无创电流估计(NICE)简介
Introduction to Non-Invasive Current Estimation (NICE)
摘要:
众所周知,很难在不影响瞬时电源电压和损害器件运行的情况下测量ASIC、FPGA或CPU等器件的瞬时电源电流[21]。几十年来,设计人员一直依赖于对动态负载电流的粗略估计来激励所设计的电力输送网络(PDN)。负载电流特性不准确的后果可能包括PDN成本过高、开发时间延长、性能差或功能故障。本文将介绍和描述一种从一对测量的时域电压波形精确确定时域电流波形的方法。这种无创电流估计(NICE)方法基于已建立的双端口网络理论以及已通过对示范电路的测量进行验证的元件和电路板建模技术。本文将说明NICE方法适用于任何可以在数字示波器上捕获的瞬态事件。在适当情况下,说明了方法和基本计量的局限性。该方法适用于一个简单的PDN与任意负载,和NICE派生的电流波形进行了验证,对一个独立的测量感测电阻。通过仔细的元件和电路板建模,可以计算出电流波形,与参考测量值相比,均方根误差小于5%。使用NICE,以前很难或不可能通过任何方式表征的电流瞬变现在可以在示波器触发事件的几秒钟内计算和显示。ASIC和FPGA制造商现在可以计算其器件的启动电流并发布实际波形,或提供分段线性SPICE模型(PWL源),以促进支持其器件所需的稳压器和PDN的设计和测试。
英文摘要:
It is notoriously difficult to measure instantaneous supply current to a device such as an ASIC, FPGA, or CPU without also affecting the instantaneous supply voltage and compromising the operation of the device [21]. For decades designers have relied on rough estimates of dynamic load currents that stimulate a designed Power Delivery Network (PDN). The consequences of inaccurate load-current characterization can range from excessive PDN cost and lengthened development schedules to poor performance or functional failure. This paper will introduce and describe a method to precisely determine timedomain current waveforms from a pair of measured timedomain voltage waveforms. This NonInvasive Current Estimation (NICE) method is based on established twoport network theory along with component and board modeling techniques that have been validated through measurements on demonstrative circuits. This paper will show that the NICE method works for any transient event that can be captured on a digital oscilloscope. Limitations of the method and underlying measurements are noted where appropriate. The method is applied to a simple PDN with an arbitrary load, and the NICE-derived current waveform is verified against an independent measurement by sense resistor. With careful component and board modeling, it is possible to calculate current waveforms with a root mean square error of less than five percent compared to the reference measurement. Current transients that were previously difficult or impossible to characterize by any means can now be calculated and displayed within seconds of an oscilloscope-trigger event by using NICE. ASIC and FPGA manufacturers can now compute the startup current for their device and publish the actual waveform, or provide a piecewiselinear SPICE model (PWL source) to facilitate design and testing of the regulator and PDN required to support their device.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。