzed under a practical RIS environment w…
This paper analyzes the performance of multiple reconfigurable intelligent surfaces (RISs)-aided networks. The paper also provides some optimization results on the number of reflecting elements on RISs and the optimal placement of RISs. We first derive accurate closed-form approximations for RIS channels' distributions assuming independent non-identically distributed (i.ni.d.) Nakagami-\emph{m} fading environment. Then, the approximate expressions for outage probability (OP) and average symbol error probability are derived in closed-form. Furthermore, to get more insights into the system perfo…
Simultaneously transmitting and reflecting reconfigurable intelligent surface (STAR-RIS) assisted non-orthogonal multiple access (NOMA) communication systems are investigated in its vicinity, where a STAR-RIS is deployed within a predefined region for establishing communication links for users. Both beamformer-based NOMA and cluster-based NOMA schemes are employed at the multi-antenna base station (BS). For each scheme, the STAR-RIS deployment location, the passive transmitting and reflecting beamforming (BF) of the STAR-RIS, and the active BF at the BS are jointly optimized for maximizing the…
A simultaneous transmitting and reflecting reconfigurable intelligent surface (STAR-RIS) assisted multi-user downlink multiple-input single-output (MISO) communication system is investigated. In contrast to the existing ideal STAR-RIS model assuming an independent transmission and reflection phase-shift control, a practical coupled phase-shift model is considered. Then, a joint active and passive beamforming optimization problem is formulated for minimizing the long-term transmission power consumption, subject to the coupled phase-shift constraint and the minimum data rate constraint. Despite …
A correlated transmission and reflection (T&R) phase-shift model is proposed for passive lossless simultaneously transmitting and reflecting reconfigurable intelligent surfaces (STAR-RISs). A STAR-RIS-aided two-user downlink communication system is investigated for both orthogonal multiple access (OMA) and non-orthogonal multiple access (NOMA). To evaluate the impact of the correlated T&R phase-shift model on the communication performance, three phase-shift configuration strategies are developed, namely the primary-secondary phase-shift configuration (PS-PSC), the diversity preserving phase-sh…
The sum-rate performance of simultaneous transmitting and reflecting reconfigurable intelligent surface (STAR-RIS) assisted full-duplex (FD) communication systems is investigated. The reflection and transmission coefficients of STAR-RIS elements are optimized for the energy splitting and mode switching protocols to maximize the weighted sum rate of the system. The underlying optimization problems are non-convex, and hence, the successive convex approximation technique has been employed to develop efficient algorithms to obtain sub-optimal solutions. Thereby, the maximum average weighted sum ra…
Xi’an Institute of Optics and Precision Mechanics of Chinese Academy of Sciences（中国科学院西安光学精密机械研究所）；Durham University（杜伦大学）；Jinan University（暨南大学）；The University of Manchester（曼彻斯特大学）
Simultaneous transmitting and reflecting reconfigurable intelligent surfaces (STAR-RISs) has been considered as a promising auxiliary device to enhance the performance of the wireless network, where users located at the different sides of the surfaces can be simultaneously served by the transmitting and reflecting signals. In this paper, the energy efficiency (EE) maximization problem for a non-orthogonal multiple access (NOMA) assisted STAR-RIS downlink network is investigated. Due to the fractional form of the EE, it is challenging to solve the EE maximization problem by the traditional conv…
In the intelligent reflecting surface (IRS)-enhanced wireless communication system, channel state information (CSI) is of paramount importance for achieving the passive beamforming gain of IRS, which, however, is a practically challenging task due to its massive number of passive elements without transmitting/receiving capabilities. In this letter, we propose a practical transmission protocol to execute channel estimation and reflection optimization successively for an IRS-enhanced orthogonal frequency division multiplexing (OFDM) system. Under the unit-modulus constraint, a novel reflection p…
Active reconfigurable intelligent surfaces (RISs) have recently been proposed to compensate for the severe multiplicative fading effect of conventional passive RIS-aided systems. Each reflecting element of active RISs is assisted by an amplifier such that the incident signal can be reflected and amplified instead of only being reflected as in passive RIS-aided systems. This work addresses the practical challenge that, on the one hand, in active RIS-aided systems the perfect individual CSI of the RIS-aided channels cannot be acquired due to the lack of signal processing power at the active RISs…
In this paper, we investigate the performance of an RIS-aided wireless communication system subject to outdated channel state information that may operate in both the near- and far-field regions. In particular, we take two RIS deployment strategies into consideration: (i) the centralized deployment, where all the reflecting elements are installed on a single RIS and (ii) the distributed deployment, where the same number of reflecting elements are placed on multiple RISs. For both deployment strategies, we derive accurate closed-form approximations for the ergodic capacity, and we introduce tig…
Intelligent surfaces comprising of cost effective, nearly passive, and reconfigurable unit elements are lately gaining increasing interest due to their potential in enabling fully programmable wireless environments. They are envisioned to offer environmental intelligence for diverse communication objectives, when coated on various objects of the deployment area of interest. To achieve this overarching goal, the channels where the Reconfigurable Intelligent Surfaces (RISs) are involved need to be in principle estimated. However, this is a challenging task with the currently available hardware R…
QoS Improvement in Multi User Cellular-Symbiotic Radio Network Assisted by Active-STAR-RIS
Department of Electrical and Computer Engineering, Isfahan University of Technology（伊斯法罕理工大学电气与计算机工程系）；Department of Electronics and Communication Engineering, Kuwait College of Science and Technology（科威特科学与技术学院电子与通信工程系）；The Pasargad Institute for Advanced Innovative Solutions (PIAIS)（帕萨尔加德先进创新解决方案研究所）；Electrical and Electronic Engineering Department, London South Bank University（伦敦南岸大学电子与电气工程系）
