Following up a recent study describing a flexible plasma source operated in planar geometry, the performance of a cold atmospheric plasma jet (CAPJ) matrix emanating radially from a soft cylindrical surface in the open air is presented. The plasma device, which has a set of small outlets produced in its side surface, has a length of 12 cm and an outer diameter of 5.4 cm. The dielectric barrier discharge (DBD) sustaining the plasma jets is generated in helium flowing between two coaxial electrodes, which are separated by both an insulating tape and a cylindrical wall made of polymer foam. Two operation modes are considered: four equidistant CAPJs at the same axial position (brush mode) and three aligned CAPJs at constant azimuthal angle (comb mode). All discharges, excited by 15 kHz-AC voltages at 3.8 kV in amplitude, have resulted in uniform lengths and intensities of the jets. Consumed discharge powers of between 0.1 and 1 W have been estimated from current-voltage measurements. Optical emission spectroscopy (OES) has shown the preponderance of hydroxyl groups, nitrogen molecules and helium atoms in the active DBD region and the jet afterglow zone. This new design of CAPJ anticipates promising applications for treating the inner surface of hollow and delicate components for activation or healing purposes.
Investigating the effects of electron bounce-cyclotron resonance on plasma dynamics in capacitive discharges operated in the presence of a weak transverse magnetic field
Electron dynamics in planar radio frequency magnetron plasmas: III. Comparison of experimental investigations of power absorption dynamics to simulation results
The effect of surface quenching coefficients of $O_2(a^{1}Δg)$ and $O_2(b^{1}Σg^{+})$ on capacitively coupled $Ar$/$O_2$ discharge: A global/equivalent circuit model study
Key Laboratory of Materials Modification by Laser, Ion and Electron Beams (Ministry of Education), School of Physics, Dalian University of Technology(大连理工大学激光、离子和电子束材料改性教育部重点实验室物理学院)
The effect of the driving frequency on the confinement of beam electrons and plasma density in low pressure capacitive discharges
采用Particle in Cell/Monte Carlo碰撞模拟和解析模型,研究了在几Pa的低压下工作的电容式射频氩等离子体中,改变驱动频率对等离子体密度和电子动力学的影响。与先前的假设相反,在这种非局部无碰撞的情况下,等离子体密度不遵循对驱动频率的二次依赖。相反,观察到在不同的驱动频率下的阶梯状增加。基于分析的功率平衡模型,结合电子动力学的详细分析,密度跳跃被发现是由电子加热模式从经典的$α$模式转变成低密度谐振加热模式,其特征在于在每个电极每个鞘层膨胀阶段产生两个高能电子束。这些电子束在没有碰撞的情况下通过主体传播,并与相对的鞘层相互作用。在低密度模式中,发现第二束在其塌陷期间撞击相对鞘。因此,大量的高能电子在电极处损失,导致与在较高驱动频率下观察到的经典$α$模式相比,束电子的约束较差。基于分析模型,这种调制的约束质量和相关的调制的能量损失的每电子在电极上被证明是导致等离子体密度的阶梯状变化。根据模拟结果分析了电极间隙、中性气体压力、电极的电子粘附系数和次级电子发射系数的变化对等离子体密度阶梯状增加的影响。