Linear modal instabilities of flow over finite-span untapered wings have been investigated numerically at Reynolds number 400, at a range of angles of attack and sweep on two wings having aspect ratios 4 and 8. Base flows have been generated by direct numerical simulation, marching the unsteady incompressible three-dimensional Navier-Stokes equations to a steady state, or using selective frequency damping to obtain stationary linearly unstable flows. Unstable three-dimensional linear global modes of swept wings have been identified for the first time using spectral-element time-stepping solvers. The effect of the wing geometry and flow parameters on these modes has been examined in detail. An increase of the angle of attack was found to destabilize the flow, while an increase of the sweep angle had the opposite effect. On unswept wings, TriGlobal analysis revealed that the most unstable global mode peaks in the midspan region of the wake; the peak of the mode structure moves towards the tip as sweep is increased. Data-driven analysis was then employed to study the effects of wing geometry and flow conditions on the nonlinear wake. On unswept wings, the dominant mode at low angles of attack is a Kelvin-Helmholtz-like instability, qualitatively analogous with global modes of infinite-span wings under same conditions. At higher angles of attack and moderate sweep angles, the dominant mode is a structure denominated the interaction mode. At high sweep angles, this mode evolves into elongated streamwise vortices on higher aspect ratio wings, while on shorter wings it becomes indistinguishable from tip-vortex instability.
Forward-swept wings offer unique advantages in the aerodynamic performance of air vehicles. However, the low-Reynolds-number characteristics of such wings have not been explored in the past. In this work, we numerically study laminar separated flows over forward-swept wings with semi aspect ratios $sAR=0.5$ to 2 at a chord-based Reynolds number of 400. Forward-swept wings generate wakes that are significantly different from those of backward-swept wings. For low-aspect-ratio forward wings, the wakes remain steady due to the strong downwash effects induced by the tip vortices. For larger aspect…
Through triglobal resolvent analysis, we reveal the effects of wing tip and sweep angle on laminar separated wakes over swept wings. For the present study, we consider wings with semi-aspect ratios from $1$ to $4$, sweep angles from $0^\circ$ to $45^\circ$, and angles of attack of $20^\circ$ and $30^\circ$ at a chord-based Reynolds number of $400$ and a Mach number of $0.1$. Using direct numerical simulations, we observe that unswept wings develop vortex shedding near the wing root with a quasi-steady tip vortex. For swept wings, vortex shedding is seen near the wing tip for low sweep angles, …
We perform direct numerical simulations of laminar separated flows over finite-aspect-ratio swept wings at a chord-base Reynolds number of $Re = 400$ to reveal a variety of wake structures generated for a range of aspect ratios ($sAR=0.5-4$), angles of attack ($α=16^{\circ}-30^{\circ}$), and sweep angles ($Λ=0^{\circ}-45^{\circ}$). Flows behind swept wings exhibit increased complexity in their dynamical features compared to unswept-wing wakes. For unswept wings, the wake dynamics are predominantly influenced by the tip effects. Steady wakes are mainly limited to low-aspect-ratio wings. Unstead…
A low-order method is presented for aerodynamic prediction of wings operating at near-stall and post-stall flight conditions. The method is intended for use in design, modeling, and simulation. In this method, the flow separation due to stall is modeled in a vortex-lattice framework as an effective reduction in the camber, or "decambering." For each section of the wing, a parabolic decambering flap, hinged at the separation location of the section, is calculated through iteration to ensure that the lift and moment coefficients of the section match with the values from the two-dimensional visco…
We perform unsteady three-dimensional direct numerical simulations to study the aerodynamic characteristics of finite-aspect-ratio swept wings with a NACA 0015 cross-section at a chord-based Reynolds number of 400. The effects of the sweep angle ($Λ=0^{\circ}-45^{\circ}$) on the aerodynamic force coefficients are examined for finite-aspect-ratio wings ($sAR=0.5$, 1, and 2) over a wide range of angles of attack ($α=0^{\circ}-30^{\circ}$). The unsteady laminar separated flows exhibit complex aerodynamic characteristics with respect to these parameters. The introduction of sweep enhances lift for…
Icing on three-dimensional wings causes severe flow separation near stall. Standard improved delayed detached eddy simulation (IDDES) is unable to correctly predict the separating reattaching flow due to its inability to accurately resolve the Kelvin-Helmholtz instability. In this study, a shear layer adapted subgrid length scale is applied to enhance the IDDES prediction of the flow around a finite NACA (National Advisory Committee for Aeronautics) 0012 wing with leading edge horn ice. It is found that applying the new length scale contributes to a more accurate prediction of the separated sh…
This work describes a novel mechanism of laminar flow control of a backward swept wing with a comb-like leading edge device. It is inspired by the leading-edge comb on owl feathers and the special design of its barbs, resembling a cascade of complex 3D-curved thin finlets. The details of the geometry of the barbs from an owl feather were used to design a generic model of the comb for experimental and numerical flow studies with the comb attached to the leading edge of a flat plate. Examination was carried out at different sweep angles, because life animal clearly show the backward sweep of the…
Researchers have hypothesized that the post-stall lift benefit of bird's alular feathers, or alula, stems from the maintenance of an attached leading-edge vortex (LEV) over their thin-profiled, outer hand-wing. Here, we investigate the connection between the alula and LEV attachment via flow measurements in a wind tunnel. We show that a model alula, whose wetted area is 1% that of the wing, stabilizes a recirculatory aft-tilted LEV on a steadily-translating unswept wing inclined at post-stall incidences. The attached vortex is the result of the alula's ability to smoothly merge otherwise separ…
Dynamic stall on airfoils negatively impacts their aerodynamic performance and can lead to structural damage. Accurate prediction and modelling of the dynamic stall loads are crucial for a more robust design of wings and blades that operate under unsteady conditions susceptible to dynamic stall and for widening the range of operation of these lifting surfaces. Many dynamic stall models rely on empirical parameters that need to be obtained from experimental or numerical data which limits their generalisability. Here, we introduce physically derived times scales to replace the empirical paramete…
The number of studies related to unmanned air vehicles (UAV), micro air vehicles (MAV), wind turbines, birds and insects which operate at low Reynolds (Re) numbers have rapidly increased, recently. In this thesis, unsteady aerodynamics of low Reynolds number flows (Re=25000, 50000 and 75000) on NACA4412 airfoil shaped wing which is mainly used in wind turbines and micro air vehicles and operates at low Reynolds numbers and has aspect ratio of 1 (AR=1) was investigated by means of numerous experimental analyses at various angles of attack changing from 0° to 45°. Due to the obtained force measu…
The thin runback water films driven by the gas flow, the pressure gradient and the gravity on the iced aircraft surface are investigated in this paper. A three-dimensional film flow model based on Finite Volume Method (FVM) and the lubrication theory is proposed to describe the flow. The depth-averaged velocity of the film is stored in Cartesian coordinates to avoid the appearance of the metric tensors. The governing equations are discretized in the first layer structured grid cell which is selected as the grids for film flow. In order to verify this method, comparisons between numerical resul…
We numerically examine the mechanisms that describe the shock-boundary layer interactions in transonic flow past an oscillating wing section. At moderate and high angles of incidence but low amplitudes of oscillation, shock induced flow separation or shock-stall is observed accompanied by shock reversal. Even though the power input to the airfoil by the viscous forces is three orders of magnitude lower than that due to the pressure forces on the airfoil, the boundary layer manipulates the shock location and shock motion and redistributes the power input to the airfoil by the pressure forces. T…
Passive aerodynamic robustness reduces disturbance amplification in flight
J. C. Wu Center for Aerodynamics, School of Aeronautics and Astronautics, Shanghai Jiao Tong University（上海交通大学航空航天学院空气动力学中心）；Commercial Aircraft Corporation of China, Ltd.（中国商用飞机有限责任公司）
SuperWing: a comprehensive transonic wing dataset for data-driven aerodynamic design
School of Aerospace Engineering, Tsinghua University, Beijing, China（清华大学北京航空航天工程学院）；School of Computation, Information and Technology, Technical University of Munich, Germany（慕尼黑技术大学计算、信息与技术学院）
High-lift Wing Separation Control via Bayesian Optimization and Deep Reinforcement Learning
TUAREG, Universitat Politècnica de Catalunya (UPC)（TUAREG，西班牙巴塞罗那理工大学）；Mechanical Engineering, Delft University of Technology (TU Delft)（代尔夫特理工大学机械工程系）；CASE, Barcelona Supercomputing Center (BSC)（巴塞罗那超级计算中心）
School of Aeronautics, Northwestern Polytechnical University（西北工业大学航空学院）
In the field of fixed wing aircraft, many morphing technologies have been applied to the wing, such as adaptive airfoil, variable span aircraft, variable swept angle aircraft, etc., but few are aimed at the tail. The traditional fixed wing tail includes horizontal and vertical tail. Inspired by the bird tail, this paper will introduce a new bionic tail. The tail has a novel control mode, which has multiple control variables. Compared with the traditional fixed wing tail, it adds the area control and rotation control around the longitudinal symmetry axis, so it can control the pitch and yaw of …
Information-theoretic machine learning for time-varying mode decomposition of separated aerodynamic flows
Department of Aerospace Engineering, Tohoku University（东京东京大学航空工程系）；Department of Mechanical and Aerospace Engineering, Tokyo University of Science（东京科学大学机械与航空航天工程系）
This paper deals with the investigation of flow field due to clap and fling mechanism using immersed boundary coupled with lattice Boltzmann method. The lattice Boltzmann method (LBM), an alternative to Navier Stokes solver, is used because of its simplicity and computational efficiency in solving complex moving boundary problems. Benchmark problems are simulated to validate the code, which is then used for simulating flow over two elliptic wing of aspect ratio 5 performing clap and fling flapping motion for different flow parameters such as Reynolds number (Re = 75,100,150), advance ratio (J …
The wind tunnel rotary-balance testing is widely used in aircraft dynamics to characterise aerodynamics at moderate and high angles of attack during stall and spin regimes. In such experiments an aircraft test model is rotated along the wind-tunnel free-stream velocity vector allowing the measurement of aerodynamic characteristics in steady rotational flow conditions with constant angle of attack and sideslip. In modified tests named as oscillatory coning, the rotation vector is tilted from the free-stream velocity vector making flow conditions with periodic variations in angle of attack and s…
